熔透 的英文怎麼說

中文拼音 [róngtòu]
熔透 英文
fusion penetration
  • 熔 : 動詞（熔化） melt; fuse; smelt
  • 透 : Ⅰ動詞1 （滲透; 穿透） penetrate; pass [seep] through 2 （暗地裡告訴） tell secretly; let out; lea...
  1. This indicated that the fracture had initiated at the unfused butt weld in the longitudinal stiffener.

    研究表明裂紋是從縱向加勁助未熔透的對接焊縫中起始的。
  2. Some crack extension probably developed from the unfused section of the butt weld across the thickness of the stiffener during transport and erection.

    有些裂紋可能在運輸和安裝過程中就從加勁肋對接焊未熔透處開始發展。
  3. Infiltration and solidification remelting of molten aluminum in a centrifugal force field

    高溫鋁熔液在旋轉多孔介質內的滲透與瞬態固化和再熔過程
  4. Medium frequency induction heating equipment are used in metal melting, temperature keeping, diathermic technology, metal - heat processing brass soldering, quenching, tempering and sintering

    中頻感應加熱設備適用於各種金屬熔煉，保溫，透熱，金屬熱處理，釬焊，淬火回火，燒結，釬絲鋼絲等。
  5. With this solution, various requirements of different training materials, different types of binding, such as online binding, page breaking interleaves, color interleaves, transparent films, cardboard covers or tape binding, can be accomplished without interruption

    有了這套解決方案，根據不同培訓材料的要求，可以一起呵成地進行多種裝訂，例如聯機打釘分頁紙插頁彩色插頁透明膠片或者硬卡紙封面熱熔裝訂等。
  6. The imported transparent glaze fired at lower temperature was analysed semi - quantitatively by adopting emission spectroscope. the stripping of lead and cadmium from this transparent glaze fired at lower temperature in ceramic product was determined by atomic absorption spectroscope. the effect of chemical composition on the stripping of lead and cadmium was analysed. upon the author s opinion, the overproof lead stripping from the imported transparent glaze fired at lower temperature can only be settled by adopting lead - free glaze instead of adopting low - lead prescription. the author succeeded in developing an excellent lead - free transparent glaze fired at the lower temperature of 1000 1050. the success is based on an inquiry into the feasibility of using such new agents of fusion as li2o and sro in replacement of pbo ; and on a study of the effects of the contents of sio2 ， al2o3 ， b2o3and other metallic oxides on such performances of glaze as coefficient of linear expansion, fusion temperature and transparency. it is also based on an analysis of coefficient of linear expansion of blank and glaze on an analysis of coefficient of linear expansion of blank and glaze on their correlation ; and on a study of technology for preparing glaze

    採用發射光譜儀對進口低溫透明釉進行半定量分析，並用原子吸收光譜儀測定其陶瓷製品的鉛、鎘的溶出量，分析化學成分對鉛、鎘溶出量的影響.結果表明，進口低溫透明釉採用低鉛配方不能解決鉛溶出量的超標問題，只有採用無鉛釉才能解決.探討用氧化鋰和氧化鍶等新型熔劑完全代替氧化鉛的工藝，研究釉料中氧化硅、氧化鋁、氧化硼和各種金屬氧化物的含量，對釉的線膨脹系數、熔融溫度和透明度等性能的影響.分析坯料、釉料的線膨脹系數及其相互關系和釉料制備的工藝，研製出優質的1000 1050低溫無鉛透明釉
  7. Founding - liquid penetrant inspection - investment castings

    鑄造.液體滲透檢查.熔模鑄造
  8. Fabrication technology of microlens array by melting photoresist

    微透鏡陣列的光刻膠熱熔製作技術
  9. A drop of molten silver from the reliquary produced a symmetrically placed mark through the layers of the folded cloth

    一滴熔化的鍍銀從聖物箱滴了下來，透過各層折疊的布而產生出一個對稱性的標記。
  10. Hence lack of fusion and slag would exist at the weld root and create a large initial crack condition.

    因而未熔透及夾渣存在於焊縫棍部，並造成大的初始裂紋條件。
  11. Meanwhile, through adopting imported environmental materials, all of our product pu, pure pu, tri - layer ventilative cloth, heat transformation materials, etc. are totally accord with eu environmental criteria

    盟環保標準的高品質系列防水熱風膠條pu純pu三層透氣膠帶熱熔膠膜熱轉移材料等。
  12. Slag, blowholes, and paint on unfused regions were observed at the welded junctions.

    在焊接處看到了夾渣，氣孔及未熔透區的油漆。
  13. Ultrafine powder, the high quality ultrafine power has been got. ( 2 ) the perfect rutile has been got with flame fusion method in developed domestic sjz sintering machine, and the technology of crystal growth has been clearly analyzed. in the end the suitable techniche has been got on the basis of systemic study on the conditions of growth

    通過對晶體生長中的籽晶方向、氣氛等的作用的大量深入的研究，得出了金紅石晶體焰熔法生長現階段的最佳工藝條件，即籽晶（ 001 ）在氫氧比為1 ： 1的附近，通過加氫進行擴肩，然後在1450加氧退火24hr后就能夠獲得完整透明的金紅石單晶。
  14. Often lack of fusion adjacent to the girder web in the transverse groove welds led to the cracking.

    在靠近主梁腹板的橫向坡口焊縫處常常出現未熔透而導致裂紋。
  15. Where heavy wall vessels with small nozzle diameters are involved, an alternative method of full penetration may be permitted if prior written approval is obtained from secco

    對于帶有小直徑接管的厚壁容器，在事先取得賽科公司書面認可后，可採用其它全熔透方法。
  16. Each pass shall be cleaned free of slag before the next pass is deposited. each weld layer shall be visually free of slag inclusions, cracks, porosity and lack of fusion

    每一層焊道都應在熔敷下一層焊道前清除熔渣。每一焊層都不得有可見的夾渣、裂紋、氣孔及未熔透現象。
  17. Depth of penetration

    熔透深度
  18. Depth of fusion

    熔透深度
  19. All full - penetration joints shall be back purged with argon or helium

    所有全熔透焊接接頭用氬或氦進行反吹。
  20. 2 all welds for nozzles and manways shall be full penetration through the vessel wall

    接管和人孔的焊縫應為穿過容器壁的全熔透。
分享友人
分享到 Line

分享到臉書