layer interface 中文意思是什麼
layer interface
解釋
層次介面-
Structure of the adsorbed layer of cationic surfactant at diaspore - water interface
陽離子表面活性劑在一水硬鋁石表面吸附研究 -
The anion surfactant nals was the most efficient in the process and was selected as collector by orthogonal method. the interfacial tension and cmc of nals ( cmc 6. 5 10 - 3m ) in the solution was measured by hanging ring test, the function relationship between interfacial tensions and nals concentration was : = - 0. 9523 in 2c - 24. 534 in c - 81. 411. the relation of interfacial adsorption equilibrium in the solution system was respectively tested and calculated with gibbs equation and dynamic method. the conclusion showed that ( 1 ) the experiment result of dynamic method with was highly in coordination with the value which from theoretical calculation. ( 2 ) the surfactant molecule was in arrangement of monomolecular layer at the gas - liquid interface
用吊環法測定了十二烷基硫酸鈉水溶液不同濃度與其界面張力的關系，擬合得到的回歸方程為= - 0 . 9523ln ~ 2c - 24 . 534lnc - 81 . 411 ，同時還測得其臨界膠束濃度值（ cmc為6 . 5 10 ~ （ - 3 ） m ） ，運用吉布斯等溫方程和動態法分別計算和測定了該溶液系統的界面吸附平衡關系，結論表明： （ 1 ）動態法測定結果基本吻合吉布斯方程的理論計算； （ 2 ）表面活性劑分子在氣?液兩相界面是以單分子層形式定向有序排列的。 -
On the contrary, because the molecular weight of piperazine monomer is far below the molecular weight cut - off range of nanofiltration, it can easily permeate the functional layer into the w / o interface to keep reacting with trimesoyl molecules
目前紡制的復合效果較好的聚礬中空纖維基膜通量高於200lm一h一， ，對peg20 （ ） 00的截留率達99 % 。 -
The study conducted research on the following four fields : firstly, the characteristics of the interfacial polymerization system of piperazine aqueous solution / trimesoyl hexane solution were systematically investigated. the results show that at a certain molar ratio between the two monomers, piperazine and trimesoyl, at the two phase interface, a dense functional layer of ultra low pressure, high permeating flux and high salt rejection formed by controlling the time of interfacial polymerization, such as the composite membrane ( i ), the concentration in water phase is 0. 4 %, and 0. 1 % in organic phase, and the polymerization time is 1 minute
本文主要進行了四個方面的研究，首先系統分析和研究了哌嗪水溶液均苯三甲酰氯正己烷溶液界面聚合體系特徵、界面聚合反應中各影響因素對膜性能的影響等，結果發現，當界面處兩相單體（哌嗪和酰氯）分子摩爾比為某一比值時，通過控制界面聚合時間（有機相處理時間） ，可以形成超低壓高通量高脫鹽的緻密功能層，如復合膜（ ） ，水相濃度為0 . 4 ，有機相濃度為0 . 1 ，聚合時間1min 。 -
The particles distributed hi the matrix of grey cast iron, but some contact each other. the composite layer extend gradually into the substrate. when volume fraction of wc is 36 wt % and 27 wt %, the matrix of the composite is high chromium cast iron, consist of white carbide bars and the austenite. wc particles distributed uniformly, retaining approximately quondam granular form in the composite layer which has an evident interface area with the substrate, with good bonding strength
對不同碳化鎢體積分數的灰鐵和低鉻鑄鐵基復合材料的微觀組織結構分析表明：碳化鎢體積分數為52時，復合層內基體為灰口鑄鐵組織，顆粒直接分佈在灰鐵基體上，部分碳化鎢顆粒有相互接觸的現象，基材與復合層之間沒有明顯的過渡；碳化鎢體積分數為36 、 27時，復合層內基體為高鉻鑄鐵，由面塊狀的奧氏體和白條狀碳化物組成，碳化鎢顆粒表面固溶於基體組織中，粒形基本保持完整，分佈均勻，與基體構成冶金結合，基材與復合層之間存在一個明顯的平緩過渡區。 -
Aiming at the function and performance limitations of traditional special cnc or current pc - based open - structure cnc, a brand - new cnc platform designing scheme of multi - layer open - architecture is presented, based on embedded - mcu calculation and management core, and three kinds of expanding mode of software, hardware and interface. by using double system working ram and boot rom technology, an independent re - development interface is set on the hardware platform to realize customized function ’ s simulations and verifications online, which makes all the expanding or re - configuring on basic cnc platform are all safe and restorable
本文針對傳統專用數控系統的結構封閉、交互形式不通用和配置擴展不靈活方面的劣勢以及當前pc模式開放結構數控的體積龐大、開放程度不高和實時可靠性不強的局限，創新性地提出了以基本cnc框架+軟體、硬體和介面三種擴展形式為特徵的層次化開放結構的嵌入式cnc硬體平臺，並採用雙存儲區技術進行了cnc系統在線模擬校驗機制和安全保護機制的方案設計。 -
Secondly, based on the function requirement of usb device controller the system was divided into five modules, clock extracting, event detect, physical layer interface, media access controller, endpoint control layer and every module was designed in detail
其次，針對usb設備控制器的功能要求，將系統分為時鐘提取、事件檢測、物理層、介質訪問層、端點控制層五個模塊並對每個模塊進行了詳細設計。 -
The layers from substrate to top of the deposited film are ti substrate, buffer layer ( interface between substrate and film ), porous layer and lamellar layer
研究發現，從鈦合金到羥基磷灰石共有四層結構：鈦合金基體、鈦合金的氧化層、多孔的納米晶羥基磷灰石和花瓣狀的結晶良好的羥基磷灰石。 -
Transport layer interface
運輸層介面 -
The results of orthogonal experiment shows that the effect of the volumetric flow of exhaust gases is the most notable ; the effects of the number of exhaust inlets and the heat released rate of fire source are less notable than the effect of the volumetric flow of exhaust gases on the smoke layer interface ; the effects of the separation of exhaust inlets, the interrelation between the number and the separation of exhaust inlets and the location of exhaust inlets are notable ; but the rest factors " effects are not obvious
實驗結果表明：對煙氣層高度影響特別顯著的是排煙量大小、排煙口數量和火災負荷大小三個因素；排煙口間距，排煙口數量與間距的交互作用，排煙口位置和大小對煙氣層高度的影響也比較明顯；而排煙口大小與間距，大小與位置，大小與數量，位置與數量，位置與間距之間的交互作用對煙氣層高度的影響不大。 -
After analyze the foundation of the current national code ( code for fire protection design of tall buildings gb500045 - 95 ) through experiments and fire simulations, the author has found that there are some limitations on the use of this national code for the designing of smoke management system in an atrium. this paper has been discovered that it is not enough when using the smoke layer interface height as a criterion to make an assessment on the safety rate in a building fire, or to calculate the egress time
通過上述實驗研究和數值模擬研究，發現當採用我國現行的《高層民用建築防火設計規范》 （ gb50045 - 95 ）來指導中庭建築的排煙系統設計時，在本文設計的火災場景條件下（參照實際的中庭商場調研情況，即火災載荷密度較大時） ，對于本文實驗研究中所採用的相似模型及原型建築，無論是採用自然排煙或者是採用機械排煙，其排煙量皆不足。 -
Firstly, by calling open client api, data transmission among simulation members was simply achieved. then, the api which suits for radar simuation system is developed based on open client api. on the base of the work, the data - layer interface which includes interface class, data - interface description file and code generation is developed
先是簡單地調用openclient介面函數實現模擬子系統與數據庫的數據傳輸，接著在openclient介面函數基礎上開發出適合於雷達模擬的數據傳輸統一介面函數，然後對數據層次生成方式進行改進，開發出由介面類、數據介面描述文件和代碼生成器組成的數據層次介面。 -
On the other hand, an experimental small - scale model, which is 1 : 8 - scaling model of the polyu / ustc atrium, was established. the effects of some factors on the smoke layer interface of the smoke exhaust system in atria are studied by using the orthogonal experiments
論文以香港理工大學和中國科技大學合建的大空間火災實驗廳為原型，按1 ： 8的相似比例，搭建了中庭火災相似模型實驗臺，採用兩水平正交實驗研究了影響機械排煙系統煙氣層高度的幾個因素。 -
Network and customer installation interfaces - ds3 physical layer interface and mapping specifications for atm applications
網路與用戶裝置介面. atm的ds3物理層介面和映射規范 -
Network and customer installation interfaces - sonet physical layer interface and mapping specifications for atm applications
網路和用戶安裝介面. atm的sonet物理層介面和映射規范 -
The highly constant quality of basf dispersion and compatibility of external wall decorative surface and thermal insulation layer interface ensure the stability for the whole external wall thermal insulation and surface decoration system
巴斯夫乳液穩定的高品質和外墻飾面與保溫層界面的相容性保證了整個外墻外保溫飾面系統的穩定性。 -
A new progress in m ? ssbauer spetrum study on the magnetic structure and magnetic properties of the magnetic layer, interface layer and nonmaynetic layer in the magnetic multilayers is reviewed
摘要簡述磁性多層膜中磁層、界面和非磁層的結構及磁性的穆斯堡爾譜研究。 -
The distributed system with the framework is strictly divided into five layers from the bottom to the top : data layer, data integration layer, transaction logic layer, interface control layer and user interface layer
本文提出並實現的應用框架將分散式系統自底向上嚴格地分為五層：數據層、數據集成層、業務邏輯層、界面控制層和客戶界面層。 -
The interface transferring mechanism of fbg strain sensors and error modification have been studied. the equations of multi - layer interface transferring and error modification are derived. interface - transferring properties of fbgs embedded in cfrp were analyzed in theory
建立監測對象實際應變與光纖傳感器應變層間界面應變傳遞的統一模型，並推導其界面層應變傳遞統一公式，用於光纖應變傳感的誤差修正。 -
Abstract : in this paper the visco - elasticity constitution relationship of cyclic degradation describing offshore soft clay behaviors is studied. a method for quantitatively analyzing the stability of offshore soft soil sites under wave loading is developed by combining the relationship with water - mud multi - layer interface model. since the variation of nonlinear visco - elasticity parameters due to cyclic degradation of soft clay can be considered, the analytic results can reflect the changing process of soft clay under wave loading
文摘:本文研究了海洋軟土的循環弱化粘彈性本構關系，進而把它與波浪、水、土多層計算模型相結合，提出一種定量分析波浪作用下海洋軟土場地穩定性的方法.由於它考慮了軟土的循環弱化而導致的非線性粘彈性參數的變化，使分析結果能比較真實地反映波浪作用下海洋軟土層的變化過程
分享友人