熱反射塗層 的英文怎麼說

中文拼音 [rèfǎnshètúcéng]
熱反射塗層 英文
heat-reflecting coating
  • 反 : Ⅰ名詞1 （方向相背） reverse side 2 （造反） rebellion 3 （指反革命、反動派） counterrevolutionari...
  • 射 : Ⅰ動詞1 （用推力或彈力送出） shoot; fire 2 （液體受到壓力迅速擠出） discharge in a jet 3 （放出） ...
  • 塗 : Ⅰ動詞1 （抹） spread on; apply; smear 2 （亂寫或亂畫） scrawl; scribble 3 （抹去） cross [blot; s...
  • 層 : i 量詞1 （用於重疊、積累的東西 如樓層、階層、地層） storey; tier; stratum 2 （用於可以分項分步的...
  • 塗層 : paint-coat; paintcoat; coat; coating; covering; lining; wrapping flux
  1. Indium stannum oxide ( ito ) as semiconductor have caused a great deal of interest due to their prominent electro - optical behavior. ito has high prominent transmittance, high infrared reflectance, good electrical conductivity, ito applied as gas sensors, photovoltaic devices, heat reflecting mirrors, solar cells, flat panel displays, liquid crystal displays, electroluminescent, devices and organic light - emitting diodes ( oled ) etc. although preparations and applications of ito films have been studied deeply. nano - ito composites hardly studied

    氧化銦錫（ ito ）是一種高簡並的n型半導體，由於具有導電性，可見光高透過率，紅外反射性，穩定的化學性，被廣泛應用於熱反射建築玻璃、抗靜電塗層，太陽能電池，熱發射鏡，平板顯示器和液晶顯示屏，傳感器，有機光致二級管（ oled ）等方面，國內外對高質量的ito薄膜的制備和應用進行了深入的研究，但是很少有ito納米粒子與高分子材料復合的報道。
  2. At the initial stage of planar technique, b was employed as ideal diffusion impurity in base - region of npn si planar devices because of the match of its solid - solubility and diffusion coefficient in si with those of p in emission - region, and the good shield effect of sio2 film to b. but because of the relatively large solubility ( 5 1020 / cm3 at 1000 ) and the small diffusion coefficient, the linear slowly - changed distribution of acceptor b in pn junction can not be formed, which could not cater to the requirement of high - reversal - voltage devics. thereafter b - a1 paste - layer diffusion technology and close - tube ga - diffusion technology had been developed, while the former can lead to relatively large the base - region deviation and abruptly varied region in si, which caused severe decentralization of current amplification parameter, bad thermal stability and high tr ; the latter needed the relatively difficult pack technique, with poor repeatability, high rejection ratio, and poor diffusion quality and productio n efficiency

    在平面工藝初期，由於b在硅中的固溶度、擴散系數與n型發射區的磷相匹配， sio _ 2對其又有良好的掩蔽作用，早被選為npn硅平面器件的理想基區擴散源，但b在硅中的固溶度大（ 1000時達到5 10 ~ （ 20 ） ，擴散系數小， b在硅中的雜質分佈不易形成pn結中雜質的線性緩變分佈，導致器件不能滿足高反壓的要求，隨之又出現了硼鋁塗層擴散工藝和閉管擴鎵工藝，前者會引起較大的基區偏差，雜質在硅內存在突變區域，導致放大系數分散嚴重，下降時間t _ f值較高，熱穩定性差；後者需要難度較大的真空封管技術，工藝重復性差，報廢率高，在擴散質量、生產效率諸方面均不能令人滿意。
  3. The varieties, amount and particle size of reflective materials are the key factor for control of reflecting solar heat of coatings

    反射材料的種類、數量和粒徑是決定塗層太陽熱反射能力的關鍵因素。
  4. It is found that aggregating state of reflective materials shows decisive influence on the capability of reflecting solar heat of coatings in dry coatings through theoretical analysis and experiments

    本文通過理論分析和試驗證明，認為在乾燥塗層中，反射材料的分散聚集狀態對塗層的太陽熱反射能力有重要影響。
  5. “ ouslan ” the thermal insulation layer uses the rare metal completely, and uses the even coating technology, spreads evenly the conductive sea the cloth on the basement membrane, will cause it to occupy in the sunlight the main quantity of heat to reflect a part, to absorb a part, simultaneously will transmit a part, will create an independent cool world for you

    隔熱層全部採用稀有金屬，並採用均勻鍍膜技術，將金屬層均勻塗布在基膜上，使其將占太陽光中主要熱量反射一部分、吸收一部分，同時傳遞一部分，為您創造一個獨立的清涼世界。
  6. The capability of reflecting solar heat and radiation refrigeration depends mainly on reflective materials ( pigments and fillers ) in coatings

    塗層的反射太陽熱和輻射製冷能力主要與塗層中的反射材料（顏填料）有關。
分享友人
分享到 Line

分享到臉書