熱液出口 的英文怎麼說

中文拼音 [rèyèchūkǒu]
熱液出口 英文
hydrothermal vents
  • 液 : 名詞（液體） liquid; fluid; juice
  • 口 : Ⅰ名詞1 （人或動物進飲食的器官; 嘴） mouth 2 （容器通外面的地方） mouth; rim 3 （出入通過的地方） ...
  1. Wl - fa2000 double units laminator is the newest and highest intellective full automatic laminator, use intellective numbers meter control the temperature, you needn ' t do any other operations during it ' s working, import the hydraulic pressure mode, excellent calefaction 、 refrigeration elements, two - double designing, use water and air cooling mode, so that effective improve the working efficiency and better effect, it ' s diploid more quickly than wl - fa1000 laminator

    Fa2000型雙塔層壓機是最新研製出的高效率智能型全自動層壓機，溫度採用智能化數碼控制儀，工作時不需要進行任何操作，壓力採用用進口液壓加壓方式，優質的加熱、散熱元件。
  2. Sluice gate of double disk is controlled by electric - hydraulic handspike ; plc will compare sand temperature on outlet according to pre - designed value and inner sand temperature of double disk ; and then it adjusts close time of sluice gate, controls residence time of hot sand in double disk ; therefore, it can control sand temperature of outlet and make it reach required value.

    雙盤的卸砂門由電液推桿控制， plc根據預設的出口砂溫與實測的雙盤內砂溫進行對比，而調整卸砂門的關閉時間，控制熱砂在雙盤內的停留時間，進而控制雙盤出口砂溫使其達到要求。
  3. By physiognomy feature, it could be divided into three types of thermal structure : positive dome model, negative collapse model and border dome core collapse model. based on the depth degree or magma - thermal influenced, it could be divided into five types of thermal structure : ( ancient ) geothermal anomaly focus region model, superficial volcano eruption hydro - thermalism and hypabyssal intrusive model, thermal anticline ( thermal dome ) model, mid - deep intrusive model, deep mantle ( crust ) thermal plume model ; and put forward a perfect model of the thermal structure. there are many interaction system could be induced into a systematic thermal interaction, include : ocean - continent system, basin - mountain interaction, superficial and mid - deep crust - mantle interaction, crust - mantle commingle interaction, vertical thermal interaction ( delamination ) etc.

    依據地貌形態分為三類：正向穹窿型、負向塌陷型、邊隆核陷型：依據巖漿-熱力作用影響的深淺程度或深度分為五類： （古）地熱異常群集區、表淺層火山噴發-熱液活動與淺成侵入型、熱力背斜（熱穹窿） 、中深層侵入型、深部地幔（地殼）熱柱型；提出了熱力構造作用空間分佈的理想模式，將洋陸系統、盆山作用、淺表與中深部殼幔作用、殼幔混合、垂向熱力作用（拆沉）等納入一個整體統一的熱力作用系統中，為盆地動力學研究打開了一個新窗口；研討了熱力構造研究方法。
  4. In this paper, the sensibility analysis of the factors affecting the temperature in well bore is relatively systematically made by using a large number of the data calculated with the borehole flow and heat transfer 3 ? d numerical model proposed by the author. the study shows that the thermophysical parameters of the drilling fluid and formation, etc. and the entrance temperature and circulating capacity, etc. of drilling fluid have a greater influence on the temperature in well bore. therefore, accurately mastering the thermophysical parameter values of penetrated formation and drilling fluid in well bore, considering the influence of the temperature and pressure on thermophysical parameters and accurately measuring such parameters as entrance temperature and discharge capacity of drilling fluid, etc. are of utmost importance for accurately simulating the temperature in well bore

    利用由作者提出的井內流動和傳熱的三維數值模型計算所得的大量數據，文章對影響井內溫度的諸多因素進行了較系統的敏感性分析，研究表明：鉆井液和地層等的熱物理參數以及鉆井液的入口溫度、循環排量等對井內溫度有較大影響，因此，準確掌握所鉆地區地層和井內鉆井液的熱物理參數值，考慮溫度壓力對熱物理參數的影響，準確測量鉆井液的入口溫度、排量等參數值，對于井內溫度的準確模擬至關重要。
  5. Air vacuuming : to turn two stop - valves of solar panel loose completely to allow air to expel from low - pressure tripe - pipe - valve of outdoor parts

    排除空氣，要將太陽能集熱轉換器上的兩個截止閥完全打開。從室外機組的低壓三通閥的加液口排出空氣。
  6. Warm wet plastic came out of the end of the pipe

    管子的出口流出熱乎乎的液體塑料。
  7. In this research, through the test in geometric parameter and resistance performance, and comparison between random and other stacked packing, pvc screw thread oblique corrugated plate have more advantage. combined with test and theoretic calculate, determined the heat and mass transfer coefficient, obtained the influence relationship between inlet air flow rate, temperature and humidity, inlet liquid desiccate flow rate, temperature and concentration with outlet air humidity in dehumidifier, provided consideration for equipment design and production

    通過對除濕塔的現場測試並結合理論計算，確定其熱質交換系數，並分析得出採用pvc螺紋斜波紋板填料的一定結構的除濕塔，處理空氣的風量、入口溫度和含濕量及除濕溶液流量、入口溫度和濃度對空氣出口含濕量的影響關系，為除濕設備的設計和指導生產運行提供參考。
  8. By setting water level of the direct contact heat exchanger, the superheating of steam can be adjusted

    得出壓力、液位高度為主要影響參數，實現了通過調節液位高度來調節蒸汽出口過熱度。
  9. Local high temperature soliditiation resection was carried out in 43 patients with lung cancer. the high fever, hydrothorax, pneumonia, celiac infection and abdominal wall wound infection etc. occured easily. their causes were analysed and fitting preventive measures were suggested

    對43例肝癌局部高溫固化切除術病人術后並發癥的觀察，發現術后易出現高熱、胸腔積液及肺部、腹腔、腹壁傷口感染等並發癥，並分析了發生的原因，提出了針對性的預防護理措施。
  10. 《 nursing care of postoperative complications of high temperature solidification resection in patients with lung cancer 》 abstract local high temperature soliditiation resection was carried out in 43 patients with lung cancer. the high fever, hydrothorax, pneumonia, celiac infection and abdominal wall wound infection etc. occured easily. their causes were analysed and fitting preventive measures were suggested

    摘要對43例肝癌局部高溫固化切除術病人術后並發癥的觀察，發現術后易出現高熱、胸腔積液及肺部、腹腔、腹壁傷口感染等並發癥，並分析了發生的原因，提出了針對性的預防護理措施。
  11. During the research process, it is from the existing liquid sulfur heating technology - steam heating one, and comgines other several kinds of heating methods. fully comsider the relative merits of heating methods, especially do the detail discussing for utilizing the operating principle of organic carrier heating, technology process and application. giving attention to the operating specialty of harbor, at the same time consider the various kinds of requirements from customers in marker competition, to select suitable technology method in harbor transferring

    在研究過程中主要從已有的液體硫磺加熱工藝? ?蒸汽加熱工藝出發，結合其他多種加熱方式，充分考慮各種加熱方式的優缺點，尤其是對利用有機熱載體加熱的工作原理，工藝流程，應用情況進行詳細論述；兼顧港口作業生產特點，同時考慮市場競爭過程中客戶提出的各種要求等以造出適合港口中轉的工藝方式。
  12. To improve the performance of ashp, an improved ashp system is presented. different from the original system, the new one can control the refrigerant flow rate by the sub - cooling of condenser and adjust the sup - heating of the compressor inlet vapor by the heater in accumulator. the simulation shows the new system not only has better dynamic characteristic of frost and defrost of ashp, but also has higher coefficient of performance

    為改善空氣源熱泵機組的結霜除霜動態性能，提出了一種利用冷凝器過冷度來調節製冷劑流量，在氣液分離器里增加電熱裝置保持壓縮機進口過熱度的改進型系統，結果表明這種改進型系統不但可以改善系統的運行性能，同時能改善系統運行的經濟性，為機組的技術升級和產品更新提供了一個新的途徑。
  13. However, near hydrothermal vents, areas of the ocean where warm water emerges from subterranean sources, live remarkable densities of huge clams, blind crabs, and fish

    然而，在地下熱水涌流出來的熱液噴口附近，聚集著數量龐大的巨蛤、盲蟹和魚，十分引人注目。
分享友人
分享到 Line

分享到臉書