熱中子 的英文怎麼說

中文拼音 [rèzhōngzi]
熱中子 英文
[物理學] thermal neutron
  • 子 : 子Ⅰ名詞1 （兒子） son 2 （人的通稱） person 3 （古代特指有學問的男人） ancient title of respect f...
  1. On the basis of expound the theory of building exterior - protected construction energy consumption and the gene of influence the building energy, set up mathematics model, this article discuss the mechanism of dispelling the heat of the buildings " thermal bridge and the complication that influence it, and then synthetic analysis and calculate the influence range of building thermal bridge in exterior - protected construction column thermal bridge to the building outer wall get the conclusion that when the construction column can satisfy the building stress - area, in bulgy construction column dispel less heating than out bulgy construction column. but if the pole stuck out more than 100mm, in bulgy or out bulgy make no difference

    本文在闡述建築圍護結構耗熱原理以及影響建築能耗因子的基礎上，採用數值模擬方法，探討了建築熱橋傳熱的基本機理和影響建築熱橋傳熱的因素，進而對建築熱橋在圍護結構傳熱中的影響范圍進行了綜合分析和計算，研究了構造柱熱橋型式對建築外墻能耗的影響，得出了構造柱在滿足建築受力面積要求的情況下，內凸構造柱較外凸構造柱略能減少散熱量的結論，但是凸出過大（ 100mm ）無論內凸還是外凸對建築耗熱都沒有大的差別。
  2. In recent years, study of boron neutron capture therapy has been aimed at the establishment of epithermal neutron beams in order to avoid the open - skull surgury and for the treatment of deep - seated tumors

    摘要近年來，硼中子捕捉治療之研究傾向于採用超熱中子束以避免切開頭蓋骨之手術及進行較深層之腫瘤治療。
  3. In this article, the current status of epithermal neutron beams in the world is reviewed and also the design and construction plan of the epithermal neutron beam at the tsing hua open - pool reactor is reported

    本文將介紹世界各國在設計建造超熱中子照射管之現況，以及目前在國內清華水池式反應器建造超熱中子照射管之進展及計劃。
  4. Our results show that with the up to date experimental data, 13c can not sufficiently burn, the neutron number density decrease, the timescale of neutron source become long and these come into conflict with model of thermal pulse agb star

    研究結果表明，在新實驗結果下， 』 3c不能充分燃燒，中子數密度降低，中子源持續的時標變長，這與熱脈沖agb星的現有模型出現矛盾。
  5. This project which is based on the demand of increasing the electron tube ’ s qualities totally and reducing the manufacture cost has done a large amount of investigative work as follows to improve and perfect the technologies for the important part of electron tube manufacture ? the grid surface processing : on the surface processing of the molybdenum grid, the primary purpose is to reduce thermionic emission and secondary electronic emission of the grid. by the constantly experiment and grabbling the different technology routes, we have successfully developed these new technologies on the tac and zrc electrophoresis and electroplating platinum black of the grid, and made its surface cladding quality very stable and reliable

    本課題是基於整體提高電子管的質量和降低生產成本的要求，對電子管生產中的重要部分? ?柵極的表面處理技術進行改進和完善，主要在以下方面進行了深入研究:在鉬柵極表面處理方面，主要為實現降低柵極的熱電子發射和二次電子發射，通過不同工藝路線的不斷試驗和摸索，成功開發出柵極電泳tac 、 zrc和電鍍鉑黑的新工藝，使柵極的塗覆質量穩定可靠。
  6. Using carbon - dating techniques, archaeologists can determine the age of many ancient objects by measurement the amount of radioactive carbon they contain

    參考譯文：在太陽深處的內核中，氦和氫經過一系列高熱原子核反應熔合作用產生了太陽的能量。
  7. The degradation of the electrical characteristics in sic pn junctions irradiated by neutron is attributed to the recombination centers and the electric field effect on the thermal emission of traps within the depletion region. the relationship of the ideality factor to the applied voltage is theoretically studied

    提出了中子輻照下sicpn結電特性退化的新的理論， pn結耗盡區中的輻照陷階在耗盡區電場的作用下熱發射效應得到加強，從而導致pn結正偏和反偏時的復合電流和產生電流的改變。
  8. From the scaling law about hot electron temperature given by vh model, the hot electron measured by experiment was reasonable, the temperature was higher than the temperature given by resonant absorption scaling law

    真空吸收是產生高能超熱電子的主導過程，從真空吸收給出的超熱電子溫度定標率來看，實驗中測量得到的超熱電子溫度是合理的。
  9. Verification scheme of measuring instruments for thermal neutron fluence rate

    熱中子注量率計量器具檢定系統
  10. Standard method for determining thermal neutron reaction and fluence rates by radioactivation techniques

    用放射性技術測定熱中子反應和注量率的標準試驗方法
  11. Computing worth of thin slab control rod in thermal research reactor

    熱中子研究堆薄板型控制棒價值計算
  12. Standard practices for thermal neutron radiography of materials

    材料的熱中子射線照相術的標準實施規程
  13. Standard test method for determining image quality in direct thermal neutron radiographic examination

    測定直接熱中子射線照相檢查中成像質量的標準試驗方法
  14. A new method of data processing used in pulse fast thermal neutron analysis technology is introduced

    摘要介紹了一種應用於脈沖快熱中子分析技術中的新解譜方法。
  15. A failure which results in the loss of capability of a component to perform its intended safety function, and any consequential failures which result from it

    一種物質或媒介，用以減慢核裂變所釋放的快中子，將之變為熱中子，以產生更多熱核裂變。
  16. A failure which results in the loss of capability of a component to perform its intended safety function ( s ), and any consequential failures which result from it

    一種物質或媒介，用以減慢核裂變所釋放的快中子，將之變為熱中子，以產生更多熱核裂變。
  17. Zirconium alloys are employed extensively in light water cooled reactors ( lwr ) as the cladding materials of fuel elements and other structural materials because of the low capture cross - section for thermal neutrons, good resistance to water - side corrosion at elevated temperature, adequate mechanical properties and high thermal conductivity

    由於鋯的熱中子吸收截面小，並具有優異的耐高溫水腐蝕性能、良好的綜合力學性能和理想的熱導率，因此，鋯合金被用作核電站水冷動力堆核燃料元件的包殼材料和堆芯的其它結構材料。
  18. The let factors rlet ( rlet = 0. 05 ) of neutron response for liftld in various n + y mixed fields in the fast neutron reactor have been determined experimentally due to the existing let effects of the response for liftld to neutron absorbed dose. the experimental results show that the let factor for neutrons from thermal energy to 5mev energy is about 0. 050. so it is workable to measure the photon fluence in the pulse reactor with 7liftld

    為確定liftld能否用於n 、混合場的區分測量，本文定義了let效應因子，並對liftld的let效應因子進行了實驗測定，測量結果表明： liftld對熱中子至5mev中子響應的let效應因子值約為0 . 050 ，因此，選用~ 7liftld用於脈沖堆光子注量測量是可行的。
  19. A uniform state ion chamber with double layers has been developed for distinct measurement in various n + y mixed fields in the fast neutron reactor. the cavity material is 6lif + 7lif. the inner wall material is 6lif and the outer wall material is 7lif

    根據let效應因子的測量結果和快中子堆y譜、中子譜等基本資料，以及~ 6lif和~ 7lif對中子響應靈敏度有較大差異這一特點，研製了以~ 6lif + ~ 7lif為空腔、 ~ 6lif為外壁、 ~ 7lif為內壁的具有雙層室壁結構的均勻固體電離室，並將其用於快中子脈沖堆n 、混合場區分測量，徹底剔除了熱中子的干擾。
  20. The main contents of the thesis are as following : ( 1 ) thermal neutrons irradiating the silicon wafer gives rise to fractional transmutation of silicon into phosphorus and dopes the silicon n - type. the method of p - type doping zno by proton transmutation doping was presented by reference to that of the silicon

    本論文的主要內容和結果如下: （ 1 ）借用「熱中子輻照矽片使部分硅嬗變為磷，從而將硅摻雜成n型」的思想，從質子嬗變角度討論了實現zno材料的p型摻雜方案。
分享友人
分享到 Line

分享到臉書