燃料供給過量 的英文怎麼說
中文拼音 [ránliàogōnggěiguòliáng]
燃料供給過量
英文
overfueling- 燃 : 動詞1. （燃燒） burn 2. （引火點著） ignite; light
- 料 : 名詞1 （材料; 原料） material; stuff 2 （喂牲口用的穀物） feed; fodder 3 （料器） glassware 4 （...
- 供 : 供Ⅰ名詞1 （供品） offerings 2 （口供; 供詞） confession; deposition Ⅱ動詞1 （供奉） lay （offerin...
- 給 : 給Ⅰ動詞1 （送對方某物; 使對方得到） give; grant 2 （用在動詞后 表示交與 付出） pass; pay 3 （叫; ...
- 過 : 過Ⅰ動詞[口語] （超越） go beyond the limit; undue; excessiveⅡ名詞（姓氏） a surname
- 量 : 量動1. （度量） measure 2. （估量） estimate; size up
- 燃料 : fuel
- 過量 : excessive; overdose; surfeit; excess; overmeasure; overage; bellyful
-
By adjusting the fuel rectifying screw and then increasing the fuel quantity per cycle, the loss of the maximum power of e30 engine ca n ' t exceed 10 % of the maximum power of diesel, and the loss of the maximum torque can be controlled within 2 percent
通過旋出油量校正螺釘，增大燃料供給量，可以使e30混合燃料發動機的最大功率損失控制在10以內，最大轉矩損失控制在2以內。Based on the the mass experimental data, taking advantage of electronic control technology, a set of diesel / cng dual fuel supply system is developed and the control of cng supply for turbocharged diesel engines is primarily realized. this thesis introduces the development of this electronic control system in detail, including the structure of hardware, the module of software and the control style
在實驗室大量實驗數據的基礎上，採用電子控制技術，自行開發設計了一套柴油cng雙燃料供給系統，初步實現了在增壓發動機上對cng摻燒的控制。論文詳細介紹了該雙燃料電控系統的研製過程，包括硬體結構、軟體模塊以及控制方式。Characters including : fuel atomization device replaced by gas sprayer, gas supply controlled by gas flux valve ; separate fuel supply from combustion - supporting air, regulate air supply through changing the electioneering voltage to make the fully burning and improve efficiency and reduce fuel consume ; arts and crafts are simple, the modification of the oil heater ' s configuration is little and the heating power is not below the oil heater ' s level ; because of falling the voltage of electioneering, greatly descend the noise of the sample machine compared with the original
其特點是：以燃氣噴頭替代原機燃油霧化裝置；以燃氣流量控制閥控制燃氣的供給；燃氣的供給與助燃空氣的供給相分離；通過改變主電機的電壓，調整空氣的供給量，使燃燒更加充分完全，並進一步提高了熱效率，降低了燃料消耗；工藝簡單，對原機型改動較小；樣機的加熱功率不小於原機型水平；此外，由於主電機電壓的降低，使樣機的整機噪聲比原機大大下降。
分享友人