熱傳導傳熱性 的英文怎麼說

中文拼音 [rèzhuàndǎozhuànrèxìng]
熱傳導傳熱性 英文
heat conduction
  • 傳 : 傳名詞1 （解釋經文的著作） commentaries on classics 2 （傳記） biography 3 （敘述歷史故事的作品）...
  • 導 : 動詞1. （引導） lead; guide 2. （傳導） transmit; conduct 3. （開導） instruct; teach; give guidance to
  • 性 : Ⅰ名詞1 （性格） nature; character; disposition 2 （性能; 性質） property; quality 3 （性別） sex ...
  1. Based on the above, a surrogate models are built for thermal conductibility performance of sandwich panel with " v - type " folded core in this paper, and they can be optimized by multi - subject. the numerical simulation function and optimization design method in condition of lightest weight are shown in this paper

    其次，用isight軟體重新設計了40組不同構型的試驗設計點，並以此為基礎對v型褶皺芯材夾層板的熱傳導性能構建了可用的代理模型，給出了數值模擬函數和最輕重量條件下的優化設計方法。
  2. Test method for thermal conductivity of insulating firebrick

    絕熱耐火磚的熱傳導性的測試方法
  3. The temperature rise at the center of a massive concrete wall is calculated by using the adiabatic rise of temperature and heat conduction equations of concrete based on the equivalent time, and considering effects of temperature on the hydration heat reaction ratio and creep characteristics of early - age concrete

    摘要基於等效時間的混凝土絕熱溫升、熱傳導方程，考慮溫度對早期混凝土水化熱化學反應速率和徐變特性的影響，計算了大體積混凝土墻中心的溫升。
  4. In this paper, a crank - nicolson mixed element method, a nonlinear galerkin mixed element method for the non stationary conduction - convection problems time second order accuracy fully discrete formats and a two - level mixed element method with backtracing for the stationary conduction - convection problems are presented and analyed, respectively, an error analysis are provided for the crank - nicolson method of time discretization applied to spatially discrete galerkin mixed element approximations of the nonstationary conduction - convection problems

    本文分別給出了非定常的熱傳導-對流問題的crank - nicolson混合元法時間二階精度全離散格式，非線性galerkin混合元法時間二階精度全離散格式以及定常的熱傳導-對流問題回溯二重水平法。討論了時間上的crank - nicolson離散方法應用於非定常的熱傳導-對流問題的空間離散的galerkin混合元近似。
  5. Nonclassical heat conduction analysis in periodic structures with multiple spatial and temporal scales analysis method

    周期性材料非經典熱傳導時空間多尺度分析方法
  6. In this article, physical equations and relative three - dimensional finite - difference formulae in cylindrical and spherical geometries were derived and two - and three - dimensional code in cylindrical and spherical geometries for direct - drive by laser was made, based on the lared - s code in planar geometry. it consisted of the processes such as the inverse bremsstrahlung absorption, electic heat conduction and fluid dynamics

    本論文在lared - s程序平面版本基礎上，推導了三維柱和球幾何中激光驅動的物理方程和相應的差分方程，編制了二維和三維柱和球幾何中激光驅動流體不穩定性的lared - s程序版本，主要物理過程包括：激光逆軔致吸收、電子熱傳導和流體運動。
  7. The temperature effect which has been calculated is taken as " thermal load " forced on the body, then such thermal stress is settled as general elasticity mechanics question ; secondly, the thermal stress is taken as " surface force " forced on the body, and the new system stiffness is formed which include the extra stiffness matrix, then it changes the nature frequency of the structure

    首先，這篇論文介紹溫度場和熱應力場的有限元方法，建立了三維熱傳導模型計算有溫度場產生的熱應力，計算熱應力時運用了一種轉化思維：將溫度處理為「溫度載荷」 ，這樣就能用彈性力學問題的處理方法來求解熱應力。其次，將熱應力作為結構的「面內力」 ，而面內力產生附加的幾何剛度矩陣，改變了結構的剛度，影響了結構的固有頻率。
  8. The following conclusions and innovation can be obtained : ( 1 ) the marc finite element analysis software and subroutine program is used to analyse the model of deicing or snow - melting and heat transfer problems in practical deicing or snow - melting successfully. the results are found to be in good agreement with relevant literature. when the wind scale exceeds 3, the influence of wind is apparent and must be taken into account in practical design

    得到了以下的結論和創新性成果： （ 1 ）藉助于marc有限元程序和自編的用戶子程序成功地分析了融雪化冰模型，並解決了融雪化冰中所涉及的熱傳導計算問題，得到的結果與相關文獻吻合得較好。
  9. In this article, according to heat conduction theory, elastic creep theory and finite element theory, the temperature field and creep stress field in the arch dam during construction and operation are simulated and analyzed by means of three dimensional finite element relocating mesh method, and the distribution law of the temperature field and creep stress field in the arch dam during construction and operation are systematically studied, and according to the construction process of concrete arch dam, the effect of lamination placement, construction interval, elastic modulus change, thermal insulation change, surrounding temperature change, concrete creep and autogenous volume change on thermal stress in the arch dam are also considered

    論文根據熱傳導理論、彈性徐變理論及有限元理論，用三維有限元浮動網格法對拱壩施工期和運行期溫度場、徐變應力場進行了全過程模擬分析，較為系統的研究了混凝土拱壩施工期和運行期溫度場、徐變應力場的分佈規律，在分析中按照混凝土拱壩施工過程，考慮了混凝土分層澆築、施工間隙時間、彈模變化、絕熱溫升過程、環境溫度的變化、混凝土徐變、自生體積變形等因素對壩體溫度應力的影響。
  10. Boundary element solution to a class of periodical heat conduction equation

    一類周期性熱傳導方程的邊界元數值解法
  11. In the paper, with system energy balance method and heat conductive equations ， on tne basis of short time heat transfer modeling established the long time modeling, considering heat interference in thermal well group. this paper used the finit element method for element division and computer analysis, and provided the operation temperature figure. acquired computation values agreed well with experimental results, the most difference between them was 5. 13 %

    本文採用系統能量平衡結合熱傳導方程，在淺埋套管式換熱器短期傳熱模型基礎上建立了長期傳熱模型，並考慮了管群熱干擾對模型的影響。並運用有限單元法軟體編程進行離散和計算機分析，得出模擬溫度場，其模擬值與實測的均值基本相符，兩者最大誤差小於5 . 13 % ，表明該模型具有一定的合理性和實用意義。
  12. Furthermore, both current in - situ conductivity test data interpretation methods and gshp design methods are based on models that only consider heat conduction. therefore, the groundwater flow may impact the results of in - situ thermal property of soil, and then the ghe size, and make the short - time economics of gshp comparatively unattractive consequently

    此外，由於現場對巖土熱物參數的測試及分析也都僅考慮了熱傳導的影響，這勢必影響現場測試結果的精度，最終又會引起換熱器大小的變化，使土壤源熱泵的經濟性受到挑戰。
  13. A thoroughly study on characteristics of ground pipe - heat exchanger of gshp has been made in this ph. d. thesis. the research method used in this thesis is very useful for other ground energy storage system. the research results could be very significant for engineering application of gshp technique

    本文對地下埋管換熱器傳熱性能的研究較為深入，研究方法對其他地下蓄能系統的研究有借鑒意義，研究成果對地源熱泵技術的推廣具有工程指導意義。
  14. Based on the relaxation constitutive theory of viscosity - elasticity under non - constant temperature, the equation of thermal conduction in solids, and the finite element method, the non - stationary thermal stress in low carbon steel thick hollow sphere is calculated

    摘要基於變溫粘彈性鬆弛型本構理論、熱傳導方程和有限元方法，對低破鋼厚壁球的非定常熱應力進行了分析。
  15. 2. nonlinear source term identification problem about a quasilinear parabolic heat equation is investigated. for the given function determined, the existence and the uniqueness of the solution of the state equation are proved and the dependence of the solution of the state equation on the identification parameter is discussed ; then the identifiability is verified ; through choosing suitable basic functions, the above identification problem can be transformed into a constant coefficients identification problem ; and an practical iterative algorithm for solving the identification problem is presented, the feasibility and validity of the algorithm is verified by the numerical experiments

    2 、研究一擬線性拋物型熱傳導方程非線性未知源項的識別問題；對于給定識別函數，論證了狀態方程解的存在惟一性、方程解與識別函數的依賴關系和可識別性；通過選取適當的基函數，把對非線性源項的識別轉化成常系數識別問題；給出了實現非線性源項識別的迭代演算法，通過數值實驗證明了演算法的有效性。
  16. Heat transfer fluids. determination of thermal stability

    熱傳導液熱穩定性測定法
  17. In chapter 2, a new irreversible cycle model is presented for an absorption refrigerator, in which not only the irreversibilities of heat conduction and heat leakage but also the irreversibilities resulting from the friction, eddy and other irreversible effects inside the working fluid are taken into account

    第二章建立了不可逆吸收式製冷循環新模型，模型不僅考慮了熱傳導和熱漏不可逆性，而且也考慮了循環工質內部由於摩擦，渦流及其它不可逆效應所引起的內不可逆性。
  18. In chapter 2, heat conduction and thermal deformation theory are introduced. and then, the finite element method about temperature field and thermal deformation is summarized

    第二章介紹了熱傳導和熱彈塑性基礎理論知識，總結了溫度場和熱彈性的有限元分析理論。
  19. Taking into account temperature - dependent thermal conduction and heat capacity, a three - dimensional transient finite element model was established

    摘要在考慮隨溫度變化而變化的熱傳導、比熱容等熱物性參數的作用下，建立了直接金屬多道燒結的三維有限元分析模型。
  20. The hyperbolic models which can describe the relaxation property of heat conduction are modification to the classical theory of fourier heat conduction

    能夠刻畫熱傳導弛豫性質的雙曲模型是經典傅里葉導熱定律的修正。
分享友人
分享到 Line

分享到臉書