燒失量 的英文怎麼說
中文拼音 [shāoshīliáng]
燒失量
英文
ignition loss-
The gravimetric method for the determination of loss on ignition
重量法測定燒失量Methods for chemical analysis of spodumenite and lepidolite concentrates - the gravimetric method for the determination of loss on ignition
鋰輝石，鋰雲母精礦化學分析方法重量法測定燒失量But the temperature difference at the vertical direction in combustion chamber in lead column, that is said by operator, is over 60 ?. ( 2 ) according to the experiences in the practice, the second layer air and the second layer gas had a little effect of support burning, and the third air has little effect for combustion, and the power to drawing exhaust gas can only be adjusted in limited range. the problems, it is said above, restricted more advance of some kinds of technology and economy target in spelter refining in new jersey furnace
由於鋅精餾爐產量提高，一些問題開始暴露出來： （ 1 ）燃燒室?舶要求溫度差不超過10 ，而從現場反映的情況來看，燃燒室上、中、下部溫度差已超過60 ； （ 2 ）在生產實踐中，發現燃燒室第二層空氣、第二層煤氣作用甚小，第三層空氣失去助燃作用，廢氣出口的抽力可調范圍有限；以上這些問題在客觀上制約了精餾塔在鋅精煉中各項技術經濟指標的進一步提高。Analysis of experimental data indicates that there exist several following problems during the whole operation : first, the emission is serious and the density of hc and co smoke is very high at on and off period. second, there is oil dripping from the dripping vitta as a result of the fault of ignition system and combustion structure. the last, there might be accidents of disabled ignition resulted from the improper operation at the beginning
通過對樣機的試驗分析和研究表明，汽車空氣燃油加熱器在整個工作過程中，其排放存在以下三個問題：一、開機和關機兩個階段的排放問題嚴重，廢氣中hc和co的濃度值及煙度測量值都很高；二、因點火系統和燃燒結構的缺陷而導致開機后一段時間內有油滴從滴油管滴落；三、在點火過程中，會出現因操作不當而點火失效的現象。Magnesite - chrome refractories - determination of loss content on ignition - gravimetric method
重量法測定灼燒失量Mean while, the iouver concentrator structure principle is analyzed, the iouver puiverized coal concentrator is studied on the bases of both laboratory and production. lt is discovered from the experiments that the louver horizontai rich / lean combustion pulverized coal burner has advantages of simple in structure, low resistance and adjustment of pc concentration
同時，重點分析了百葉窗濃縮器的結構原理，並在試驗臺上和現場對百葉窗煤粉濃縮器進行了大量的試驗研究，結果表明：百葉窗式水平濃淡煤粉燃燒器具有結構簡單、阻力損失小、分離調節方便等一系列優點。The gravimetric method for the determination of loss content on ignition
重量法測定灼燒損失量Methods for chemical analysis of tungsten - the gravimetric method for the determination of loss content on ignition
鎢化學分析方法重量法測定灼燒損失量Phosphate rock and concentrate - determination of loss on ignition - gravimetric method
磷礦石和磷精礦中灼燒失量的測定重量法Methods for chemical analysis of bauxite - determination of the loss on ignition - gravimetric method
鋁土礦石化學分析方法重量法測定燒失量Lass on ignition ( loi ) is a simple, inexpensive method widely used to measure contents of organic and inorganic carbon in lake sediments
摘要燒失量分析是一種便捷的測定湖泊沉積物有機碳與碳酸鹽含量的方法。Special products for hydraulic concrete constructions. synthetic resin or hydraulic binder based products. fire loss at 450 degrees celsius and ash content at 950 degrees celsius
水硬性混凝土建築用特殊產品.合成樹脂或水凝基製品. 450時燒失和950灰份含量Determination of the loss on ignition - gravimetric method
重量法測定燒失量Ascharite ores - determination of loss on ignition - gravimetric method
硼鎂礦石中灼燒失量的測定重量法Limestone for chemical industry - determination of content of loss on ignition - gravimetric method
化工用石灰石中灼燒失量的測定重量法Ignition loss : burn the test sample at 1000 c to sapecified quantity and measure the reduction
燒失量：將試樣於1000度溫度灼燒1小時之減量。Chemical analysis methods of aluminium hydroxide - determination of the loss of mass at 1100 c - gravimetric method
氫氧化鋁化學分析方法重量法測定灼燒失量Test methods of crystalline layered sodium disilicate - gravimetric methods for determination of the loss on ignition
層狀結晶二硅酸鈉試驗方法重量法測定灼燒失量Through observing the interface of porosity hap sintered at 1050, the gradient changing of pore size was observed that was like gradient structure of bone. in the compact layer there were a few about 50 y mpores and many about 5um micropores. in the porous layer there were many about 500um pores
緻密層存在少量的尺寸為50 m左右的氣孔和大量的尺寸為5 m左右的微孔，這是原料中殘留有機物燒失以及粉末顆粒燒結不緻密形成的；多孔層存在大量的尺寸為500 m左右的大孔，這是檸檬酸造孔劑燒失形成的，在大孔之間存在一些約50 m 、 100 m的氣孔。Textile glass reinforced plastics - determination of void content - loss on ignition, mechanical disintegration and statistical counting methods iso 7822 : 1990 ; german version en iso 7822 : 1999
玻璃纖維增強塑料.孔隙率的測定.燒失量機械粉碎和分享友人