爐料性狀 的英文怎麼說
中文拼音 [lúliàoxìngzhuàng]
爐料性狀
英文
behaviour of burden-
According to finite element segmentation principle, by combining test with observation, the author has measured the air streamline and speed distribution of burning equipment in dally situation, which provides some guide for research of air field in hearth on cold and hot conditions. and the law is found of air speed distribution by measuring its speed and distribution of upper and lower deck on cold condition, thus it lays the foundation for analysis on hot condition. under four burning states, we measure the air speed in single, double - deck, and find out its corresponding distribution law
5 .根據有限元分割原理布置測點，採用降溫方法，用k五江9106等儀器分別測出單雙爐排燃燒方式4種不同工況下，該燃燒設備爐膛內coz 、 02 、 co氣體濃度，並找到了隨爐膛高度方向及深度方向變化規律;從燃燒原理分析評價了2種燃燒方式爐膛內coz 、 02 、 co氣體濃度場分佈特點及相應燃料層內乾燥、干餾、氧化、還原、灰渣層厚度，肯定了雙層爐排燃燒方式爐膛中c02 、 02 、 co氣體濃度場分佈合理性，從燃燒理論找出了最佳濃度場分佈狀態及燃料層內各反應層厚度。Abstract : the air / fuel ratio control scheme in common use of boiler auto - burning system is introduced summary. two kinds of scheme improved to obtain the best air / fuel ratio and to raise dynamic characteristic are analyzed in particular. further how to correct measures on air / fuel ratio when changing boiler load and fuel composition is proposed and analyzed
文摘:對鍋爐自動燃燒系統中空氣/燃料比控制的常用方案進行了簡要介紹，著重分析了兩種為獲取最佳空氣/燃料比和提高控制系統動態特性而採取的改進方案，並針對鍋爐負荷變化和燃料特性改變對燃燒狀況的影響，進一步對空氣/燃料比的修正措施進行了分析與探討，提出了綜合修正方案。The influence of nano - al2o3 on the sintering and the properties of the si3n4 ceramics was researched in this paper. the samples with different amount of nano - al2o3 were obtained by using pressureless sintering at 1600, 1650, 1700 in the nitrogen atmosphere. the microstructure and the composition of the ceramics were determined by the means of x - ray, sem, micro - hardness meter etc. it is show that the sisty ceramics can be densified at 1650c to % percent of the theory density through the addition of nano - al2o3 ( the value could be 90 percent by other technique ). the crystalline growth of the cylindrical - si3n4 and the ratio of its longitude to its diameter are increased with the addition of nano - al2o3. a uniform microstructure and an fined crystal as well as more sialon phases can be obtained in the si3n4 ceramics through the addition of that
實驗結果表明：在碳管爐中、氮氣保護下進行燒結，添加劑為納米al _ 2o _ 3粉末時，由於納米粉末的高活性、高燒結驅動力，在1650就可使si _ 3n _ 4完全地燒結，並使其緻密度可達理論密度的96以上（比其它工藝高6左右） ；同時，納米al _ 2o _ 3地加入大大促進了長柱狀? si _ 3n _ 4的生長和發育及柱狀晶長徑比的提高，使微觀結構均勻、細化，形成了更多力學性能優異的固體? sialon相，減少了不利於陶瓷材料性能的晶間玻璃相，凈化了晶界。Boiler combustion efficiency is improved due to the retrofit for burner material, air flow adjustment mechanism and air direction of entering burner, and cold and hot commissioning
通過對燃燒器材料、調風機構、進風方式及調節等方面進行改造，並經過冷、熱態調試后， # 1鍋爐燃燒狀況得到改善，經濟性得到提高。Abstract : in accordance with the current thermotechnical behaviors of domestic tunnel kilns using different firing fuels, such as thermal utilization ratio and energy consumption per kilogram of porcelain, the influence of various firing fuels properties and fuel system ' s installation etc, on the kiln ' s thermotechnical behavior has been analysed in this paper. it is demonstrated that clean gaseous fuels and light oil are high quality fuels for the production of top grade fired products
文摘:從國內現有使用不同燃料的陶瓷隧道窯的熱能利用率、千克瓷能耗等熱工性能的現狀，分析了各種燃料的燃燒性能及不同的燃燒系統設置對窯爐熱工性能的影響，認為潔凈的氣體燃料和輕油是生產高檔產品的優質燃料。The occurrence, mineral composition and constructure of titanium in solidified slags which are obtained from blast furnace slags via selective precipitating and growth have been studied, and the contribution of titanium among different mineral phases has been calculated by optical microscope, x - ray diffraction ( crd ) as well as scanning electron microscope ( sem )
本文採用光學顯微鏡、 x射線粉晶衍射、圖象分析和掃描電鏡等多種手段，研究了攀鋼含鈦高爐渣經選擇性析出處理的凝渣中鈦的賦存狀態、礦物組成及結構，計算了鈦在各礦物相中的分佈，測定了原料中鈦礦物的解離度，為鈦的綜合利用提供了科學依據。Abstract : the occurrence, mineral composition and constructure of titanium in solidified slags which are obtained from blast furnace slags via selective precipitating and growth have been studied, and the contribution of titanium among different mineral phases has been calculated by optical microscope, x - ray diffraction ( crd ) as well as scanning electron microscope ( sem )
文摘:本文採用光學顯微鏡、 x射線粉晶衍射、圖象分析和掃描電鏡等多種手段，研究了攀鋼含鈦高爐渣經選擇性析出處理的凝渣中鈦的賦存狀態、礦物組成及結構，計算了鈦在各礦物相中的分佈，測定了原料中鈦礦物的解離度，為鈦的綜合利用提供了科學依據。分享友人