熱處理膜 的英文怎麼說

中文拼音 [rèchǔlǐmó]
熱處理膜 英文
heat treating film
  • 處 : 處名詞1 （地方） place 2 （方面; 某一點） part; point 3 （機關或機關里一個部門） department; offi...
  • 理 : Ⅰ名詞1 （物質組織的條紋） texture; grain （in wood skin etc ） 2 （道理;事理） reason; logic; tru...
  • 膜 : 名詞1. [生物學] （像薄皮的組織） membrane 2. （像膜的薄皮） film; thin coating
  • 熱處理 : [冶金學] heat treatment; heat treating熱處理保護塗料 heat treatment protective coating; 熱處理車...
  1. A heat treatment to composite membrane, preferred at a 70 hot air bath for 20 minutes can improve the salt resistance of the composite membrane

    對復合膜進行適當的熱處理可以進一步改善復合膜的脫鹽性能，以70熱空氣浴， 20min為宜。
  2. At 100 to 150, both the toughness and the molecular weight decreased during the process of amination, but the transformation ratio of the amination reaction increased rapidly ; above 150, both the toughness and the molecular weight increased and transformation ratio of the amination slightly increased, and reached completely amination

    亞胺化過程中，當溫度從100升至150時，不同熱處理階段薄膜的韌性和分子量均下降，亞胺化反應轉化率上升較快； 150后，其韌性和分子量均升高，亞胺化反應轉化率上升趨于緩慢，最終達到完全亞胺化。
  3. The results indicate the stress of copper interconnects generates in the metallization and the thermal stress caused by thermal mismatch during the damascene process is the main stress. the thermal stress distribution in copper interconnects has been simulated by the finite element analysis software with the different trench structures

    對測量結果的分析得出金屬薄膜的淀積是造成銅互連線中應力的主要原因，熱應力在銅互連線應力中占較大比例，熱處理后銅互連線中應力減小。
  4. The photocatalytic activity of the samples was evaluated by the photocatalytic oxidation of nitrogen monoxide in the gaseous phase and the photocatalytic decolorization of methyl orange solution in the aqueous phase, respectively. the titania thin films on fused quartz were prepared by lpd method and then calcined at different temperatures

    用液相沉積法在石英玻璃上制備了二氧化鈦薄膜，並在不同的溫度下進行熱處理，用甲基橙水溶液的降解脫色評價二氧化鈦薄膜的光催化活性。
  5. The 3d electrons increased with the content of mn doping increasing, and the electrical property increased accordingly as the electron transport path improved. it is confirmed that all the orthorhombic perovskite phase which is formed initially at the heat treatment temperature of about 600c and thoroughly above 850c are observed in the lcmto thin film deposited on si ( 100 ) substrate by rf magneto - controlled sputtering

    確認了採用射頻磁控濺射法于si （ 100 ）基板上生長的薄膜至多在600熱處理已開始形成晶相，形成的晶相全部是正交晶系鈣欽礦相，提高熱處理溫度，薄膜中晶相含量相對增大，高於850后晶相基本形成完畢。
  6. These precursors polymerize to form polyamic acid ( paa ). the paa reacts with metal film such as copper. thus its character become worse and circuit resistance increases

    電子科技大學博士學位論文聚酚亞胺（ pi ）是薄膜多層布線的重要介質材料，它是由兩種單體在熱處理后聚合而成。
  7. The iron doped tio2 thin films showed almost no photocatalytic activity for the photodegradation of no in the gaseous phase when the calcination temperature was lower than 400 c. this was due to the fact that the phase structure of the film was amorphous. at 400 c, the film appeared obviously photoactive du

    對于用液相沉積法所制備的tio :薄膜，薄膜中的si （或fe ）含量和薄膜的厚度可通過調節前驅體濃度、溶液的ph值、基片的沉積溫度和沉積時間，薄膜的熱處理溫度和時間進行有效地控制。
  8. One is to improve the photoconductivity by annealing the mpc film under magnetic field ; the other is to form composite multi - layer film of zno / pbpc and sno / pbpc, to change the spectral response range of mpc films

    一是通過磁場熱處理提高酞菁薄膜的光電導性能；二是通過將p型酞菁與n型材料異質復合，改變光譜響應范圍。
  9. The results indicate that ( a ) before heat treatment, with the increasing of substrate temperatures, content of lower valency ( tij + ) decreases, the stoichiometric proportion of o / ti in all samples is about 2 ; the films have amorphous incompact columnar fiber structure, and with the increasing of substrate temperature, the size of columnar fiber increases ; the films have good hyalescence in visible range and great absorbability at the wavelength of 350nm ; optical constants of the films are calculated from the transmittance spectrums in visible range by mathematical analysis of the orders of interference, the results show that the refractive ind

    研究結果表明， （ a ）熱處理前，隨著基片溫度的增加，薄膜中的低價氧化鈦含量逐漸減少，化學計量比趨于o ti = 2 ；薄膜具有非晶態不緻密的柱狀纖維結構，柱狀纖維的尺寸隨基片溫度的升高而增加;薄膜在可見光范圍內透明，在波長為35onzn時嚴重吸收，利用干涉級次法分析了薄膜的光學常數，結果表明，薄膜的折射率隨基片溫度的升高而增加，根據計算結果得到了tioz薄膜在不同基片溫度下的折射率色散曲線。
  10. The results indicate : ( 1 ) the photocatalytic activity and hydrophilicity of tio2 film are affected by the factors of thickness, porosity and heat - treated temperature which lead to the changes of the hydroxyl content, adsorbability and surface roughness of the film

    熱處理溫度、薄膜厚度、孔隙率等因素對摻銀的tio :薄膜、 tioz一snoz 、 tioz一fezo3復合薄膜光催化和親水性能的影響與對純tio :薄膜的影響相似。
  11. Surface states and the topmost surface atoms of the batio3 thin films have been analyzed by x - ray photoelectron spectroscopy ( xps ) and angle - resolved x - ray photoelectron spectroscopy ( arxps ). the results show that the as - grown batio3 thin films have an enriched - bao nonstoichiometric surface layer which can be removed by ar + ion sputtering, and the atomic ratio of ba to ti decreases with increasing the depth of ar + ion sputtering

    用x射線光電子能譜技術（ xps ）和角分辨x射線光電子能譜技術（ arxps ）研究了薄膜的表面化學態以及最頂層原子種類和分佈狀況，結果顯示在熱處理過程中薄膜表面形成一層富含bao的非計量鈦氧化物層，並且鋇-鈦原子濃度比隨著探測深度的增大而逐漸減小。
  12. Effect of heat treatment on color sol - gel coating glass

    熱處理對銅系鍍膜玻璃色彩的影響
  13. Again, because the ion influx technique have a little damnification on the skin - deep structure for the cdte thin films, among the experiment, we have let the doped cdte thin films be annealed a hour with n2 atmosphere at 500, and then slowly cooled until the room temperature. via the test and analyse, heat treatment has very important effect on the comeback of crystallattice surface disfigurements. finally, the films were characterized by x - ray diffraction ( xrd ), scanning electron microscopy ( sem ), ultraviolet visible ( uv ) and the hall effect measurement

    再次，由於離子注入會對薄膜表面的結構造成損傷，本實驗把被注入離子的cdte薄膜在n2氣氛中500下退火1個小時，然後緩慢冷卻至室溫。經測試分析，熱處理對晶格表面缺陷的恢復有很重要的作用。最後，利用xrd 、 sem 、紫外可見分光光度計及hall測試系統研究其結構，表面形貌和光電性能。
  14. Microcracks and stresses will appear if the dropping speed, aluminum content and dropping cycles are too high. high temperature heat - treatment can eliminate and help to obtain compact thick film

    當提拉速度、溶膠濃度和鍍膜次數較大時膜內易出現微裂紋和脫落等缺陷， 550熱處理5h可以消除缺陷，獲得緻密厚膜。
  15. We have developed many treatment equipment covering vacuum aluminum plating, decorative plating film, hard film plating, ion injection, vacuum winding film plating, and vacuum thermal treatment equipment, forming 12 large series including over 50 specifications and types

    先後開發了真空鍍鋁裝飾鍍膜工具硬質鍍膜及離子注入真空卷繞鍍膜和真空熱處理設備。已形成12大系列， 50餘種規格型號。
  16. A tio2 layer prepared by dipping in the stable tio2 sol was deposited on the surface of etched aluminum foils. after heat treatment, the composite oxide films were prepared by a normal formation

    將鋁腐蝕箔在此穩定的溶膠中浸漬處理，高溫熱處理后將其陽極氧化，得到復合氧化膜。
  17. The aim of the thesis was that the pure cdte thin films were adulterated by the influx technique with different metals, and then we have investigated its configuration and photoelectricity after the anneal treatment

    目前，用離子注入的方法在cdte薄膜中摻雜的文獻報道的很少。本工作目的就是採用離子束注入的方法對純cdte薄膜進行不同金屬元素的摻雜及熱處理，研究其結構和光電特性。
  18. In the uv light region, the absorption dramatically increases that is caused by the absorption of the films substance, hi addition, as the heat treatment temperature increases the absorption threshold slightly occurs " red shift "

    在紫外區，薄膜的吸光度急劇增大，而且，隨著熱處理溫度的增加，吸收閾值發生輕微的「紅移」 。這種降低是由於薄膜物質的吸收所致。
  19. The techniques of preparing film buffer layers on si were studied. the sem, tem and xrd were adopted to study the crystal structure of films. the influences of buffer layers, substrate and heat treatment condition on the crystal structure and performance of the ybco films were discussed

    進一步用掃描電鏡、透射電鏡和x射線衍射儀研究了薄膜組織結構和結晶情況，分析了緩沖層和襯底對ybco薄膜制備的影響、以及不同熱處理條件對薄膜結晶結構及性能的影響。
  20. Revolving furnace for diaphragm spring

    膜片彈簧熱處理
分享友人
分享到 Line

分享到臉書