熱特性 的英文怎麼說

中文拼音 [xìng]
熱特性 英文
property, thermal
  • : Ⅰ形容詞(特殊; 超出一般) particular; special; exceptional; unusual Ⅱ副詞1 (特別) especially; v...
  • : Ⅰ名詞1 (性格) nature; character; disposition 2 (性能; 性質) property; quality 3 (性別) sex ...
  • 特性 : characteristic(s); character; performance; features; properties; behaviour; response; character...
  1. Combined heat and mass transfer by natural convection which is caused by heat and mass diffusion can be seen in nature and some processes of industry, such as evaporation and desiccation. these processes relate to aeronautics, hydraulics, mechanics, chemical engineering, oceanography and aerography

    及物質擴散引起的傳傳質復合自然對流常見于自然界和蒸發、乾燥等工業過程,涉及到航空、水利、機械、化工、海洋、氣象等諸多領域,其流體力學和傳質傳熱特性一直是人們研究的重點。
  2. This paper researches diathermancy and fluidity of condenser, evaporator, compressor, and capillary in detail. maths models of condenser, evaporator, compressor, and capillary are established and model predigesting and modifying methods are done methods are given in this paper, which can transfer the practical system into the simulating system. in the basis of refrigerating system character, components models are modified in the system administrative levels

    本文詳細研究了蒸發器、冷凝器、壓縮機和毛細管的傳熱特性和流動,建立和發展了蒸發器、冷凝器、壓縮機和毛細管數學模型,並進行了相應的模型簡化和修正方法研究,建立了從實際系統到模擬系統的轉換方法;本文針對各製冷系統的點,在系統層次上進行了部件模型的修正研究,建立了相應的修正模型和演算法。
  3. Also the theoretical basis of the method have been checked through simple deducing simulation and the influences of various physical parameters on the method have been studied. it is shown that the method is theoretically reliable for the production oil wells without very high production rate and is more suitable in field production for oil wells ( i ) in area with bigger geothermal gradient ; ( ii ) producing fluids ( oil and water ) with distinguish thermal characteristics ; ( iii ) producing oil with lower heat capacity or water with higher heat capacity ; ( iv ) with good surface measurement accuracy, as well as the method h as certain requirements on the accuracy of the temperature and flowmeter logs sensors

    就該產出剖面方法的理論基礎進行了簡單的正演模擬和可能影響該方法的各項物理參數進行了全面的考察,結果表明,該方法對于非高產的生產油井來說在理論上是可靠的,在實際生產中適合於( 1 ) 、油井所在地區地溫梯度較大的油井; ( 2 ) 、油水熱特性差別較大的油井; ( 3 ) 、油比容值偏低水比容值偏高的油井; ( 4 ) 、井口計量精度較高的油井,並且對井溫測井和流量測井的傳感精度有一定的要求。
  4. The result shows the inherence rules and degree of heat - transfer property are influenced by the substance distributions when condition is changed

    解析結果揭示了工況變化時分佈變化對傳熱特性影響的內在規律和程度。
  5. Simulation of thermal performance of ulsi interconnect system

    互連系統熱特性的模擬
  6. Copper - water pulsating heat pipe heat transfer characteristics

    水振蕩管的傳熱特性
  7. Conduction characteristics study on the head of ringed side - electrode spark plug

    環狀側電極火花塞頭部導熱特性研究
  8. The selectivity behavior becomes coupled with the heat release hehavior for this particular reaction.

    對這個具體反應來說,選擇和放熱特性關聯起來了。
  9. Review on heat transfer of subcritical carbon dioxide

    亞臨界二氧化碳換熱特性研究進展
  10. And then, on the foundation of comparing of different ways of enhancing of latent heat transfer, the way of adding fins in the lhtes was selected, and it was taken as the main research object in this paper. as a result, three different fins were designed to enhance the latent heat transfer, including circular fins, vertical fins and screw fins

    選定了相變材料后,本文通過對多種強化相變儲裝置傳熱特性方式比較分析的基礎上,確定了以添加肋片的方式作為本文中強化相變儲裝置換熱特性的主要的方式,並將其作為本實驗的主要研究對象。
  11. Electrical insulating materials - thermal endurance properties - part 4 - 3 : ageing ovens - multi - chamber ovens

    電絕緣材料.耐熱特性.第4 - 3部分:老化爐.多室爐
  12. Guide for the determination of thermal endurance properties of electrical insulating materials - electrical insulating materials - thermal endurance properties - ageing ovens - multi - chamber ovens - multi - chamber ovens

    電絕緣材料耐能測定導則.電氣絕緣材料.耐熱特性.老化爐.多室爐
  13. Methods of testing plastics - thermal properties - determination of the thermal stability of polyvinyl chloride by the conductometric method

    塑料試驗方法.第1部分:熱特性.方法130c :聚氯乙烯耐的電導測量方法
  14. The investigation on the evaporation heat transfer characteristics in a horizontal micro - fin tube for r290 - 3gs mixture shows : a ) the average evaporation heat transfer coefficient of the mixture increase with the increasing of the mass flux

    R290含油混合物在水平微肋管內流動沸騰換熱特性的實驗研究表明: a )隨著質量流率的增加,含油混合物微肋管內的沸騰平均換系數增加。
  15. The experimental results of air heat transfer show that the relative fin height, relative fin width, relative fin pitch and density of 3 - d ift with staggered arrangement fins all have an effect on heat transfer and flow friction. especially, the effect of fin density is bigger

    空氣換實驗的結果表明:肋叉排三維內肋管的相對肋高、相對肋寬、相對肋間距以及肋密度均對其對流換熱特性有影響,其中肋密度的影響較大。
  16. The experimental study on heat transfer performance of tube - and - fin radiator for vehicles

    管帶式車用散器散熱特性的試驗研究
  17. Coal - water slurry is a new type of clean fuel as a replacement for oil. this paper introduces the tests of maoming no. 2 oil - fired 220 t / h utility boiler being retrofitted to fire coal - water slurry, including slagging tendency, heat transfer performances and pollutant emissions. firstly the k - ? two - equation turbulence model is used in numerical simulation for the side - air burner, compared with the practical measures and tests, good accordance achives

    水煤漿是一種低污染、高效率、流動強的代油新型清潔燃料,本文針對廣東省茂名電廠2 #油爐改燒水煤漿示範工程,對鍋爐改造后的結渣、爐內傳熱特性和污染物的排放進行了試驗研究。
  18. Experimental study on axial wall heat conduction for steel microtube under forced convection

    過冷水環狀兩相流傳熱特性實驗研究
  19. On the basic theory of transfer heat, tribology of rolling bearings and rotor dynamics, taking gdz48a electrospindle as an example, the paper puts forward the spindle bearing ' s quasi - dynamics analysis model with the influences of the friction heat and preloadings analyzes the friction moment, velocities, contact loads, friction heat and stiffness and studies the influences of the friction heat, structure and application parameters on the speed and dynamics

    本文以傳學、滾動軸承摩擦學和轉子動力學為理論基礎,以gdz48a型電主軸為例,建立了考慮摩擦和預緊方式影響的主軸軸承擬動力學分析模型,分析了軸承的摩擦力矩、運動、載荷和剛度,研究了軸承的熱特性、設計和應用參數對速度和動力學能的影響,並進行了試驗驗證。
  20. The result of thermal analysis for coupled - cavity slow - wave structure had been achieved in the form of temperature contour figure and heat flow density vector figure

    對耦合腔慢波結構熱特性的模擬得到了以溫度分佈雲圖和流密度矢量圖方式表示的結果。
分享友人