熱彈性帶 的英文怎麼說

中文拼音 [dànxìngdài]
熱彈性帶 英文
thermoplastic tape
  • : 彈名詞1. (彈子; 小球形的東西) ball; pellet 2. (內裝爆炸物, 具有破壞和殺傷能力的東西) bullet; bomb
  • : Ⅰ名詞1 (性格) nature; character; disposition 2 (性能; 性質) property; quality 3 (性別) sex ...
  1. The removal of nocturnal solitude, the superior quality of human mature female to inhuman hotwaterjar calefaction, the stimulation of matutinal contact, the economy of mangling done on the premises in the case of trousers accurately folded and placed lengthwise between the spring mattress striped and the woollen mattress biscuit section

    消除了夜晚的孤寂,人成熟的女的溫暖勝過非人「湯壺」的氣以及早晨的接觸給予的刺激把長褲疊,豎著夾在簧床墊條紋的和羊毛墊子黃褐色方格花紋之間,就能節省熨燙之勞了。
  2. 4. the choice reference of medium belt material is came up with : with higher compress intensity, pull intensity and bend fatigue intensity, with middle or low elastic modulus, besides fine heat - resistant, wearable, oil - fast, water - fast anti - impactive capabilities

    4 、提出並分析了介質材料的合理選擇原則:壓縮強度、拉伸強度和彎曲疲勞強度高和韌好的中低模量復合材料,此外還需具有良好的耐、耐油耐水、耐磨、抗沖擊、耐候等。
  3. Plastics piping systems. glass - reinforced thermosetting plastics components. test methods to prove the design of rigid locked socket - and - spigot joints with elastomeric seals

    塑料管道系統.玻璃纖維增強式塑料元件.檢驗密封件的剛鎖定管座套筒接頭設計的試驗方法
  4. In the paper, active control to rotor vibration with sma is studied : 1 ) the material performance of sma, especially the coupled relation of strain, stress and temperature, is studied in nonlinear coupled thermoelasticity theory and the linear result is modified ; 2 ) the nonlinear dynamic behavior of rotor system with sma bearing is studied in the nonlinear theory and the dynamic stability theory and the deference of the soft / hard nonlinear system is pointed out

    1 )運用非線耦合理論研究記憶合金材料的力學能,特別是應力、應變和溫度三者之間的耦合關系,改進了原有的線結果。 2 )運用非線理論和運動穩定理論研究有記憶合金支承的轉子系統在非定常狀態的非線動力學行為,指出了軟、硬非線系統的區別。
  5. V - belts, composed of high - strength and hign - elasticity tensile body and heat resistance rubber, and is designed for hign - speed and high - temperature application

    汽車三角由高強度,高的抗張體和耐橡膠製成,並被設計成特殊形狀以適合於高速,高溫的條件
  6. Using the engineering methods of supersonic and hypersonic flow or local piston theory developed in this paper to compute unsteady aerodynamic loads, and coupling structural equations, the supersonic or hypersonic aeroelasticity with a typical servo system under thermal environment is simulated in time - domain

    運用超音速、高超音速氣動力工程計算方法和本文發展的當地流活塞理論計算非定常氣動力,耦合結構運動方程,實現了環境中有伺服機構的氣動的時域模擬。
  7. It was revealed that elastomer or filler had its strong point as modifier of pp. at the same matrix ligament thickness l, improvement of toughness by elastomer was obviously higher than that of caco3, while adding caco3 increased the modulus, hardness and heat deflection temperature of pp

    0刀9匆m人指出用體和無機剛粒子作聚丙烯的增韌劑各有所長,在相同基體厚度l下,體提高韌的程度明顯高於c3co3 , c3co3則使聚丙烯的模量、硬度和變形溫度等明顯提高。
  8. Thermoplastics piping systems - joints for buried non - pressure sewerage applications - test method for long - term sealing performance of joints with thermoplastic elastomer seals by estimating the sealing pressure

    塑管道系統.地下埋裝的非承壓污水設施用連接件.通過對密封壓力的估計對力密封件的連接件的長期密封能的試驗方法
  9. Standard specification for mechanical couplings using thermoplastic elastomeric gaskets for joining drain, waste, and vent, sewer, sanitary, and storm plumbing systems for above and below ground use

    地下和地上用的連接排水廢物通風污水衛生及暴雨管件設備的墊圈的機械連接件的標準規范
分享友人