球粒劑 的英文怎麼說

中文拼音 [qiú]
球粒劑 英文
globular powder
  • : 名詞1 (以半圓的直徑為軸 使半圓旋轉一周而成的立體; 由中心到表面各點距離都相等的立體) sphere; glo...
  • : Ⅰ名 (小圓珠形或小碎塊形物) small particles; grain; granule; pellet Ⅱ量詞(用於粒狀物)
  • : Ⅰ名詞1 (藥劑; 制劑) a pharmaceutical or other chemical preparation 2 (某些有化學作用的物品) a...
  1. Use forceps to dip the cotton ball into antiseptic lotion and wipe the wound from inside to outside. repeat the procedure using a new cotton ball each time until the wound is clean

    4 )用鉗夾起沾了適量洗的棉,由內而外的方向拭抹傷口,每一用一次,重復此步驟,直至傷口清潔為止。
  2. 4 use forceps to dip the cotton ball into antiseptic lotion and wipe the wound from inside to outside. repeat the procedure using a new cotton ball each time until the wound is clean

    4用鉗夾起沾了適量洗的棉,由內而外的方向拭抹傷口,每一用一次,重復此步驟,直至傷口清潔為止。
  3. A series of near roundness cds nanoparticles with a particle diameter of 3 ~ 6nm have been prepared by controlling the concentration and proportion of reactants and adopting sodium hexametaphosphate as stabilizing agent. the studies demonstrate that these particles present obvious quantum size effect and an appropriate excess of cd2 + ion and hexametaphosphoric acid group polysnion are helpful to the dispersion and flame capability ' s improvement of particles. another series of near roundness monodisperse au nanoparticles with a diameter of 12. 3nm was prepared via sodium citric acid deoxidizing auric chloride acid

    利用六偏磷酸鈉作為穩定,通過控制反應物的濃度及比例,制備了徑為3 6nm 、呈近似形的cds納米顆,光譜測試結果表明,顆具有明顯的量子尺寸效應,適當過量的cd ~ ( 2 + )離子以及六偏磷酸根聚陰離子有助於顆的分散並提高其發光性能;採用檸檬酸鈉還原氯金酸,制備了接近形、平均徑約為12 . 3nm的單分散體系au納米顆;採用wessling的前驅聚合物法獲得導電聚合物ppv前驅體。
  4. The raw materials, the composition, the time of milling, the calcining temperature, the different additives, the sintering temperature and the sintering parameters were investigated. the result showed : it was advantaged to obtain high initial permeability mnzn ferrite with stable frequency characteristic using high - purity raw materials ; in order to obtain mnzn ferrite with high properties, we must control strictly the composition ; it could improve the properties of mnzn ferrite by optimizing calcining temperature. the lower calcining temperature made the permeability higher, and the higher calcining temperature could promote the frequency characteristic of permeability ; we chosen the right time of milling according to the requirement of power diameter ; in order to improve the properties of mnzn ferrite, it is necessary to add effective additives. in this dissertation, the influence of bi2o3 、 moo3 、 k2co3 、 co2o3 were investigated ; the sintering temperature, the time of heat - retaining and sintering parameters were the key factors of preparing high permeability mnzn ferrites

    研究結果表明:採用高純度的fe2o3有利於獲得高起始磁導率且頻率特性優良的鐵氧體;為了制備所需性能的鐵氧體,需要嚴格控制配方中各種原材料的含量,優化配方;由於粉體活性受預燒條件的影響,所以對不同要求的鐵氧體選擇的預燒條件就不一樣,適當降低預燒溫度有利於獲得較高的起始磁導率,而為了獲得良好的頻率特性可以適當地提高預燒溫度;根據對粉體顆徑的不同需求,可以選擇不同的磨時間;而有效的添加是改善材料性能的必要條件,本文在添加的研究中主要對bi2o3 、 moo3 、 k2co3 、 co2o3的影響分別作了詳細地討論;燒結溫度、保溫時間和燒結氣氛是高磁導率mnzn鐵氧體制備最關鍵的工藝,適宜的燒結工藝可以獲得理想微結構和組成,從而得到高性能的鐵氧體材料;而從材料的微結構上來看,要提高材料的截止頻率,就要適當地細化晶、增加晶內部的氣孔。
  5. Under these conditions co3o4 nano - particles with average diameter of 22nm were obtained. influences of disperants on preparing co3o4 nano - particles were studied, and tg - dta, xrd, tem and ir absorption spectra were used to characterize the samples. the results showed that shapes and sizes of co3o4 nano - particles could be controlled and modified by dispersants. the diameter was about 20nm when peg ( 40mg / ml ) was used as dispersants, while the diameter was 10nm and the length is 0. 2um for paana ( 15mg / ml )

    其中,利用peg制備的納米co _ 3o _ 4子分散性稍差,當peg的用量為40mg ml時,可以獲得平均徑為20nm左右的形納米co _ 3o _ 4微粉;以聚丙烯酸鈉作為分散可更好地控制納米子的形狀和大小,其用量為15mg ml左右時,可得到平均徑為10nm 、長為0 . 2 m的鏈狀納米co _ 3o _ 4微粉。
  6. In this paper, select li 3 # and grease 7014 as basis grease. select nano diamond and sio _ 2 are selected as additives, design 14 recipe using k and l10 as appraise norm study the dose of nano particle to the effect of contact fatigue of ceramic and steel friction has the conclusion that proper quantities nano particle which put in two grease can improve the contact fatigue life of ceramic using sem and edax, nano particles fatigue resistance mechanism are analyzed. which can improve the contact fatigue life of ceramic and steel friction

    本文選用3 #通用鋰基脂和7014號寬溫航空潤滑脂作為基礎脂,選取納米金剛石粉和納米二氧化硅微作為添加,設計了14種配方。利用威布爾斜率k和額定壽命l10作為評價指標,研究了納米微的用量對陶瓷/鋼副的接觸疲勞壽命的影響,得出在所選兩種基礎脂中添加合適用量的納米微添加可以提高陶瓷的接觸疲勞壽命。利用sem和edax ,初步揭示了納米微提高陶瓷/鋼副滾動接觸疲勞的機理。
  7. Ps - mpm was prepared by improved microsuspension polymerization. product structure, particle size and magnetic properties, were characterized and the reaction mechanism was analyzed. such influencing factors as the indissoluble assistant, the dispersant agent, the surfactants, the amount of initiator and the stirring speed were surveyed

    本文採用了一種難溶助,用改進了的微懸浮聚合法制備出了聚苯乙烯磁性高分子微,對產物進行了結構、徑、磁性能的表徵,分析了反應機理,並探討了難溶助、分散、表面活性、引發用量、攪拌速度等因素對磁性高分子微性能的影響。
  8. The effect of shenyanling granule for the lipid metabolism in patients with chronic idiopathic glomerulonephritis

    腎炎靈顆對慢性原發性腎小疾病脂質代謝的影響
  9. Under the condition of 1000 ~ 1200, study the effect of the carbon - bearing pellet strengths and metallization rate with different iron ore concentrate size, matching carbon ratio ( carbon oxygen mol ratio ), kind of additive and reduction temperature

    摘要在1000 ~ 1200條件下研究了不同的礦粉度、配碳比、粘結、還原溫度等對含碳團強度及金屬化率的影響。
  10. In this paper, functional kefir yogurt starter was produced by lactococcus and lactobacillus isolated from kefir grains

    摘要本文利用開菲爾中分離的乳菌和乳桿菌採用混合發酵法研製開菲爾酸奶復合發酵
  11. The purity and composition uniformity were very high, and the specific surface area was 67 - 156 nm. in the third part, surface modification of sn - in2o3 nano particle was studied and some conclusions were drawn finally. kh560 and kh570 were selected as surface modification agents, and the concentration of them was 0. 5 - 1 wt %, and ph value was controlled for 5. 4, and the best milled technology were 72 hours

    本文第三部分,結合丙烯酸酷類單體,對sn一inz仇納米微進行表面修飾研究,最後得出選用kh一560和kh一570作表面修飾,添加量為0 . 5一lwt %左右, ph值為5 . 4左右,採用磨72小時,輔助超聲分散工藝時, sn一in20 :納米粉的分散性較好,且與基體有較好的相容性。
  12. It was showed that mipm between 50 - 300 ? m with macro - pores could be prepared via both seeds swelling and suspension polymerization method and suspension polymerization method, the former method could prepared the mipm with narrower size distribution while the later one was easier to carry out and more time - saving. the morphology of the mipm was influenced by many factors including swelling solvent, stirring speed, dosage of seeds, dispersant, dilute and progenic solvent

    M的、具有大孔結構的mipm ,前者的產物具有相對較窄的徑分佈,但後者的制備工藝則較簡單、制備周期也較短;溶脹、攪拌速度、種用量、分散、稀釋和致孔是影響產物微形態的主要因素;乳液聚合法能夠制備得到0 . 16 - 0 . 56
  13. Monodisperse ( coefficient of variation 5 % ) polystyrene microspheres in the size range of 1. 0 ~ 10 m are prepared by dispersion polymerization in ethyl alcohol reaction media using polyvinylpyrrolidone ( pvp ) as a steric stabilizer and 2, 2 ' - azobisizobutyronitrile ( aibn ) as an initiator in suitable condition

    摘要以聚乙烯吡咯烷酮為分散、無水乙醇為反應介質、偶氮二異丁腈為引發,採用分散聚合的方法,通過優化反應條件,成功制備出了徑范圍為1 ~ 10 m不同徑級別的單分散(分散系數5 % )聚苯乙烯微
  14. The effect of these parameters on the variation of final particle size and size distribution, the morphology, magnetic content and magnetic response were investigated in detail

    另外,磁性復合微徑大小及單分散性還與體系中存在的表面活性含量及磁流體含量密切相關。
  15. Silicon dioxide spherical particles are widely used in many fields of advanced technology, such as photonic crystals, catalyst supports, chromatographic packing materials and standard materials in measurement etc. in this article, micrometer sio2 spherical particles were synthesized by polymerization - induced colloid aggregation process

    由於二氧化硅形顆在光子晶體、催化載體、色譜填料、標準計量等許多高新技術領域有著非常廣泛的應用前景。本文用聚合誘導膠體團聚法制備介孔二氧化硅形顆,並對其形成機理及制備條件進行了詳細研究。
  16. On the basis of preparing powders with usual technological parameters of thermal spray, the influences on powders properties of ball milling time, assistant reagents of ball milling and conditions of heat treatments are discussed, and then it comes to the optimal preparation project

    在採用常規熱噴塗工藝參數進行粉末制備的基礎上,討論了磨時間、磨助、熱處理條件對粉末性質的影響,得出最佳的制備方案。該方法可以制備出度分佈均勻、性質穩定,度為200 500nm的超細銅鋅粉末。
  17. It is a kind of globular granule primary made of high - purity silicon powder and silicasolm, provided with resistance to water, high strength, high activity and long life

    遇水不裂硅膠(硅大)是以高純度硅粉和硅溶膠為主要原料而製成的形顆,克服了硅膠遇水都會爆裂的弱點,具有耐水、高強度、高活性、所制備的催化壽命長的特點。
分享友人