界面應力 的英文怎麼說

中文拼音 [jièmiànyīnglì]
界面應力 英文
interfacial stress
  • 界 : 名詞1 （相交的地方; 劃分的界限） boundary 2 （一定的范圍） scope; extent 3 （按職業、工作或性別等...
  • 面 : Ⅰ名詞1 （頭的前部; 臉） face 2 （物體的表面） surface; top 3 （外露的一層或正面） outside; the ri...
  • 應 : 應動詞1 （回答） answer; respond to; echo 2 （滿足要求） comply with; grant 3 （順應; 適應） suit...
  • 力 : Ⅰ名1 （力量; 能力） power; strength; ability; capacity 2 [物理學] （改變物體運動狀態的作用） forc...
  • 界面 : [物理化學] interface; boundary; limiting surface
  1. Abstract : for analyzing the residual stress distributing state within the weld joint, and its effect on the performance of welding structure, when welding the ferrite pearlite steel with the austenite steel, this paper develops a finite element program to compute the interface stress of two or over two material. finally, this program is used to analyze the mechanical behavior of heterogenic joint

    文摘:為了分析鐵素體、珠光體類鋼與奧氏體類鋼焊接時，焊接接頭處焊接殘余應力的分佈狀態及其對焊接構件性能的影響，研製了可計算兩種或兩種以上材料界面應力的有限元程序，並用此程序分析了異質接頭的力學行為。
  2. The study indicate that the surface form has no effect on kl, but has obvious effect on kll, and will affect the breaking angle and mode ; in finite plate, the boundary condition has effect on the sif and the k is bigger than in infinite plate ; the effect of the distance and the angle between cracks are all have obvious effects on the multiple crack interaction, and the interactions between cracks also have obvious effects on the sif, which can be neglect only when the distance is bigger enough

    研究表明：裂面狀態對k _的大小沒有影響，而對k _的影響卻很大，相同應力條件下，裂面狀態會影響裂紋的開裂角和開裂方式；有限板的邊界對應力強度因子有一定的影響，其k比無限板中的k略大；裂紋間的距離、夾角等因素對裂紋間的干涉效應均有較大影響，裂紋間的干涉效應對應力強度因子的影響非常顯著，只有當裂紋間的距離充分大時，干涉效應才可忽略。
  3. Here, fem is applied in the analyses of i ) fiber axial stress and interphase shear stress in fragmentation tests during initially applied strain, ii ) influence of temperature on the stress transfer across the interface, iii ) modulus and thickness of the interphase and their influence on interfacial stress transfer, iv ) interfacial debonding process, and v ) fragment aspect ratio, contact friction along the interface and their influences to the interfacial stress transfer efficiency

    在論文的這部分工作中，使用有限元法描述和分析了逐節斷裂試驗中初始應變下的纖維軸向應力和界面相剪切應力，溫度對界面應力傳遞的影響，界面相模量和厚度、纖維節長寬比、界面脫粘過程、界面接觸中的摩擦效應等因素對逐節斷裂試驗中應力傳遞的影響。
  4. In the paper we mainly researched space gainp2 / gaas / ge high efficiency tandem cells " making process by home - made low pressure mocvd technology and new solar concentrators. firstly, we presented reseached and development of solar cells in china and foreign countries ; secondly, on the basis of fundamental priciples and theories, we discussed some factors of influcing conversion efficiency of solar cells, and analysed the i - v output feature of two - junction tandem cells ; then the design concept of gainp2 / gaas / ge two - junction tandem cells was discussed, the detailed aspects of gainp2 / gaas / ge tandem cells epitaxy growth by low pressure mocvd was studied, and some questions on epitaxy growth ( such as crystal qualities, interface stress, element interdiffusion, n - and p - type doping et all ) were solved ; after that, the cell fabrication process was described ; finally, we reseached the hot pressing and mould process technology of an arched line - focus fresnel lens made by pmma, designed and fixed new solar concentrators

    本文致力於用自製的低壓mocvd裝置進行cainp _ 2 / gaas / ge空間用高效級聯太陽能電池製作的工藝以及聚光太陽能電池組件的研究。首先，介紹了國內外太陽能電池的研究現狀及應用情況；其次，運用太陽能電池基本原理討論影響電池轉換效率的因素，分析了級聯電池的伏安特性；隨后，討論了cainp _ 2 / gaas / ge雙結級聯電池的結構設計理念，研究了採用低壓mocvd技術生長cainp _ 2 / gaas / ge級聯太陽電池材料的工藝過程，解決了異質材料生長的結晶質量、界面應力、材料互擴散以及材料n 、 p型摻雜等一系列問題；然後總結了級聯電池的后工藝製作；最後，研究了以pmma為材料的菲涅耳線聚焦透鏡的熱壓成型工藝及其模具的加工工藝，設計並安裝完成新型聚光太陽能電池組件。
  5. Research of stress and strain in the interfacial bonding of rubber composites

    復合材料粘結界面應力應變研究
  6. Models for calculation of interfacial stress in cobalt - rich crusts breaking

    破碎富鈷結殼時界面應力計算模型
  7. An interface analysis model was established based on the interface stress element method for discontinuous medium mechanical problem to simulate the pull - out tests and tensile tests, and the calculated results are in good agreement with those of experiments

    應用解決不連續介質力學問題的界面應力元法建立交界面的分析模型，對拔出試驗和拉伸試驗進行了數值模擬，數值模擬計算結果與試驗結果接近。
  8. Based on analysis and comparison of existing test data applied to existing ultimate strength prediction models, interfacial stress at the end of plate is deduced. after formulas for calculating the effective moment of inertia for frp - strengthened beams being revised and adjustment coefficient related to nominal main steel reinforcement ratio and curtailment length ratio being put forward, strength prediction formulas of compound beams under plate end debonding failure are established. in analysis of strength of compound beams under intermediate crack induced interfacial debonding failure mode, several bond strengths and their relation are introduced

    對于板端剝離破壞，在總結現有承載力模型的基礎上，利用已有試驗數據對各承載力計算公式進行了分析比較，進一步採用分階段分析法，推導了板端界面應力的計算公式，在此基礎上，採用加固復合梁有效慣性矩的修正公式，建立了考慮名義配筋率和板端偏移比影響的板端剝離破壞梁承載力的計算公式；對于跨中受彎裂縫導致的粘結破壞，闡述了常見的幾種粘結強度之間的區別和聯系，並基於拉剪粘結強度，提出了跨中受彎裂縫導致粘結破壞的承載力計算公式，並利用現有試驗結果確定了模型中的一些參數；最後，利用試驗數據對本文建立的兩種粘結破壞承載力計算公式進行了檢驗，結果基本吻合。
  9. The coupled effect is analyzed for an elliptical inhomogeneity under plane uniform loads and linear temperature change at infinity. the complex potentials are obtained for an elliptical inhomogeneity under plane uniform mechanical loading, uniform temperature change and uniform heat flow directed at any angle. the discussion is also given to the variation of the interfacial stresses with thermal parameters

    分析了無窮遠平面加載和線性溫變的耦合效應，獲得了橢圓夾雜體在無窮遠平面均勻加載和均勻升溫以及任意方向的均勻熱流共同作用下的復勢解答，並討論了界面應力隨各熱載參數的變化規律，發現基體導熱性能越好（與夾雜相比） ，界面應力幅值越大。
  10. Researches on the deformation of the discontinuous interface of rock mass and the method of interface element stress

    巖體不連續結構面變形研究與界面應力元法
  11. Experimentalresults showed that the thickness of the frp interface stress has importantimplications in the use of intensity required to achieve such a way as to not morethan three layers, because in temperature 40 degrees, the stress arising from theinterface sheared intensity has reached half

    實驗結果表明， frp片材的厚度對界面的應力有著重要的影響，在補強強度達到使用要求的情況下，盡量不要超過3層，因為在溫差40時，三層碳纖維補強所產生的界面應力已達到界面剪切強度的一半。
  12. Study on the stress of dlc mct interface by finite element method

    晶體界面應力的有限元分析
  13. Stage ii begins at a peak associated with the maximal interfacial stress. then, the unloading of macro - stress occurs. in stage iii, the interface is completely separate

    1 ）隨著界面開始分離，宏觀剛度下降； 2 ）界面應力達到最大值並發生卸載，使得宏觀應力達到峰值然後卸載。
  14. Numerical method of the interface stress element method

    界面應力元法的數值計算
  15. Interface stress element model for bond - slip problems

    粘結滑移問題的界面應力元模型
  16. A simplified and efficient algorithm is presented by combining stress - strain analysis with numberical method in this paper

    將數學方法應用於應力應變分析，提出了一種高效、簡便的界面應力演算法。
  17. Stress analyses of fiber - matrix interface and interface failure

    基體界面應力分析及界面失效
  18. Abstract : to understand the states of stresses of coatings is the key to development and application of coatings and guaranteeing of their performance and sevice life

    文摘:掌握塗層界面應力狀態有助於塗層開發應用和提高其工作性能與使用壽命。
  19. In this paper i have done several worksuch as : coefficient of thermal expansion of frp sheet is larger different thanthat of the concrete. the interface of frp sheet reinforced concrete will producetemperature stress under the circumstance of temperature difference. i n order todesign the reinforced structure and evaluate safely, it is very significant toanalyse the interface temperature stress and to find the changing law of interfacetemperature stress

    本文重點分析了frp片材補強混凝土梁界面溫度應力分佈理論，解決補強方面的一些工程問題，主要完成了以下幾個方面的研究工作:首先， frp片材的熱膨脹系數與混凝土的熱膨脹系數相差較大，在環境溫差作用下， frp片材補強混凝土界面將產生界面溫度應力，正確分析界面溫度應力和界面應力變化規律，對補強結構設計和安全評價具有重要的意義。
  20. An non - linear finite element analysis of double shear testpiece of rubber - steel bimaterials has been finished. for the testpiece without crack, the stiffness of the testpiece and the stress distributions of the interface have been given

    對無初始裂紋和含初始裂紋的橡膠鋼雙剪切試件進行非線性有限元分析，了解試件剛度和界面應力的變化情況。
分享友人
分享到 Line

分享到臉書