疲勞壽命試驗 的英文怎麼說

中文拼音 [píláoshòumìngshìyàn]
疲勞壽命試驗 英文
life cycling test
  • 疲 : 形容詞（疲乏; 勞累） tired; weary; exhausted
  • 勞 : Ⅰ動詞1 （勞動） work; labour 2 （煩勞） put sb to the trouble of; trouble sb with sth : 勞您費心...
  • 試 : 名詞（古代占卜用的器具） astrolabe
  • 驗 : 動詞1. （察看; 查考） examine; check; test 2. （產生預期的效果） prove effective; produce the expected result
  • 疲勞 : 1. （疲乏勞累） tired; fatigued; weary; become fagged 2. （機能或反應能力減弱） fatigue; strain 3. [物理學] fatigue
  • 試驗 : trial; experiment; test
  1. It can be seen from the results that the control beam had good plastic property in the static failure experiment after two million fatigue loading circles. all specimens with corroded main bars were failure under the fatigue loads within one million fatigue circles. fatigue lifespan of reinforced concrete beam was sharply shortened after main bars corroded in it and the beam was destroyed bristly without any prediction

    試驗結果表明，振動測試不能夠對銹蝕鋼筋混凝土梁的疲勞破壞做出可靠的預測;對比梁在經過200萬次疲勞循環加載后的靜力試驗中仍表現出良好的延性破壞特徵;銹蝕梁在100萬次疲勞循環內均因主筋疲勞斷裂而破壞;主筋銹蝕使得梁的疲勞壽命急劇縮短;梁發生脆性破壞而沒有徵兆。
  2. Abstract : the factors to influence fatigue life of chain plate areconcluded by experimental methods. the factors to prolong life of chain plate are analyzed by theoretical methods. the maximum value of crushing hole in 16a roller chain plate is calculated by finite element method

    文摘:用試驗方法確定了擠孔對鏈板疲勞壽命的影響，從理論上分析了在最佳擠孔量下，鏈板疲勞壽命提高的因素，用有限元法計算了16a鏈板的最佳擠孔量，並與試驗結果進行了比較。
  3. First, the theory of fretting wear and studies on fretting fatigue were introduced and the parametric method was used in the process of creating the model of dovetail joints in ug software. the elastic contact problem is analyzed in finite element method ( fem ) and is used to the parameters " distribution and contact stress of the joint are obtained on the base of ansys code. with the effect factor of load frequency, the prediction method of fretting fatigue life of dovetail joint under low and high / low cycle complex load is proposed

    本文介紹了微動損傷的機理和微動疲勞壽命的研究方法；利用ug軟體對燕尾榫聯接結構創建了參數化實體模型；基於ansys軟體平臺求解彈性接觸問題，獲得了榫聯接結構接觸應力及接觸狀態量的分佈；在已有微動疲勞壽命預測模型的基礎上，引入載荷頻率影響因子，對低周、高低周復合載荷作用下的燕尾榫聯接結構進行了微動疲勞壽命的預測，與試驗結果對比表明採用本文提出的方法預測榫聯接結構的微動疲勞壽命是有效的。
  4. For rotor steel ( 30crlmolv steel ), the tests of low - cycle fatigue property are done under different temperatures. the fatigue life under different temperatures is researched to make up for the defects of the testing for foreign similar materials. when pull - stretch data is attempted to evaluate low - cycle fatigue data, the result shows that four - point associated method in middle - low life zone is done well under room temperature, but there are large errors of four - point associated method and general - slope method under other temperatures

    在本文中，通過與國外同類材料的性能進行比較，國產材料與國外材料共有的材料特徵基本相同；對轉子鋼（ 30crlmolv鋼）進行了不同溫度下的低周疲勞性能實驗，研究其在不同溫度下疲勞壽命，以彌補國外對同類鋼材測試的不足；採用拉伸數據預測低周疲勞壽命時發現，室溫條件下用四點關聯法在中低壽命區預測較好，在高溫條件下四點關聯法和通用斜率法都有較大誤差，需要進行改進。
  5. Moreover, base on lots of test data, fatigue life estimation is finished by help of miner, opposite miner rule and fracture mechanics theory. theoretic results and test data are well fit to each other

    另外，本文在大量試驗數據的基礎上，依據miner法則、相對minar法則以及斷裂力學理論，對40cr高強螺栓的疲勞壽命估算進行了系統研究，理論分析結果與試驗值的規律性吻合較好。
  6. Being deficient in sonic fatigue testing and owing to the limitations of nomograph method application to the sonic fatigue life prediction, an analysis software program was designed and worked out in present thesis, based on the research achievement in prediction of sonic fatigue life, which strong function, easy use and great extensive capabilities

    本文針對現階段聲疲勞試驗的不足，以及工程中常用的諾謨圖方法的局限，整理了目前比較成熟的典型蒙皮壁板聲疲勞壽命研究成果，提出設計並編制了一套功能強、易於使用，可擴展性好的聲疲勞壽命預測及分析平臺。
  7. Nowadays, company has been equipped with perfect gas spring assembling lines, microcomputer controlling function testing platforms, fatigue longevity test - beds, high and low temperature function concussion test - beds and sodium fog experiment tables

    公司現已配備有性能完善的氣彈簧裝配流水線、微機控制性能測試臺、疲勞壽命試驗臺;高低溫性能沖擊試驗臺、鹽霧實驗臺等專用設備。
  8. Second, carried out the fatigue life test of the truck ' s front axles adopted grouping fatigue life test method, calculated the results on theory of probability stats, linear fitted the fatigue life data by means of the basquin equation and least squares method, acquired the mathematical model of s - n and p - s - n curve of the front axles

    其次，採用成組試驗法，對汽車前橋進行了疲勞壽命試驗，藉助概率統計方法對試驗結果進行了分析計算，得到了各試驗載荷下的疲勞壽命的正態分佈的均值和標準差，採用basquin關系式和最小二乘法對疲勞壽命數據進行線性擬合，得到了前橋的s - n和p - s - n的關系。
  9. The tested results showed that the collecting ring could be used for the dynamic stress test successfully and the experimental data would be used for determining load spectrum and analyzing fatigue life of spoke plate

    結果表明，動態測試過程穩定，所設計和製造的集流環完全滿足試驗要求，測試數據可以用於結構載荷譜的編制和疲勞壽命分析。
  10. The existed material fatigue performance test curves are dealt with and analyzed, and the non - dimensional stress - strain curve, tangent modulus factor curve and fatigue life curve are drawn based on the experiment data, and these three non - dimensional parameter curves are used to find the inherent rules that the test curves can be replaced each other to some extent. it can be concluded that if the common character and system error of these materials are found, the test curve of a certain material can be used for reference by another material. this is a simple approach about fatigue life estimate and is engineering practical

    對已有的材料力學疲勞性能試驗曲線進行分析整理，利用試驗數據繪制了相對應力應變曲線、切線模量因子曲線和疲勞壽命曲線，利用這三種無量綱參數曲線發現了其中存在的規律性，即在某種程度上實驗曲線可以互相取代，並用試驗數據對此進行了討論，並由此推斷，如果找出材料彼此的共性或彼此之間的系統誤差就可以將一種材料的試驗曲線供其它材料參考使用，這是一種估算材料的疲勞壽命的簡便方法，對工程而言具有實用性。
  11. 3, analyzing the stress field of the aero - engine case under the given loads, the fatigue life of the case is predicted through the presented fatigue model and the method of " nominal stress "

    用該模型對孔徑為5mm層合板的s ? n曲線進行疲勞壽命預測及試驗驗證。 3 、首次對某型發動機t300 kh - 304復合材料機匣的主鋪層在給定工況下的疲勞壽命進行預測。
  12. Research on fatigue life using aircraft structure passed higher load test

    利用做過高載試驗的飛機結構進行疲勞壽命研究
  13. Research on fatigue intensifying test of driving axle and estimating confidence interval of fatigue life

    驅動橋疲勞強化試驗及疲勞壽命的置信區間估計
  14. In this paper, the high - temperature low - cycle fatigue life and fatigue crack propagation life tests are carried on the cylindrical axial symmetry specimens having precrack or non - precrack with different types of notches of 16mnr steel in common use in the petrochemical industry contacting coke drum equipment, the stress / strain and the range of stress / strain of dangerous points are received through stress analysis of the specimens using finite element program under multi - axial stress state. at last, the equations of evaluating the high - temperature low - cycle fatigue life and the fatigue crack propagation life are found through using the least - square regression method

    本文採用無預裂紋和帶預裂紋環狀缺口圓柱形試樣，進行了石化焦炭塔設備常用材料16mnr多維應力狀態下不同缺口形式的高溫低周疲勞總壽命試驗及裂紋擴展壽命試驗，並利用有限元程序對試樣缺口周圍及裂紋尖端附近進行了軸對稱多維應力狀態下的應力、應變場分析，來評價材料不同條件下的高溫低周疲勞總壽命和裂紋擴展壽命，最後利用最小二乘回歸方法，得到了該材料高溫低周疲勞總壽命和裂紋擴展壽命評價方程。
  15. Based on the experimental data of rotor steel 1crmov in the loading of low - cycle fatigue at high temperature, the strength behavior and the fatigue life curve of this material at 550 have been achieved. meanwhile, with respect to three kinds of notched bar, their material damage assessment method under multiaxial stress condition is discussed

    本文在1crmov材料的高溫低周疲勞實驗數據進行了整理和統計的基礎上，得到了材料的疲勞強度特性曲線和疲勞壽命曲線，同時對三種不同缺口形式的圓柱形試件進行了多軸應力狀態下的材料損傷的研究，並通過數值計算方法進行了疲勞壽命評估。
  16. Based on the principle of the cooperation, i. e, the correlative stochastic equations are located on the same probability level, the linear regression with fuzzy weight analysis is adopted to fit the test data, and the three - parameter stress - life curves of the mean and the mean square deviation are obtained

    根據協同原理，即相關聯的隨機方程動態地處于同一概率水準，採用模糊隨機加權線性回歸方法對試驗數據進行擬合，得到了三參數的應力-壽命模型均值和均方差曲線，從而求得在給定應力下各可靠度的疲勞壽命。
  17. Test method for ambient temperature fatigue life of metallic bonded resistance strain gages

    金屬連接耐應力規環境溫度疲勞壽命試驗方法
  18. Fatigue experiments were performed to obtain the fatigue lifetime under the different loading. the parameters for law of the fatigue crack growth were obtained by crack growth experiments. in order to study the fatigue characteristics at high temperature, creep tests were also done

    本文對多種典型焊接試件開展了諸多的試驗研究工作：進行單軸靜載拉伸試驗以確定構件的強度；進行疲勞壽命試驗以測得疲勞壽命曲線；進行疲勞裂紋擴展試驗以獲得試件的疲勞裂紋擴展規律paris公式；進行蠕變試驗以考察焊接試件疲勞持久特性；進行剩餘壽命試驗以獲得試件的剩餘壽命。
  19. Monitoring online for the test of bearing fatigue life - span in amplitude domain

    在幅值域中對軸承疲勞壽命試驗的在線監測
  20. Influences on fatigue life and dynamic balance from metallographic structure image, fatigue experiments and dynamic balance experiments were also analyzed

    從條碼的微觀組織、疲勞壽命試驗、動平衡試驗中分析了對刀具疲勞壽命和動平衡的影響。
分享友人
分享到 Line

分享到臉書