熱致相分離 的英文怎麼說

中文拼音 [rèzhìxiāngfēnlí]
熱致相分離 英文
tips
  • 致 : Ⅰ動詞1 （給與;向對方表示禮節、情意等） deliver; send; extend 2 （集中於某個方面） devote （one s ...
  • 相 : 相Ⅰ名詞1 （相貌; 外貌） looks; appearance 2 （坐、立等的姿態） bearing; posture 3 [物理學] （相位...
  • 分 : 分Ⅰ名詞1. （成分） component 2. （職責和權利的限度） what is within one's duty or rights Ⅱ同 「份」Ⅲ動詞[書面語] （料想） judge
  • 離 : Ⅰ動詞1 （離開） leave; part from; be away from; separate 2 （背離） go against 3 （缺少） dispens...
  1. Back extraction by hno3 - hf and back extraction by concentrated hnch after lower the concentration of organic phase are studied, the method of back extration by hnorhf can not be used to icp - ms, because some zirconium is hydrolysis when hf is removed by heat. however, the method of back extraction by concentrated nitric acid after lower the concentration of organic phase can be used to icp - ms, the recovery is 93. 2 %, rsd % is 5. 24 %, the decontamination factor of uranium is 3. 2xl04, the detection limit of zirconium is 0. 04ng / ml. the method of tta extracting trace zirconium in uranium is firstly used to icp - ms, the result is satisfied, it can be used to determine zirconium in uranic production quickly and veraciously

    本文通過研究hno _ 3 - hf反萃和稀釋有機相後用濃hno _ 3反萃這兩種分離方法，認為hno _ 3 - hf反萃由於在加熱去除hf時酸度不易控制，導致鋯的部分水解，因而此方法不宜用於icp - ms中，然而稀釋有機相後用濃hno _ 3反萃法用於icp - ms測量中，全程回收率為93 . 2 ，相對標準偏差為5 . 24 ，鈾的一次去污因子為3 . 2 10 ~ 4 ，鋯的測定下限為0 . 04ng / ml ，本文首次將tta萃取分離鈾中鋯用於icp - ms測量中，結果令人滿意，此方法適用於快速、準確測量鈾產品中微量鋯。
  2. Preparation of flat sheet microporous membranes from ipp via tips for membrane distillation

    熱致相分離法制備膜蒸餾用聚丙烯平板微孔膜
  3. Aim : to analyze the mechanism, thermadynamic theoretical basis, dynamic mechanism and influencing factors of thermally induced phase separation ( tips ) in order to completely grasp the factors affecting the size, distribution and form of pores, so that the adjusted range of pore can be widened and the preparation of porous membrane can be repeated and controlled. methods : considering from the structural characteristics of tissue engineered materials, the methods of preparing porous membrane using tips technique, the hermadynamic theoretical basis, dynamic mechanism and influencing factors were analyzed, the problems and investigative directions in the future were also analyzed. tips technique is a process of phase separation of polymer homogenous solution under quenching, and it is suitable for diameter and structural form of the micropore materials prepared using tips are closely correlated with the kind and dispensing proportion of polymer attrnuant, polymer concentration and polymer molecular mass, etc. conducted, including determination of polymer - solvent system phase diagram, study of form and appearance of porous membrane of different thickness, study of form and appearance of porous membrane prepared with systems of different x, which is the parameter of polymer - solvent interaction

    目的:分析熱致相分離成膜過程的機理、熱力學理論基礎、動力學機制以及影響因素，以便充分掌握影響孔度大小、分佈、形態的因素，使孔度調控范圍得以拓寬，使多孔膜的制備能重復可控.方法:從組織工程材料結構特點出發，分析熱致相分離聚合物多孔膜的制備方法及該法成膜的熱力學理論基礎、動力學機制以及影響因素.並分析實驗中存在的問題及今後的研究方向.結果:以熱致相分離法可制備聚合物多孔膜.熱致相分離法制備多孔膜是高聚物均相溶液在淬冷條件下發生相分離的過程，它適用於上臨界共溶溫度型聚合物一稀釋劑二元體系.熱致相分離法成膜的過程，可以認為是旋節線機理佔主導地位.熱致相分離法制備的微孔材料，其孔隙率、孔徑大小、結構形態與聚合物稀釋劑的種類、組成配比、聚合物濃度、聚合物分子量等因素密切相關.結論:可採用熱致相分離技術制備多孔膜，通過改變不同的成膜條件可獲得一系列不同孔徑尺寸和孔徑分佈的多孔膜材料.對熱致相分離成膜過程中聚合物-溶劑體系的相圖測定，不同厚度的多孔膜形貌研究，不同x （聚合物-溶劑相互作用參數）體系所制備的多孔膜形貌等需深人研究
  4. The zijinshan fluid system and the gonglang fluid system were driven by the stress of extrusion nappe onto the basin and the thermal driving force of magmatism. when the fluids cycling in the basin encountered the boundary of reduction - oxidation or underwent fluid mixing, phase separating and fluid boiling caused by fault - induced pressure reducing, the physical chemistry condition abruptly changed and mineralization then took place

    在盆地兩側擠壓推覆構造應力及巖漿作用熱力驅動下，紫金山背斜和公郎弧兩大流體系統的流體在盆地中運動，當遇到氧化還原界面或遭受流體混合、相分離及斷裂導致的減壓沸騰時，因物理化學條件發生重大變化而導致成礦作用的發生。
  5. Separation is operated on normal temperature, having no chemical change occur

    常溫分離，無相變。可避免因加熱而導致的變性、結垢及材料腐蝕。
分享友人
分享到 Line

分享到臉書