熱差分析 的英文怎麼說

中文拼音 [rèchāfēnxī]
熱差分析 英文
thermal analysis
  • 差 : 差Ⅰ名詞1 （不相同; 不相合） difference; dissimilarity 2 （差錯） mistake 3 [數學] （差數） differ...
  • 分 : 分Ⅰ名詞1. （成分） component 2. （職責和權利的限度） what is within one's duty or rights Ⅱ同 「份」Ⅲ動詞[書面語] （料想） judge
  • 析 : Ⅰ動詞1. （分開; 散開） divide; separate 2. （分析） analyse; dissect; resolve Ⅱ名詞（姓氏） a surname
  1. Differential thermal analysis did not reveal the ammonium perchlorate phase change from rhombic to cubic.

    差熱分析沒有測出過氯酸銨從正交晶向立方晶的相變。
  2. On the basis of expound the theory of building exterior - protected construction energy consumption and the gene of influence the building energy, set up mathematics model, this article discuss the mechanism of dispelling the heat of the buildings " thermal bridge and the complication that influence it, and then synthetic analysis and calculate the influence range of building thermal bridge in exterior - protected construction column thermal bridge to the building outer wall get the conclusion that when the construction column can satisfy the building stress - area, in bulgy construction column dispel less heating than out bulgy construction column. but if the pole stuck out more than 100mm, in bulgy or out bulgy make no difference

    本文在闡述建築圍護結構耗熱原理以及影響建築能耗因子的基礎上，採用數值模擬方法，探討了建築熱橋傳熱的基本機理和影響建築熱橋傳熱的因素，進而對建築熱橋在圍護結構傳熱中的影響范圍進行了綜合分析和計算，研究了構造柱熱橋型式對建築外墻能耗的影響，得出了構造柱在滿足建築受力面積要求的情況下，內凸構造柱較外凸構造柱略能減少散熱量的結論，但是凸出過大（ 100mm ）無論內凸還是外凸對建築耗熱都沒有大的差別。
  3. Differential scanning calorimeter study on fe73. 5 cu1nb3si13. 5b9 alloys

    9合金示差掃描熱分析
  4. Differential scanning calorimetry dsc

    微差掃瞄熱卡分析法
  5. Determination of ignition temperature of pyrotechnic composition - dta - tg analysis

    煙火藥劑著火溫度的測定差熱-熱重分析法
  6. Collocation methods and error analysis for the semiconductor problem with heat - conduction

    熱傳導型半導體問題的配置方法及誤差分析
  7. 90. 95. the phase transformation temperature of the natural cryptomelane was about 635. 5 examined by tga and dta and the cryptomelane was changed to bixbyite at a higher temperature. these studies reveal the significant features of cryptomelane for the potential application in the environmental materials science

    K 3 . 37 % 4 . 17 %差熱熱重分析表明天然錳鉀礦的結構熱穩定性較好， 635 . 5時相轉變為方鐵錳礦。
  8. A measurement method regarding reactor core thermal power and error analysis

    反應堆堆芯熱功率測量方法及其誤差分析
  9. And, this thesis return as to it ' s measure to measure the proceeding error margin the analysis, and was analyzed by error margin the enthalpy different laboratory matchs the gb / t 7725 - 1996 standard, can be used for measuring the making the cold and making the heat ' s ability, the consuming, the cop, the breeze deal under the steady state or not steady state of air condition of diagraph room, and it can also test the influence of the four channels change to the face valve and and the electronic expanding valve to the whole function of the air condition

    而且，本論文還對其測量量進行誤差分析，經誤差分析該焓差室符合gb t7725 - 1996標準，可用於測量房間空調穩態及非穩態製冷能力和制熱能力、工耗、 cop以及空調器室內機組的風量，並能測試四通換向閥、電子膨脹閥等控制元件對空調器整體性能的影響。
  10. The principles and its system error analysis of measuring specific heat ratio of the air

    空氣比熱容比實驗的原理和系統誤差分析
  11. On the basis of the analysis of fundamental principle of thermoelectric refrigeration, the steady state mathematical model of the thermoelectric system was founded. according to the model, the theoretical analysis and calculation are made on various working conditions, and analyzed theoretically the effects on thermoelectric system which caused by hot and cold temperature difference, the device ’ s effective system figure of merit, the properties of the heat changers, which established theoretical basic for the opening up and design of the thermoelectric system and its performance test

    在分析熱電製冷基本原理的基礎上，建立了熱電裝置的穩態系統數學模型，並依據該模型對熱電裝置系統進行了不同的工作狀態下的熱力分析計算，並就熱電裝置的冷熱端溫差、電堆片的優值系數、散熱器的散熱性能與熱電熱泵裝置性能的影響進行了理論分析，為熱電裝置的開發設計和現有熱電裝置的性能測試建立計算理論基礎。
  12. An experimental apparatus has been set up start from scratch and some experiments have been done to study the heat transfer characteristics of the ice - on - coil tank. the comparison of the theoretical predictions and the experimental data has been made and the disagreements between them are also analyzed

    建立了導熱塑料蓄冰盤管傳熱性能測試裝置，測試了結冰和融冰過程中載冷劑的進出口溫度、流速和結冰或融冰時間的關系，通過實驗結果與理論計算的比較和誤差分析，驗證了建立的數學模型的合理性。
  13. The intermediate - temperature sofc ( solid oxide fuel cell ) ’ s electrolyte with perovskite - type lsgm ( la _ ( 0. 9 ) sr _ ( 0. 1 ) ga _ ( 0. 8 ) mg _ ( 0. 2 ) o _ ( 3 - ) ) was synthesized using advanced pechini method and solidification method. the thermal and electrical properties of the sintered samples ( synthesized by two different methods ) were measured and compared by thermal expansion and ac impedance spectroscopy ; the phase transformation process and inner structure were measured and compared by xrd, dta - tg and ac impedance spectroscopy. the research results show that the electrolyte synthesized by advanced pechini method has several advantages, such as fine pre - powders, low sintering temperature, reduced or eliminated impurity phases and high conductivity etc. so, the apm is ideal method to synthesize lsgm

    採用改進的檸檬酸法（以檸檬酸和edta乙二氨四乙酸為復合絡和劑，檸檬酸為燃料）和固相法分別制備了具有鈣鈦礦結構的中溫固體氧化物燃料電池的電解質材料lsgm （ la _ （ 0 . 9 ） sr _ （ 0 . 1 ） ga _ （ 0 . 8 ） mg _ （ 0 . 2 ） o _ （ 3 - ） ） ，用差熱?熱重分析（ dta / tg ） 、 x光衍射分析（ xrd ） 、交流阻抗譜技術（ ac - impedancespectra ） 、比表面積分析（ bet ）和燒結收縮率曲線等手段對產物的熱分解過程、物相轉變和內部結構等進行了表徵，並對由這些粉體燒結而成的固體氧化物燃料電池的電解質材料的電導率進行了檢測。
  14. The monitoring error analysis of thermoluminescence detectors and the quality control

    熱釋光探測器在個人劑量監測中的誤差分析及質量控制
  15. The application of differential thermal and thermo - gravimetric difference analysis to mineral identification

    礦物熱重差分析的應用
  16. The pinch point temperature differences analysis method was introduced in this paper, the major equipments of system was designed in term of the guide line that the best general efficiency of cooling and heating mode should be achieved

    本文首先按照使製冷制熱兩種典型工況下綜合效率最佳的原則，利用挾點溫差分析的方法設計了系統的主要部件。
  17. Heat deviation analytical method is adopted, which is used to analyze the influences which the main operational monitored parameters have on the economic performance of the power plant unit

    採用熱偏差分析方法，分析了鍋爐主要運行可監控參數對機組經濟性的影響。
  18. The system performance tests and error analysis was put up at 90 and 120 that is very often used, the results show that the rise time is less than 20 min, and control precision is within 1, and that the requirement of the hotplate is met.

    在熱板常用溫度點90和120對溫度控制系統分別進行了性能測試和誤差分析。結果表明，熱板的溫度上升時間小於20min 、溫度控制精度均在1之內，滿足熱板的工作需要。
  19. The suitable preparing condition of the composite has been set down by a series of experiments. the clay / poly - acrylamid superabsorbent composite is characterized by infrared ( ir ), thermogravimetry, analysis ( tga ), differential scanning, calorimetry ( dsc ) and x - ray diffraction analysis ( xrd )

    在理論研究方面，利用x射線粉晶衍射光譜、紅外吸收光譜、熱重分析法、示差掃描量熱法、電化學分析等方法對超吸水性復合材料的吸水性能與超吸水性復合材料的組成基團以及結構關系進行了深入探討。
  20. Design and error analysis of bi - directional hot centering mechanism

    雙向熱定心機的設計及其熱定心誤差分析
分享友人
分享到 Line

分享到臉書