熱模型 的英文怎麼說

中文拼音 [rèmóxíng]
熱模型 英文
thermal model
  • 模 : 模名詞1. （模子） mould; pattern; matrix 2. （姓氏） a surname
  • 模型 : 1 （仿製實物） model; pattern 2 （制砂型的工具） mould; pattern3 （模子） model set; mould patter...
  1. Thermal models show that even if the asteroids assembled immediately after the formation of the chondrules, 26al heating would have raised temperatures in the interiors of ordinary - chondrite bodies to a maximum of 1, 100 degrees c ? high enough to cause melting of metals and sulfides but too low to melt silicate minerals extensively and differentiate an asteroid

    熱模型顯示，即使小行星在球粒形成之後立刻聚合，鋁26的加熱最多也只能將普通球粒隕石內的溫度提高到1100 ，雖可使金屬和硫化物熔化，但並不足以將矽酸鹽礦物大量熔化並造成小行星各層分異。
  2. It provides strong basement for the research of design. the method of structure analysis commended by this paper is based on nonlinear finite - element, diathermanous and elasticity mechanics. it found the model of a steel beam pressed by gravity and temperature in the condition of indoor fire

    本文提出的結構分析法是在大量參數分析的基礎上，以非線性有限元、傳熱學及彈性力學為基礎，利用ansys軟體，建立一個鋼框架梁在室內局部火災條件下的傳熱模型與在重力荷載及溫度荷載共同作用下的受力模型。
  3. Meterals and methods subject were 30 male wistar rats which were made febrile by lps intraper - itoneal injection. the rectal temperature of the rats were monitored by the digital esthesiometer. effect of - mshon fever was observed and changes in levels of avp both in the plasma and csf were detected a fter administration of - msh

    材料與方法實驗採用雄性wistar大鼠，並建立大鼠lps性發熱模型，通過檢測大鼠直腸溫度，觀察靜脈注射- msh對大鼠lps性發熱反應的影響及血漿和腦脊液中avp含量的變化。
  4. In the paper, theoretic transfer heat model of hhchp is established. after comparing experimental value and estimative value, we deduce that theoretic transfer heat model accords with actual condition, so we can estimate the heat performance of hhchp by theoretic calculation formula

    同時建立了蜂窩熱管平板式太陽能熱水器的理論傳熱模型，通過對實驗值和理論值的比較，得出進行簡化后的理論模型在一般情況下與實際的情況是符合的，因此可以用理論計算公式對蜂窩熱管平板式太陽能熱水器的熱性能進行估算。
  5. Since twentieth century scholars all of the world have studied on the indoor thermal environment, this paper first summarizes in detail on thermal environment and thermal comfort, air - conditioning mode and energy conservation, thermal environment judge, simulation and emulation, environment physiology, preventive medicine, hygienics and epidemiology, garment etc of native and foreign countries ’ research status in quo. it introduces the mature achievement of human and environment heat transfer model, thermal environment evaluating indicators and comfort influence factors, standards of thermal comfort of the indoor environment, and some of which are researched in defence such as the thermal environment of aviation module or warship cabin of the psychologic and physiological influence on soldiers. so this paper still discusses human psychologic and physiological mechanics in thermal environment

    自20世紀以來，各國的學者紛紛對室內熱環境進行了研究，本文首先較為詳細地綜述了國內外熱環境與熱舒適，空調方式和節能，評判、模擬與模擬，環境生理學、預防醫學、衛生學、流行病學，服裝學等方面的研究現狀，介紹了人體與環境傳熱模型、熱環境評價指標、影響熱舒適的因素、室內環境熱舒適的標準等方面比較成熟的研究成果，研究中不乏有用於國防研究的特定熱環境（如航空艙、軍艦艙）對士兵生理和心理方面的影響，因此本文還闡述了有關在熱環境下人體生理和心理反應的機理。
  6. Through the study of the example of shaxi porphyry body in anhui province, the authors first figured out the storage time of plagioclase phenocrysts, then calculated the nucleation rate and growth rate of the crystals and, on such a basis, established the thermal model for cooling of the hypabyssal magmatic system

    本文試圖通過對安徽沙溪斑巖體進行實例研究，先求出斜長石斑晶的存儲時間，再算得晶體成核速率和生長速率，進而建立起淺成巖漿體系冷卻的熱模型。
  7. Lastly, experimentations are carried out on chaochai 6102bq engine and the data of the thermal parameters according to different oil - apply lead angle is derived. the influence of the change of oil - apply lead angle on the rate of heat release is researched, then a reference is provided for building an accurate heat release model

    最後，在朝柴6102bq柴油機臺架上進行了試驗，對不同供油提前角下柴油機的熱工參數進行實機測試，對試驗結果進行了處理、分析，研究了供油提前角的改變對放熱規律的影響，為建立該故障下的燃燒放熱模型提供參考。
  8. The topic of this paper originates from the research " semiconductor property fdtd modeling in macrocosm ", which is aided by the national nature science fund

    本論文題目來源於國家自然科學基金項目「半導體特性fdtd全域建模」中的熱模型分析。
  9. Experimental verification of theoretical heat - transfer model of polymer hollow microsphere composite

    中空微球復合材料理論傳熱模型的實驗驗證
  10. Thus, the feasibility and stability of the em - therm model were proved

    驗證了所提出電磁?熱模型的可行性和可靠性。
  11. In the paper, with system energy balance method and heat conductive equations ， on tne basis of short time heat transfer modeling established the long time modeling, considering heat interference in thermal well group. this paper used the finit element method for element division and computer analysis, and provided the operation temperature figure. acquired computation values agreed well with experimental results, the most difference between them was 5. 13 %

    本文採用系統能量平衡結合熱傳導方程，在淺埋套管式換熱器短期傳熱模型基礎上建立了長期傳熱模型，並考慮了管群熱干擾對模型的影響。並運用有限單元法軟體編程進行離散和計算機分析，得出模擬溫度場，其模擬值與實測的均值基本相符，兩者最大誤差小於5 . 13 % ，表明該模型具有一定的合理性和實用意義。
  12. The adiabatic heating model of exploding wires is used to simulate their blasting characters on strong pulsed current, andto gain the influence trends fo exploding wire numbers to their hlasting chacters

    用電爆絲絕熱加熱模型數值模擬了電爆絲在沖擊大電流作用下的電爆炸特性，電爆絲根數對電爆炸特性的影響。
  13. Dynamic model and simulation of fan - coil heat exchanger

    風機盤管換熱器動態換熱模型及計算機模擬
  14. Based on a cone - shaped compound heatshield, a series of research work has been done from the investigation of theoretical analyses of ablative and insulating principles and technical experiments. 1 based on the exploration of improving material performances, a feasible scheme of adding insulating functional layer is proposed ; 2 a simplified calculation method is proposed via establishing fea ( fmite element analysis ) and instantaneous heat transmission is calculated with the mentioned method ; 3 a practical engineering scheme is proposed through a series of experiments ; 4 the interface problems of the function layer are solved through co - curing method and successful samples are manufactured ; 5 in order to estimate properties, the heatshield was anatomized engineering applied possibility is explored on the analyses of performance evaluation by testing mechanical properties, coefficient of heat conductivity and doing dynamic ablative experiments, also, the comparison with that of the required materials is done

    本文以一錐形復合防熱套為研究對象，從燒蝕、隔熱機理的理論分析和工藝試驗兩方面，進行了一下研究工作： 1 、通過對提高材料及製品通過對提高材料及製品隔熱性能的多種途徑進行探討，提出了採用添加隔熱功能層，研究復合型大面積防熱套是理論有效、工藝可行的方案； 2 、通過建立有限元分析模型，對防熱套的燒蝕隔熱行為進行了理論分析，提出了簡化的隔熱計算方法，並用該方法對復合型防熱套的瞬態傳熱模型進行了分析計算； 3 、通過復合型防熱套的工藝探索試驗，提出了一種工程應用上切實可行的工藝方案。
  15. By employing a certain kind of rapid - fire - gun barrel adopting outside liquid cooling method to act as the research object, the fluid - structure coupling heat - transfer model of barrel, cooling fluid and water - jacket was established, and then such a model was calculated with finite element method

    以某採用外液冷方式的速射火炮身管為研究對象，建立了包括身管、冷卻液和水套的流固耦合傳熱模型，使用有限元方法進行研究。
  16. At last the quantified adhesion force is given by a simplified formula. 2. temperature field is the key factor affecting the process of laser material processing

    從激光與材料相互作用的理論出發，建立了激光乾式和濕式清洗的激光加熱模型，並利用數字方法模擬了清洗中溫度場的動態分佈。
  17. Through developing a 2 - dimensions heat transfer model of buried pipe - in - pipe heat exchanger and simulating the process by computer, the author figures out inter - relations of factors which influence characteristics of buried pipe - in - pipe heat exchanger, such as pipe diameter, pipe length, ratio of pipe diameters, flow rate, inlet water temperature, patterns of water inlet and outlet, and material features made of pipe, and proposes some optimizing indexes of buried pipe - in - pipe heat exchanger. the author studies the " heat - - short circuit " phenomenon as well and gives < wp = 5 > some important results

    本文通過建立地下套管式埋管換熱器傳熱過程的二維傳熱模型，並藉助計算機對分析結果進行解析，弄清了影響埋管換熱器性能的管徑、管長、管徑比、通過流量、進水溫度、進出水方式以及管材等參數的作用，並提出了相應的優化指標，對研究界懸而未決的「熱短路」問題也進行了細致分析，得出了有關結論。
  18. Based on the practical condition of the heating distribution network in beijing city, this paper systematically discusses the application of the neural network in the field of heating burden prediction and dispatching, include : based on city heating system, systematically analyzing the current condition of the heating system in our city and the development of the international heating technique, discussing the tendency in the field of the domestic heating system. at the same time, constructing a heating model characterized by distribution, ranking structure, intelligentized and favorable practicability and reliability, which adapts to the situation of our city and greatly enhances the level of automation and energy saving

    本文從北京市供熱管網的實際出發，系統地討論了適合我市實情的神經網路技術在供熱管網預測和調度中的應用研究，主要進行了如下幾個方面的工作：以城市供熱系統為對象，綜合分析了我市集中供熱的現狀，結合當前國際供熱技術的發展，分析了我市集中供熱的發展趨勢，並提出了一種適合我市實情的供熱模型，該模型具有分散式、遞階結構、智能化以及良好的實用性和可靠性等特點，可極大提高集中供熱的自動化水平和節能效果。
  19. A quantitative model of heat production by faulting and its effect on thermal evolution of hydrocarbon source rocks

    斷層作用熱模型及其對烴源巖熱演化的影響
  20. 2 ) simulation of the heat transfer across the walls : there are two methods, finite thickness solid method and semi - infinite solid method, to simulate the heat transfer across the walls when the temperature gradient along the height and the width of the wall is ignored

    在火災環境下，忽略高度和寬度方向的溫度變化，採用一維熱傳導方程，建築、圍護結構適用兩種傳熱模型:有限厚度模型和半無限大厚度模型。
分享友人
分享到 Line

分享到臉書