熱傳導法 的英文怎麼說
中文拼音 [rèzhuàndǎofǎ]
熱傳導法
英文
radiant heat method-
Based on the above, a surrogate models are built for thermal conductibility performance of sandwich panel with " v - type " folded core in this paper, and they can be optimized by multi - subject. the numerical simulation function and optimization design method in condition of lightest weight are shown in this paper
其次，用isight軟體重新設計了40組不同構型的試驗設計點，並以此為基礎對v型褶皺芯材夾層板的熱傳導性能構建了可用的代理模型，給出了數值模擬函數和最輕重量條件下的優化設計方法。Heat losses from the reservoir by heat conduction cannot be prevented.
熱儲通過熱傳導的熱損耗是無法阻擋的。Test method for thermal conductivity of insulating firebrick
絕熱耐火磚的熱傳導性的測試方法In this paper, a crank - nicolson mixed element method, a nonlinear galerkin mixed element method for the non stationary conduction - convection problems time second order accuracy fully discrete formats and a two - level mixed element method with backtracing for the stationary conduction - convection problems are presented and analyed, respectively, an error analysis are provided for the crank - nicolson method of time discretization applied to spatially discrete galerkin mixed element approximations of the nonstationary conduction - convection problems
本文分別給出了非定常的熱傳導-對流問題的crank - nicolson混合元法時間二階精度全離散格式，非線性galerkin混合元法時間二階精度全離散格式以及定常的熱傳導-對流問題回溯二重水平法。討論了時間上的crank - nicolson離散方法應用於非定常的熱傳導-對流問題的空間離散的galerkin混合元近似。Nonclassical heat conduction analysis in periodic structures with multiple spatial and temporal scales analysis method
周期性材料非經典熱傳導時空間多尺度分析方法The temperature effect which has been calculated is taken as " thermal load " forced on the body, then such thermal stress is settled as general elasticity mechanics question ; secondly, the thermal stress is taken as " surface force " forced on the body, and the new system stiffness is formed which include the extra stiffness matrix, then it changes the nature frequency of the structure
首先，這篇論文介紹溫度場和熱應力場的有限元方法，建立了三維熱傳導模型計算有溫度場產生的熱應力，計算熱應力時運用了一種轉化思維：將溫度處理為「溫度載荷」 ，這樣就能用彈性力學問題的處理方法來求解熱應力。其次，將熱應力作為結構的「面內力」 ，而面內力產生附加的幾何剛度矩陣，改變了結構的剛度，影響了結構的固有頻率。Standard test method for thermal transmittance of textile materials
紡織材料的熱傳導的標準試驗方法In this article, according to heat conduction theory, elastic creep theory and finite element theory, the temperature field and creep stress field in the arch dam during construction and operation are simulated and analyzed by means of three dimensional finite element relocating mesh method, and the distribution law of the temperature field and creep stress field in the arch dam during construction and operation are systematically studied, and according to the construction process of concrete arch dam, the effect of lamination placement, construction interval, elastic modulus change, thermal insulation change, surrounding temperature change, concrete creep and autogenous volume change on thermal stress in the arch dam are also considered
論文根據熱傳導理論、彈性徐變理論及有限元理論，用三維有限元浮動網格法對拱壩施工期和運行期溫度場、徐變應力場進行了全過程模擬分析，較為系統的研究了混凝土拱壩施工期和運行期溫度場、徐變應力場的分佈規律，在分析中按照混凝土拱壩施工過程，考慮了混凝土分層澆築、施工間隙時間、彈模變化、絕熱溫升過程、環境溫度的變化、混凝土徐變、自生體積變形等因素對壩體溫度應力的影響。Boundary element solution to a class of periodical heat conduction equation
一類周期性熱傳導方程的邊界元數值解法Collocation methods and error analysis for the semiconductor problem with heat - conduction
熱傳導型半導體問題的配置方法及誤差分析In the paper, with system energy balance method and heat conductive equations ， on tne basis of short time heat transfer modeling established the long time modeling, considering heat interference in thermal well group. this paper used the finit element method for element division and computer analysis, and provided the operation temperature figure. acquired computation values agreed well with experimental results, the most difference between them was 5. 13 %
本文採用系統能量平衡結合熱傳導方程，在淺埋套管式換熱器短期傳熱模型基礎上建立了長期傳熱模型，並考慮了管群熱干擾對模型的影響。並運用有限單元法軟體編程進行離散和計算機分析，得出模擬溫度場，其模擬值與實測的均值基本相符，兩者最大誤差小於5 . 13 % ，表明該模型具有一定的合理性和實用意義。In chapter 5, we extent the results of the finite difference domain decomposition algorithm of paper [ 13 ] for two dimensional heat equation and give some numerical results
在第五章，我們在二維熱傳導方程求解上擴充了dawson等人的區域分解演算法。給出了關于演算法計算精度的數值結果。By using the eigenfunction expansion technique, a one - dimension finite element formulation is then developed to determine the eigensolutions to the 2d heat conduction problem at the crack tip, which discretizes the sectorial domain circumferenially
利用特徵方程展開方法，可獲得分析裂紋尖端處二維熱傳導特徵解的一維有限元列式。( 3 ) temperature field and residual capacity of reinforced concrete member after fire studied by the numbers, various boundary conditions of heat exchange equation and the solutions of them given an account, the formulae of the residual capacity of the members after fire established, the program of temperature field programmed on the basic of finite difference algorithm, a case given to demonstrate
（ 3 ）對火災后構件溫度場的分佈和剩餘承載力的計算進行了系統地分析和研究。討論了熱傳導方程的各種邊界條件及相應的解法，建立了不同構件的剩餘承載力計算公式，並結合工程實例用有限差分法編制了相應的溫度場計算程序，與實例吻合良好。Determination in laboratory of thermal transmission coefficients of constitutive partition wall by method of hot guarded box
通過保溫箱法進行本構隔墻熱傳導系數的實驗室測定Based on the relaxation constitutive theory of viscosity - elasticity under non - constant temperature, the equation of thermal conduction in solids, and the finite element method, the non - stationary thermal stress in low carbon steel thick hollow sphere is calculated
摘要基於變溫粘彈性鬆弛型本構理論、熱傳導方程和有限元方法，對低破鋼厚壁球的非定常熱應力進行了分析。2. nonlinear source term identification problem about a quasilinear parabolic heat equation is investigated. for the given function determined, the existence and the uniqueness of the solution of the state equation are proved and the dependence of the solution of the state equation on the identification parameter is discussed ; then the identifiability is verified ; through choosing suitable basic functions, the above identification problem can be transformed into a constant coefficients identification problem ; and an practical iterative algorithm for solving the identification problem is presented, the feasibility and validity of the algorithm is verified by the numerical experiments
2 、研究一擬線性拋物型熱傳導方程非線性未知源項的識別問題；對于給定識別函數，論證了狀態方程解的存在惟一性、方程解與識別函數的依賴關系和可識別性；通過選取適當的基函數，把對非線性源項的識別轉化成常系數識別問題；給出了實現非線性源項識別的迭代演算法，通過數值實驗證明了演算法的有效性。Heat transfer fluids. determination of thermal stability
熱傳導液熱穩定性測定法Wavelet solving process of heat - conduction equation
熱傳導方程的小波解法Computing by heat transfer
熱傳導法計算分享友人