皮厚 的英文怎麼說

中文拼音 [hòu]
皮厚 英文
a0dc
  • : Ⅰ名詞1 (人或物體表面的一層組織) skin 2 (皮革) leather; hide 3 (毛皮) fur 4 (包在外面的一層...
  1. Confident girls wove here and there among the people.

    皮厚的年輕姑娘在人群中間鉆進鉆出。
  2. The thickness of the bark and girth of the tree can influence the shape and nature of galleries and chambers.

    不過樹皮厚度和樹的周長都會影響到蟲道和蛹寶的形狀與特徵。
  3. Thickness of upper and lower epidermis of leaves, width of xylem and phloem of annual and biennial branches, ratio of late wood to early wood, periderm thickness of biennial branches, and length of xylem ray present decreasing trends with latitude ascending ; while ratio of palisade tissue to spongy tissue, epidermis thickness of annual branches, and cortex thickness of biennial branches show unobvious variations with latitude increasing

    葉的上下表皮厚度、 1和2年生枝木質部及韌部寬度、晚材早材比值、 2年生枝的周皮厚度、木射線長等均隨緯度升高而呈下降趨勢;而葉的柵欄組織和海綿組織比值、 1年生枝表皮厚度、 2年生度等解剖結構隨緯度變化沒有明顯規律。
  4. At high power, the urothelial carcinoma does resemble urothelium, but the thickness is much greater than normal and the cells show more pleomorphism

    高倍鏡下,移行細胞癌的細胞很象尿道上,但比正常尿道上皮厚,且呈多形性。
  5. In different in terne die travel, the metal flow characterize in warm extrusion forming processes and the affection for the flow of metal stage which made by the difference between the blank bottom altitude and the axial direction limiting size in warm extrusion forming technique have been analysed we have gotten the equivalent strain field and the velocity field and other field variable that the blank in different in terne die travel and the die travel - load curve. at the same time, we have analyzed the contributing factor for the oil pump stator forming process optimized and achieve thereasonable die parameter for the war m extrusion forming finally, the optimized technics parameters were used into pilot production, then the qualified oil pump stator forging were produced, the analog results were compared with those of pilot production

    論文具體分析研究了不同成形工藝過程中金屬流動的特點,並對不同凸模行程下溫擠成形過程中的金屬流動特點、坯料連皮厚度(底部高度)與溫擠壓成形工藝中的軸向界限尺寸的差值對金屬變形階段的影響進行了分析,獲得了坯料在不同凸模行程下的等效應變場、速度場等場變量及凸模行程-載荷曲線,同時對油泵定子成形過程的影響因素等進行了分析,優化並獲得了合理的溫擠成形工藝及模具參數。最後,利用模擬優化獲得的各項工藝參數進行生產實驗,得到實際生產出的合格油泵定子件,並將模擬結果與生產實驗結果進行比較。
  6. Making a living as a door - to - door salesman demands a thick skin, both to protect against the weather and against constantly having the door shut in your face. bill porter puts up with all this and much, much more

    干挨家挨戶上門推銷這一營生得臉皮厚,不可阻擋。但俄羅斯的冰雪戰士證明他們錯了。
  7. Making a living as a door - to - door salesman demands a thick skin, both to protect agai t the weather and agai t co tantly having the door shut in your face. bill porter puts up with all this and much, much more

    干挨家挨戶上門推銷這一營生得臉皮厚,這是因為干這一行不僅要經受風吹日曬,還要承受一次又一次的閉門羹。比爾.波特忍受著這一切,以及別的種種折磨。
  8. Drought resistances of leaves of 13 rasberry and blackberry were measured based on 7 xeromorphic indexes, including thickness of leaves, ratio of palisade tissue thickness to cutis tissue, thickness extent of palisade cell density, thickness of cuticular, thickness of two sides of cutis

    摘要選取7項葉片旱生結構指標(葉片度,柵欄組織度葉肉組織度,細胞密集度,角質層度,上、下表皮厚度) ,觀察測定了13個樹莓和黑莓品種的葉片的相關指標。
  9. In addition, we also supply raw wood, spuare wood and veneer laminates ( 0. 1 - - - 5mm thick ) of teak

    另本公司大量供應柚木原材、柚木枋、柚木度10 - 500絲) 。
  10. The petiole and leaf lengths and leaf widths and cork thicknesses and seed widths of the quercus variabilis communities appeared to have a second - degree parabola relation with the latitudes of the communities ; the petiole lengths and leaf lengths and cork thickness appeared to have a clear second - degree parabola relation with the elevations of the communities ; the leaf and seed lengths appeared to have a clear positive correlativity with the elevations ; the seed lengths had a typical negative correlation with the elevations

    櫟種群的葉柄長、葉長、葉寬、栓皮厚度、種長和種寬隨緯度呈現出二次拋物線關系;葉柄長、葉長和栓皮厚度隨海拔高度呈現明顯的二次拋物線關系;葉寬和種寬隨海拔高度的變化呈現出明顯的正線性相關;種長與海拔的關系為一種典型的負線性相關。
  11. Miss douce, bending again over the teatray, ruffled again her nose and rolled droll fattened eyes

    杜絲小姐朝茶盤彎下腰去,又把鼻子一皺,滴溜溜地轉著她那雙眼皮厚實帶滑稽意味的眼睛。
  12. On the basis of analyzing infiltration process to different soil and water conservation tillage measures type, a increasing infiltration r ates model for different soil and water conservation tillage measures type by using water balance equation is woke out. 4. accumulation depth and soil crust have a better affect to soil initial stage infiltration rates and a little affect to soil stable infiltration rates

    ( 4 )積水深度和土壤結對初始入滲速率影響較大,對穩定入滲速率影響不大,隨著積水深度和結皮厚度的增大,這種情況尤為顯著,如在積水深度為5cm和3cm情況下,穩定入滲速率在黃土高原溝壑區分別為0 . 57mm min和0 . 56mm min ,在黃土丘陵溝壑區分別為0 . 94mm min和0 . 93mm min ,兩者相差甚微。
  13. According to the special shape and operate requirements of the torpedo, the structure and moulding process of the torpedo shell are established, in which the body and overlay block with grooves are moulded by fiber winding, and close moulding respectively with the adhesive by limited stop compression. in the light of the selection of raw material system, composite system with outstanding performance are defined, based on which the mechanical properties are tested., with the overall consideration of structural characters and design demands, the main factors which may have effects on the strength and stability ( including stiffness section dimension, stiffeners space, skin thickness and skin lay angle ) is optimized one by one for the structure design parameters on the base of the fem model of skin, stiffness and layover block by fem. as a result, the prototype with 1 : 1 proportion and its structure and lay optimization design are completed. the moulding technology for polyurethane foam moulding the stiffened shell is obtai ned in terms of the design, manufacture moulding, experimental mould and tooling

    依據在研產品特殊的外型結構和使用要求,確定了該型號水雷復合材料殼體的具體結構形式和復合成型工藝路線,即由纖維纏繞工藝成型主體異形件,閉模成型帶通槽外貼塊,用限位加壓工裝實現粘接的工藝路線;通過對原材料體系的篩選,確定了綜合性能較好的復合材料體系,以此為基礎進行了力學性能測試;運用有限元方法,建立了蒙、筋條和外貼塊的分析模型,綜合考慮結構特點和設計要求,對影響結構強度與穩定性的主要因素(包括筋截面尺寸、筋間距、蒙皮厚度、蒙鋪層角度)分別進行了結構設計參數的優選,最終完成了復合材料異形耐外壓殼體1 : 1樣件和縮比實驗件結構及鋪層優化設計;完成了聚氨酯泡沫胎成型內置加筋殼體的成型工藝技術研究;對縮比件進行外壓性能測試,並給出了應力、應變測試結果。
  14. You hain t done a thing from the start that had any sense in it, except coming out so cool and cheeky with that imaginary blue - arrow mark. that was bright - it was right down bully ; and it was the thing that saved us

    從一開始起,你就從沒有干過一件在理的事,除了那一件事算是例外,那就是既態度沉著又老臉皮厚地憑空編了個藍顏色箭頭標記這碼事。
  15. Specializations : singing, playing the piano, ballet, english calligraphy, drawing

    專長:唱歌彈鋼琴芭蕾舞英文書法座右銘:膽大心細臉皮厚
  16. You need a thick skin to be a politician

    當政客得臉皮厚
  17. Second, you must not be shy. be thick - skinned and speak up

    其次,千萬不要害羞。臉皮厚一點大聲說出來!
  18. " why, it s because you ain t one of these leatherface people

    「為什麼?因為你可不是那種臉皮厚一層的人啊。
  19. Absolutely. and cheeky too

    絕對,而且臉皮厚
  20. Many people would be not as cold as we think if we expressed our thought and care first actively

    只要我們積極主動,臉皮厚,許多人並不是我們看到的那麼冷漠
分享友人