熔融液 的英文怎麼說

中文拼音 [róngróngyè]
熔融液 英文
meltwater
  • 熔 : 動詞（熔化） melt; fuse; smelt
  • 融 : Ⅰ動詞1 （融化） melt; thaw 2 （融合; 調和） blend; fuse; be in harmony Ⅱ形容詞[書面語]1 （長遠; ...
  • 液 : 名詞（液體） liquid; fluid; juice
  1. Experimental study of the coal - ash fusion characteristics of waste - liquid coal water slurry and refined coal cws

    廢液水煤漿和精煤水煤漿煤灰熔融特性試驗研究
  2. Polybenzoxazine / vermiculite hybrid nanocomposites were prepared from two kinds of polybenzoxazine precursors and two kinds of organically modified - vermiculite minerals and expanded - vermiculite which were consisted of vermiculite, hydrobiotite and phlogopite. after treatment of vermiculite minerals by hexadecyl trimethylam monium bromide ( ctab ), the d001 of vermiculite layers of vermiculite mineral increased from 1. 43nm to 2. 67nm and developed a d002 = 1. 34nm

    本文分析了蛭石精礦和膨脹蛭石的組成和結構，用十六烷基三甲基溴化銨（ ctab ）進行了有機化處理，再通過熔融或溶液混合插層苯並嗯嗪樹脂（ ben ）制備了ben插層蛭石納米復合材料，並採用蒙脫土進行了對照實驗。
  3. Rapid growth of “ mother dendrites ” in a given location of a melt at just below the liquidus temperature, that growth being the result of rapid heat extraction from the melt, or from recalescence

    在特定的熔點，以低於液相線的溫度快速生成「母晶枝」 ，這是使熔融金屬或復輝快速散熱的結果。
  4. The problems can be addressed, in part, through a strongly reactive alloying addition, such as mg, li and so on, and through reinforcement coating. in this paper sicp / al composites and sicp / al - si composites fabricated by the pressureless infiltration method. in order to found out the influence the different quantity of the reactive alloying addition mg si ce on the wetting between sicp and molten metal as well as the properties of mmcs, the behaviors of molten metal, the mechanical properties, micro - structure and the interfacial reactions was investigated respectively

    本文通過研究制備sicp al復合材料、 sicp al - si復合材料的過程中，熔融鋁液或鋁硅合金液的浸滲行為、 sic - al 、 sic - al - si之間的界面反應、復合材料的機械性能、微觀結構等，探討了不同量的活性元素mg 、 si 、 ce對sic顆粒與熔融基體之間的潤濕性及復合材料性能的影響。
  5. In this paper, urea particles and oil - vegetable seeds as initial particles are used to study granulation process in a vibrated fluidized bed, where the initial particles grow in a layered manner by spraying melt urea solution on them and reached the required granule size

    本文以尿素或油菜籽顆粒為晶種，以不同濃度的尿素溶液為噴霧料漿，對振動流化床噴霧造粒特性進行了實驗研究。實驗在晶種上噴塗尿素熔融液或不同濃度的尿素溶液，使其以層式機理長大。
  6. During the spray granulation, either solutions, suspensions or melted liquid are sprayed onto dried moist particles that are located in the flow zone of the fluidized bed, then the granulation process involving vaporization crystallization, dessication and chemical reactions completes in the same equipment

    流化床噴霧造粒是將溶液、懸浮液或熔融液噴霧到已經乾燥或不完全乾燥顆粒的流化床床層內，在同一設備內一步完成蒸發、結晶、乾燥或化學反應的造粒過程。
  7. Melting, now, and the ordinary liquid statethese are not understood in any quantitative manner.

    目前，人們不能以任何定量的方式來理解熔融態與普通的液態。
  8. The goal of people responsible for raw materials, batching, and furnace operations should be to provide the bottle makers with a continuous flow of uniform defect - free glass

    負責原材料、配料和窯爐操作的人應該給制瓶工人提供始終如一、無缺陷的連續不斷的玻璃熔融液。
  9. The meltable liquid touches with the rotary drum of cooling that form material film in rotary drum appearance. the heat exchange between material film and drum wall makes material film cooling and crystallization. the crystal material film is cut by scraper which forms piece product

    轉鼓結片是一個冷卻結晶過程，料盤中熔融料液與冷卻的轉鼓接觸，在轉鼓表面形成料膜，通過料膜與鼓壁間的換熱，使料膜冷卻結晶，結晶的料膜被刮刀刮下，成為片狀產品。
  10. This dessertation systematically researched dislocation and ab microdefects etched by molten koh and by ab etching respectively in gaas substrate, which were provided by merchants from home and overseas, as well as their influence on electrical parameters

    本文系統地研究了國內外各生產廠家提供的gaas襯底中用熔融koh腐蝕的位錯、 ab腐蝕液腐蝕出的ab微缺陷的密度和分佈情況以及它們對襯底電參數（電阻率、遷移率、載流子濃度）的影響。
  11. The research on the effect of liquid - liquid transition of polyacrylate on crystallization - melting of pdms indicates that above the melting temperature of pdms, pdms is reinforced by a special mutual action between p - electron in carbonyl of polyacrylate and 3d orbit in si atom of pdms, while below the temperature, the pdms crystal is lessened, which can not completely remove the crystal of pdms. however, it is the crystallization behavior of pdms that results in its most segments relaxation being restrained

    研究聚丙烯酸酯液一液轉變對聚二甲基硅氧烷結晶一熔融影響的結果表明：碳基碳原子上p電子與出原於中3d軌道相互作用，在聚h甲基硅氧烷熔融轉變溫度以上，對其有分子增強作用；在聚二甲基硅氧烷熔融轉變溫度以下，霎對其有降低結晶度的作用，但不能消除結晶現象。
  12. These fiery conditions had to subside before molten rock could harden into a crust, before continents could form, before the dense, steamy atmosphere could pool as liquid water, and before the earth ' s first primitive life could evolve and survive

    要使熔融的巖漿能夠凝固成地殼、陸地能夠形成、濃密大氣中的蒸氣能夠凝結成液態水、最原始的生命能夠演化與存活，在這之前，都得先讓地球那熾熱如火球般的狀態平息下來才行。
  13. In addition, we also explored that : montmorillonite which has been treated by bs - 12 was treated secondly using mma by the method of emulsion reaction and prepared pvc / montmorillonite composite on the way of melt interaction again. by measuring xrd and mechanical properties and observing the section morphology of flexural sample through sem, we found that : after secondly treated, the intension and toughness of pvc / montmorillonite composite were greatly increased. the results indicated that using using montmorillonite can toughen and reinforce pvc effectively, so the study and application of it have a bright prospect

    此外，還探討了對經bs - 12初次處理過的蒙脫土，用甲基丙烯酸甲酯採用乳液聚合的方法進行二次處理，再次通過熔融法製成pvc蒙脫土插層復合材料，並通過x ?射線衍射測定和力學性能測試以及掃描電鏡觀察材料的斷面形貌，結果發現，蒙脫土經甲基丙烯酸甲酯通過乳液聚合法二次處理后製成的復合材料與只用bs - 12初次處理的蒙脫土製成的復合材料相比，其強度和韌性得到了明顯改善。
分享友人
分享到 Line

分享到臉書