相位測量器 的英文怎麼說

中文拼音 [xiāngwèicèliángqì]
相位測量器 英文
phase measuring set
  • 相 : 相Ⅰ名詞1 （相貌; 外貌） looks; appearance 2 （坐、立等的姿態） bearing; posture 3 [物理學] （相位...
  • 位 : Ⅰ名詞1 （所在或所佔的地方） place; location 2 （職位; 地位） position; post; status 3 （特指皇帝...
  • 測 : 動詞1. （測量） survey; fathom; measure 2. （測度; 推測） conjecture; infer
  • 量 : 量動1. （度量） measure 2. （估量） estimate; size up
  • 器 : 名詞1. （器具） implement; utensil; ware 2. （器官） organ 3. （度量; 才能） capacity; talent 4. （姓氏） a surname
  • 相位 : phase position; phase
  • 測量 : measure; survey; gauge; meter; measurement; measuring; surveying; mensuration; metering; gauging;...
  1. Optical 3 - d profilometry has been widely used for 3 - d sensing, machine vision, intelligent robots control, industry monitoring, biomedicine, dressmaking, etc. several 3 - d object profilometry methods, including moire technique ( mt ), phase - measuring profilometry ( pmp ), fourier transformation profilometry ( ftp ), modulation measurement profilometry ( mmp ) have been exhaustively studied

    光學三維傳感已廣泛應用於機器視覺，實物仿形，工業檢測，生物醫學等方面，在三維面形測量中，對莫爾輪廓術，位相測量輪廓術，付里葉變換輪廓術，調制度測量輪廓術這些方法已經進行了大量深入的研究。
  2. Choosing y type reflection fiber optic detector, this thesis create a tiny displacement - detecting sensor that is made up of led ( light emitting diode ), fiber optic detector, electric eye, lock - in amplifier, display and other electro circuits

    本論文採用y型反射式光纖探頭設計製作了一種微位移測量裝置，它主要由發光二極體、光纖探頭、 、鎖相放大器、顯示器及相關電路組成。
  3. A noncontact 3 - d position measurement system is introduced in this thesis. the system is composed of a planner array ccd detector, real time image analysis and quick data calculation system, which can survey the positional relationship between the haloid lamp objects on the emissive vehicle and the measuring system on the loading vehicle

    本文研究了一種簡單、新型的非接觸三維位置測量系統，該系統由一組ccd探測器、實時圖像處理及快速數據解算系統組成，對發射車上鹵鎢燈目標在測量坐標系中的三維坐標x 、 y 、 z值和發射車軸線相對測量坐標軸的夾角進行測量。
  4. Auxiliary pressure and temperature measurements make the multifrequency phase fluorometer an ideal choice for luminescence sensor design, testing and calibration

    輔助壓力和溫度測量讓多頻相位熒光計是發光探測傳感器設計、測試和校準的理想選擇。
  5. A new measurement system for electrical conductivity in an yj - 3000t press fitted with a wedge - type cubic anvil was set up on the basis of the old one. a solartron 1260 impedance / gain phase analyzer was used in the new system ; mo electrodes and a mo shield were also used to keep oxygen fugacity close to the mo - moo2, which is similar to that of iron - wustite ( iw )

    在yj ?緊裝式六面頂壓機上，對原有的礦物、巖石電性測量系統進行了進一步的改進：建立了一套以solartron1260阻抗增益?相位分析儀為測試儀器，使用mo電極和mo盾來控制樣品氧逸度的測量系統，該系統的氧逸度環境為mo ? moo _ 2 ，接近iw緩沖對。
  6. Measurement method of hydrophone phase consistency

    水聽器相位一致性測量方法
  7. It would be highly advantageous to have instrumentation to directly measure structural strains and relative displacements.

    如果能用儀器設備直接測量結構應變和相對位移將具有更大的優越性。
  8. Abstract : in fourier transform profilometry, because of the nonlinear relationship between the irradiant incident upon a ccd dete ctor andthe voltage it outputs, it will cause phase evaluation errors. here, we ex plain the errorsource by theoretical deducing, then make a simulation. at last, a method to decrease thiserror is put forward

    文摘:在傅里葉變換輪廓術中，由於ccd探測器光電響應的非線性，將在測量中引入高次項，從而對相位的求解造成較大誤差，通過理論的推導定性地解釋了誤差的來由，並用計算機進行了模擬計算，最後提出了減小誤差的方法。
  9. The third, after theoretically analyzing, the following practicable methods are put forward : 1 ) automatically pick - up the synchronous information by analyzing the spectrum of intercepted video - leaking information ; 2 ) realizing the phase lock and the electronic image stabilization by integral - projection and differential - positioning ; 3 ) improving the effect of accumulation mean filter and the pectination filter by using electronic image stabilization ; 4 ) automatically adjusting image acquisition parameters by detecting the image entropy, therefore the quality acquired image is improved ; 5 ) to realize the quantitative test of a leaking extent, a standard test picture was designed. finally, a proto type for leaking information processing based on our techniques mentioned above and the virtual instrument principle was designed and tested

    在理論分析的基礎上，提出了以下的實用技術： 1 ）用譜分析方法從截獲的信息中自動提取同步信息； 2 ）用積分投影、微分定位的方法進行相位檢測，實現可靠的鎖相和電子穩像； 3 ）將電子穩像技術用於重加濾波和梳狀濾波的濾波方法，改進了濾波效果； 4 ）通過檢測圖像信息熵實現圖像採集參數的自動調整，改進了圖像採集的質量； 5 ）設計了用於儀器定標的標準測試圖，可以對泄漏信息進行定量檢測。
  10. The instrument is integrated with a multi - channel high precision open circuit potential measurement system for the ion selective electrode and a potentiostat used in voltammetry, an analog lock - in amplifier is also presented to measure the response of light addressable potential sensor

    對于不同的測量技術，儀器中集成了用於測量電極的多通道高精度開路電壓測量系統和用於溶出伏安法測量的多路電化學測量系統，以及用於測量光尋址電位傳感器的鎖相放大器。
  11. Direct acting indicating analogue electrical measuring instruments and their accessories part 5 : special requirements for phase meters, power factor meters and synchroscopes

    直接動作指示模擬電氣測量儀器及其附件.第5部分:相位表功率因數表和同步示波器的特殊要求
  12. Taking the vr step motor as example in the paper, systemic research is conducted about the principle of the subdividing drive, the non - linearity relationship between microstep and phase current, the method of velocity adjusting and the interrelated factors. the system is designed to realize the subdividing drive, velocity adjusting and position. especially, there are two innovations in this paper. one is the first introduction of pld device and isp technology to the design of phase sequencer, the other is the new measure and amend method of microstep

    本文以三相反應式步進電機為實例，對細分驅動原理、細分驅動的非線性、變細分調速以及相關影響因素進行系統的研究；實現細分驅動器、調速控制、定位控制和軟硬介面的設計。在此基礎上，本文對細分驅動環形分配器的設計和微步距測量修正進行了創新；提出將pld器件和isp技術引入到細分驅動環形分配器的設計思想和錯位測量和逼近修正法。
  13. Therefore, according to the mobility of the aircraft, the present study builts a multi - static location system, which uses the measurements detected by active or passive airborne sensors, when the aircraft is at the different positions. this study proposes two methods for locating sonobuoys. the first one is using aircraft - to - buoy slant range information

    根據飛機的機動性，本文構造了使飛機到達不同點獲取相同的測量信息而實現定位的多基地定位系統；依據機載有源無源探測器所能獲得的測量量，提出了兩種定位方法：斜距離測量定位法和基於卡爾曼濾波的方位測量定位法。
  14. During the process of measuring valve phase, the grating displacement sensor and photoelectric axis - angle encoder are applied to measure the displacement of valve and the angle of curving shaft respectively. their signals are sampled and imported into computer. then the three signals are compared to find the relationship of valve phases in order to offer the reliable measuring parameters for the researchers and quality controllers

    在氣門相位測量中，採用光柵位移傳感器和光電軸角編碼器，分別將發動機進、排氣門位移量和曲軸旋轉位移量的變化信號通過采樣，輸入計算機，對三路信號加以比較找出氣門的相位關系，從而為設計開發人員、品質控制人員提供可靠的測量參數。
  15. The main part and key technique of the cpa system is study : the generation of the femtosecond laser pulse is study, the modulation and maintenance of the ti : s laser is learned ; the types of the measurement for ultrashort laser pulse is generalized and the interferometric autocorrelation is expatiated ; the varieties of the stretchers is sum up and aberration - free stretcher is calculated and optimized to improve the stretching ratio ; the pulse selection is analyzed and a single pulse can be selected successful from the pulse train at a repetition rate of 82mhz ; the kinds of the amplifier in cpa system is gathered up, the eight - pass pre - amplifier and a good many effects in it is investigated. finally, the second, third and fourth - order dispersions in cpa system is analyzed systemicly, and the according means for dispersion compensation is worked out

    對cpa系統的主要環節及關鍵技術進行了研究：掌握了鈦寶石激光器的調節和維護技術，較深入地研究了飛秒激光脈沖產生的機理，其中對群速色散、自相位調制、自鎖模等問題進行了詳盡的分析；總結了超短激光脈沖的測量技術，重點研究了干涉自相關測量法；在總結展寬器類型的基礎上，對無象差展寬器進行了理論計算、優化設計，提高了展寬倍數；深入論述了脈沖列的選單問題，熟練掌握了脈沖選單技術。
  16. Because of the limitation of the measuring condition, in the thesis we had only measured some characteristics of the phase modulator : channel waveguides " loss coefficient is 0. 22db / cm, the split - ratio is 52 / 48 and half - wave voltage is < 5v

    由於條件所限，論文中僅測量了直波導損耗系數、相位調制器的半波電壓和輸出分束比。經測量，半波電壓小於5v ，直波導損耗系數為0 . 22db cm ，輸出分支比為52 48 。
  17. Differential phase measuring set

    微分相位測量器
  18. The measurement system can automatically control the movement of servo motor and communicate with vna through gpib bus to setup the measurement variable automatically, measure the phase of s parameter. it also can progress the measurement data on the background, display the results by graph data, store them in the data files

    系統自動控制伺服電機的運行，對測試探頭完成指定的移動定位;通過gpib總線與矢量網路分析儀器通信，自動完成相關測量參數的設置以及s參數的相位測量;對測得的數據進行后臺處理，將結果以圖形、數據文件的方式顯示、保存。
  19. Case 1 : when there is no relative measurement, each satellite uses its own on - board attitude sensors to determine its attitude, and exchange the information through the communication link between formation satellites, and then the relative attitude is determined through simple mathematical operation. case 2 : based on the range measurements of gps like sensors, using two - point measurement of the relative orbit state to establish relative orbit and attitude kinematics and measuring equations. and state estimation is achieved through the extended kalman filter technology and unscented kalman filter technology, respectively

    方案一，在星間無相對測量時，由衛星自身攜帶的姿態敏感器實現單星高精度姿態確定，利用星間通信鏈路進行信息交互，通過簡單的數學計算獲得星間相對姿態;方案二，利用類gps相對測量，建立了編隊衛星相對軌道運動和相對姿態運動模型及相對距離測量方程，推導了兩點相對軌道運動模型，設計了擴展卡爾曼濾波器及uscented卡爾曼濾波器，對相對位置、速度和姿態進行估計。
  20. The application of advanced devices, new methods and latest technology to phase measurement results in dramatic improvement of function and precision of phase meter

    將新器件、新方法和新技術應用於相位測量技術中，相位計的性能和精確度得以顯著提高。
分享友人
分享到 Line

分享到臉書