燃點測試器 的英文怎麼說

中文拼音 [rándiǎncèshìqì]
燃點測試器 英文
ignition tester
  • 燃 : 動詞1. （燃燒） burn 2. （引火點著） ignite; light
  • 點 : Ⅰ名詞1 （液體的小滴） drop （of liquid） 2 （細小的痕跡） spot; dot; speck 3 （漢字的筆畫「、」）...
  • 測 : 動詞1. （測量） survey; fathom; measure 2. （測度; 推測） conjecture; infer
  • 試 : 名詞（古代占卜用的器具） astrolabe
  • 器 : 名詞1. （器具） implement; utensil; ware 2. （器官） organ 3. （度量; 才能） capacity; talent 4. （姓氏） a surname
  • 燃點 : 1 （點著） ignite; kindle; set fire to; light2 [化學] ignition point; burning point; kindling poi...
  • 測試 : test; testing; checkout; measurement
  1. This paper discusses the designing and making of the dynamic testing systems of engine electronic control system. base on the construction and operation principle of santana 2000gsi m3. 8. 2 engine electronic control systems, design and manufacture led circuit of dynamic testing and fault imitating electronic control unit. on the inspect board, design and equip with motronic 3. 8. 2 ecu i / o measuring joints, design and set up obd - ii diagnostic communication link, design and install fuel pressure inspecting meter. depend on the obd - ii diagnostic communication link and ecu i / o measuring joints, this dynamic testing system can inspect engine electronic fuel injection system, distributorless ignition system, idle speed control system and evaporative emission control system, and can inspect m3. 8. 2 sensors, ecu and actuators, and can interrogate fault memory and erase fault memory ; and can analyse data stream ; and can carry out fault imitating. besides, this paper analyses sensors and actuators typical fault w aves

    2電控單元電路連接器設計製成輸入輸出電子控制檢測端子，並在檢測面板上布置了obd -診斷插座和燃油壓力表。使該動態測試系統能實現對電噴發動機的燃油系統、直接點火系統、怠速控制系統和燃油蒸氣排放控制系統的動態檢測；並通過obd -診斷座、 ecu輸入輸出檢測端子和故障模擬處理單元實現對電噴發動機電控系統各傳感器、電控單元、執行器進行故障碼讀取與清除；動態數據讀取和波形測試和故障模擬等。此外，本論文還分析了傳感器和執行器典型故障波形。
  2. Long - hole and geometrical proportion type of mixing unit is finally adapted in lpg supply system, and power and torque output of lpg engine are improved by increasing compression ratio, and ignition characteristic is tried to adjusted to satisfy engine performance. meantime emission performance and noise level of lpg engine at full - throttle and other various part - throttle operations are tested and compared with former gasoline engine. ( 3 ) it is verified by engine dyno tests that lpg engine has better synthesized performance at aspects of power and torque, fuel economy, as well as emission than former gasoline engine

    選擇了等比例長孔式混合器控制空燃比；通過提高壓縮比來彌補動力性的損失；以動力性為主控目標，對最大功率點、最大扭矩點、中等轉速、最低轉速點所對應的發動機轉速做了點火特性的調節；通過空燃比的合理控制，直接改善發動機的動力性、經濟和排放指標；作為對缸內燃燒過程的理論分析，進行了燃燒特性的實驗測試；對原汽油機和新開發的液化石油氣發動機，進行了外特性和部分負荷特性以及怠速的排放及噪聲對比性測試。
  3. Analysis of experimental data indicates that there exist several following problems during the whole operation : first, the emission is serious and the density of hc and co smoke is very high at on and off period. second, there is oil dripping from the dripping vitta as a result of the fault of ignition system and combustion structure. the last, there might be accidents of disabled ignition resulted from the improper operation at the beginning

    通過對樣機的試驗分析和研究表明，汽車空氣燃油加熱器在整個工作過程中，其排放存在以下三個問題：一、開機和關機兩個階段的排放問題嚴重，廢氣中hc和co的濃度值及煙度測量值都很高；二、因點火系統和燃燒結構的缺陷而導致開機后一段時間內有油滴從滴油管滴落；三、在點火過程中，會出現因操作不當而點火失效的現象。
  4. The modified varieties, characteristics and standards of the determination and technique of flame retardant nylon engineering plastics are described, putting stress on the characteristics of environmental protection and halogen - free flame retardant nylon, and the materials widely used in electronics and apparatus industry, which is significant for the selection of materials in the design at electronic products

    摘要敘述了阻燃聚酰胺工程塑料的改性品種、特點以及測試分析和技術標準，特別敘述了環保和無鹵環保型阻燃聚酰胺的特性，電子電器行業中應用廣泛的重要原材料，對電子電器產品設計過程中的合理選材意義重大。
  5. With the rapid development of computational fluid dynamics and combustion theory, applying the computer to numerically simulate the complicated processes in the plasma ignition is possible. using numerical simulation can estimate the parameters which are not essay to measure and not doing so many experiments can improve its reliability and reduce the cost. so numerical simulation is a new pattern way to study the inner mechanism of the plasma ignition

    隨著計算流體力學和燃燒理論的發展及計算機的廣泛應用，用數值模擬等離子點火器內部燃燒系統流動、傳熱、傳質、化學反應等復雜的過程已成為可能。應用數值模擬的方法可以對實驗難以測量的量進行預估，而不需要大量的試驗，應用數值模擬的方法來解決等離子點火器燃燒性能的分析和工程設計，有利於提高工作的可靠性和經濟性。
  6. It has been shown that this updated sampling and measurement method, which can measure the content of tar and dust individually, appears much more precise and credible, particularly aiming at the characteristic of heavy tar and dust content in biomass gas. this clarification system that adopts two - level shell and tube condensers and one tar removal filter, has the advantages of high removal efficiency ( 97 % ~ 98 % ) and low operating cost. besides, it has been made more environmentally friendly considering that wastewater from condensers has measured up to related effluent state standards after being disposed in tar clarifier - tank

    多次試驗表明：針對生物質氣浙江大學碩士學位論文含焦油灰塵量大的特點，改進的生物質焦油取樣測量法可實現焦油和灰塵的分離，有較高準確性和可靠性；採用二級管殼式冷凝器與一級乾式過濾器結合的燃氣冷凝凈化系統不但凈化效率高（ 97 98 ） 、運行費用低，而且含焦油廢水二經過澄清池澄清處理后可達到國家相關污水排放標準，避兔了濕式凈化系統的水污染；兼顧凈化效果、經濟性和減少污染考慮，採用以半焦為吸附材料的于式凈化系統可以達到炊用燃氣對焦油含量的要求。
分享友人
分享到 Line

分享到臉書