熱特性測量 的英文怎麼說
中文拼音 [rètèxìngcèliáng]
熱特性測量
英文
thermal characteristic measurement- 特 : Ⅰ形容詞(特殊; 超出一般) particular; special; exceptional; unusual Ⅱ副詞1 (特別) especially; v...
- 性 : Ⅰ名詞1 (性格) nature; character; disposition 2 (性能; 性質) property; quality 3 (性別) sex ...
- 測 : 動詞1. (測量) survey; fathom; measure 2. (測度; 推測) conjecture; infer
- 量 : 量動1. (度量) measure 2. (估量) estimate; size up
- 特性 : characteristic(s); character; performance; features; properties; behaviour; response; character...
- 測量 : measure; survey; gauge; meter; measurement; measuring; surveying; mensuration; metering; gauging;...
-
A lot of engineering applications are carried out using our proposed method in this paper, such as thermal deformation measurement of a car lamp, analysis of the super low frequency harmonic vibration of a piezoelectric ceramic, dynamic mechanical behavior analysis of the ballistite material and so on
在前面所提出的理論基礎之上,本文對該方法在實際工程中的應用做出了大量的工作。本文利用時間序列法實現了汽車前燈配光鏡的熱變形檢測、壓電陶瓷片的超低頻振動分析以及火箭固體燃料的動態力學特性研究。Household electric blankets ; methods for measuring performance
家用電熱毯.特性的測量方法Also the theoretical basis of the method have been checked through simple deducing simulation and the influences of various physical parameters on the method have been studied. it is shown that the method is theoretically reliable for the production oil wells without very high production rate and is more suitable in field production for oil wells ( i ) in area with bigger geothermal gradient ; ( ii ) producing fluids ( oil and water ) with distinguish thermal characteristics ; ( iii ) producing oil with lower heat capacity or water with higher heat capacity ; ( iv ) with good surface measurement accuracy, as well as the method h as certain requirements on the accuracy of the temperature and flowmeter logs sensors
就該產出剖面方法的理論基礎進行了簡單的正演模擬和可能影響該方法的各項物理參數進行了全面的考察,結果表明,該方法對于非高產的生產油井來說在理論上是可靠的,在實際生產中適合於( 1 ) 、油井所在地區地溫梯度較大的油井; ( 2 ) 、油水熱特性差別較大的油井; ( 3 ) 、油比熱容值偏低水比熱容值偏高的油井; ( 4 ) 、井口計量精度較高的油井,並且對井溫測井和流量測井的傳感性精度有一定的要求。15. 04 test method for thermal flow and cure properties of thermosetting plastics by torque rheometer
轉矩流變儀測定熱固性塑料的熱流量和固化特性的方法The effect on display characteristic made by thermal deformations of the shadow mask is comprehensively investigated. by using the electron beam distribution automatic measurement system with a micro - deflective coil, a concave spot in luminance distribution can be get. it changes its position when the shadow mask changes its form
本文系統全面地分析了傳統蔭罩的各類熱變形對顯示屏特性的影響,利用本文研製的電子束亮度分佈自動測試系統,附加一個微偏轉磁場,使相鄰兩電子束打在同一顏色的熒光粉條,並形成一個亮度凹點,當蔭罩變形時,凹點位置作相應的位移,以此原理跟蹤測量凹點位移量,即可得到色純漂移動態變化曲線。The acquistion system is mainly used to measure the most important parameters : the heat release rate and the temperature
檢測系統主要用於測試火災中最為重要的兩個特性參數:熱量釋放率和溫度。The age hardening characteristic of as - cast cu20ni20mn and cu20ni35mn alloys and the interface characteristic between the alloy and cast tungsten carbide were studied, and on the basis of this study, composites of cu - ni - mn alloy reinforced with different volume fraction ( 0 - 45vol. % ) and different size ( 42 - 362 m ) of cast tungsten carbide particles were made by vacuum hot - pressing liquid sintering technology. pin on disk two body abrasion tests have been performed with different size of sic abrasive under different loads
本文研究了鑄態cu20ni20mn和cu20ni35mn合金的時效硬化特性及其與鑄造碳化鎢的界面特性,並在此基礎上以不同尺寸( 42 362 m )的鑄造碳化鎢顆粒為增強體,採用真空熱壓液相燒結技術制備了不同顆粒含量( 0 45vol . )的鑄造碳化鎢顆粒增強cu - ni - mn合金基復合材料;以不同粒度的sic為磨料,在不同載荷條件下利用銷?盤磨損試驗機測試了復合材料的二體磨料磨損性能。Test method for determination of fire - test - response characteristics of components or composites of mattresses or furniture for use in correctional facilities after exposure to vandalism, by employing a bench scale oxygen consumption calori
用實驗室耗氧熱量計測定遭破壞后修復設施中床墊或傢具用部件或合成材料燃燒試驗響應特性的標準試驗方法Thermal performance of building products and components - specific criteria for the assessment of laboratories measuring heat transfer properties - common criteria
建築產品和元件熱性能.試驗室測量熱傳遞性能評估的特殊標準.一般標準Methods of testing plastics - thermal properties - determination of the thermal stability of polyvinyl chloride by the conductometric method
塑料試驗方法.第1部分:熱特性.方法130c :聚氯乙烯耐熱性的電導測量方法Abstract : the hot wire anemometer and the ensemble average method are used to measure and study the dispersion turbulent transient feature in a closed cylindrical explosion bomb. the comparison of the dispersion turbulent parameters from different shapes of closed explosion bombs is presented. the relation between errors and numbers in dispersion turbulent measurement with the ensemble average metod is discussed
文摘:採用熱線風速儀和系綜平均法測定和研究了封閉圓柱形粉塵爆炸罐內揚塵湍流的瞬態特性,並與球形爆炸容器內已測定的揚塵湍流瞬態特性進行了比較,對系綜平均法用於揚塵湍流的測量誤差與測量次數的關系進行了探討。Aero - optical characteristics measurement of vortex in a low speed heated air flow
低速熱射流渦及其氣動光學特性的測量Using the microwave selective heating property for materials, by setup equivalent equation, and first time inducing the electromagnetic field perturbation theory to the design of heating materials for substrate in mpcvd, three temperature distribution modes were established, including temperature distribution comprehensive mode of inhomogeneous plasma, temperature distribution composite mode of composite substrate materials, temperature distribution perturbation mode of composite materials, which ii provided an whole new technology route to the design of substrate heating system in mpcvd and guided the preparation of heating materials for substrate. and then the heating materials for substrate were designed and optimized to obtain large area homogeneous temperature distribution even larger than substrate holder ' s diameter. as an important part, this thesis researched the nucleation and growth of diamond films in mpcvd, systematically researched the effects of substrate pretreatment, methane concentration, deposition pressure and substrate temperature etc experimental technologic parameters on diamond films " quality on ( 100 ) single crystal silicon substrate in the process of mpcvd, characterized the films qualities in laser raman spectra ( raman ), x - ray diffraction ( xrd ), scanning electron microscopy ( sem ), infrared transmission spectra ( ir ), atomic force microscopy ( afm ), determined the optimum parameters for mpcvd high quality diamond in the mpcvd - 4 mode system
該系統可通過沉積參數的精確控制,以控制沉積過程,減少金剛石膜生長過程中的缺陷,並採用光纖光譜儀檢測分析等離子體的可見光光譜以監測微波等離體化學氣相沉積過程;利用微波對材料的選擇加熱特性,通過構造等效方程,並首次將電磁場攝動理論引入到mpcvd的基片加熱材料的設計中,建立了非均勻等離子體溫度場綜合模型、復合介質基片材料的復合溫度場模型及復合介質材料溫度場攝動模型,為mpcvd的基片加熱系統設計提供了一條全新的技術路線以指導基片加熱材料的制備,並對基片加熱材料進行了設計和優選,以獲取大面積均勻的溫度場區,甚至獲得大於基片臺尺寸的均勻溫度區;作為研究重點之一,開展了微波等離體化學氣相沉積金剛石的成核與生長研究,系統地研究了在( 100 )單晶硅基片上mpcvd沉積金剛石膜的實驗過程中,基片預處理、甲烷濃度、沉積氣壓、基體溫度等不同實驗工藝參數對金剛石薄膜質量的影響,分別用raman光譜、 x射線衍射( xrd ) 、掃描電鏡( sem ) 、紅外透射光譜( ir ) 、原子力顯微鏡( afm )對薄膜進行了表徵,確立了該系統上mpcvd金剛石膜的最佳的實驗工藝參數。Test method for thermal performance of cooling - air duct sections, using a calibrated hot box
用校驗熱盒法測量冷氣管道管段的熱特性的試驗方法Measuring the cure behavior of thermosetting resins using dynamic mechanical properties
採用動態機械特性測量熱固樹脂彎曲特性For investigating thermal character changing of matter with shock compression, we need to measure the time character of radiating spectrum of matter with shock compression and its temperature, that is to measure transient time - resolved spectrum and its temperature
為了研究沖擊加載下物質熱特性的變化,需要測量沖擊壓縮態物質所發射脈沖熱輻射光譜及溫度的時間特性,即進行瞬態光譜的時間分辨測量及溫度解析。Textiles - determination of physiological properties - measurement of thermal and water - vapour resistance under steady - state conditions sweating guarded - hotplate test
紡織材料.生理學特性測定.在穩態條件下測量熱阻及水蒸汽阻The article quantitatively analyses the winter hot air ' s distribution regulation in the human work region and reveals the regulation of temperature gradient forming and change and the influence to human thermal comfort. after test research, it clarifies the thermal characteristic regulation of indoor environment in winter air condition room. the mainly characteristic regulations are the over - great vertical temperature gradient and the over - low mean radiation temperature of air condition room
本文對現有實際空調房間冬季熱射流在人體工作區的規律做出定量化分析,揭示了其溫度梯度形成變化的規律及對人體舒適的影響,經過測試研究明確冬季空調房間室內環境存在的熱特性的規律,其中房間的垂直溫度梯度過大、空調房間的平均輻射溫度較低是其主要熱特性規律。Electrically propelled road vehicles - measurement of energy performances - thermal electric hybrid vehicles
電動道路車輛.能量特性測定.熱電復式動力車Standard test method for using a cone calorimeter to determine fire - test - response characteristics of insulating materials contained in electrical or optical fiber cables
用錐形量熱計對電纜或光纜中絕緣材料的著火試驗反應特性測定的標準試驗方法分享友人