相對粘度增量 的英文怎麼說

中文拼音 [xiāngduìniándùzēngliáng]
相對粘度增量 英文
relative viscosity increment
  • 相 : 相Ⅰ名詞1 （相貌; 外貌） looks; appearance 2 （坐、立等的姿態） bearing; posture 3 [物理學] （相位...
  • 對 : Ⅰ動詞1 （回答） answer; reply 2 （對待; 對付） treat; cope with; counter 3 （朝; 向; 面對） be tr...
  • 粘 : 粘動詞（粘附） glue; stick; paste; adhere to; bond
  • 度 : 度動詞[書面語] （推測; 估計） surmise; estimate
  • 量 : 量動1. （度量） measure 2. （估量） estimate; size up
  • 相對 : 1. （面對面） opposite; face to face 2. （非絕對的） relative 3. （比較的） relatively; comparatively
  1. The results indicate that : 1. the main physical and chemical characteristics vary regularly : with rising of the altitude, there is a transition from silt > sand > clay to sand > silt > clay in the mechanical composition ; the argic horizon emerges below the altitude of 1600 meters ; the content of organic matter is enrichment, the content of organic carbon of epipedon is higher than 20 g / kg, while the content of organic carbon increases with increasing of altitude, and in the altitude of 3500 - 3700meters, the soils under the meadow have the maximum content organic carbon ; the soils appear acid - slightly acid reaction, the ph decreases appreciably and acid strengthen with increasing of altitude ; the soils higher than the altitude of 2500 meters are base unsaturated, indicating the soil leaching is strong, the ph and bs are distinct plus correlated ; the contents of sio2, al2o3, and fe2o3 of the soil body and clay are all relatively stabilization ; in the soil body, the content of sio2 is much high and cao is very little, the total contents of sio2, a12o3 and fe2o3 occupy 92 % of the mineral parts, the sequence of mineral elements is : sio2 > al2o3 > fe2o3 > k2o > mgo > cao > tio2 > mno

    研究結果表明： 1太白山南坡土壤的主要理化性質隨海拔高度的上升呈有規律的變化：隨海拔高度上升，機械組成由粉粒砂粒粘粒逐漸過渡到砂粒粉粒粘粒，海拔1600m以下出現粘化層；土壤有機質豐富，表層有機碳含量一般在20g kg以上，有機碳含量隨海拔高度升高而相應增加，海拔3500 3700m的灌叢草甸植被下有機碳含量最高；土壤呈酸性或微酸性，並隨海拔上升， ph值略微降低，酸性增強，海拔2700m以上的土壤多呈鹽基不飽和狀態，表明土壤淋溶作用較強， ph值和鹽基飽和度呈極顯著正相關；土體與粘粒中的sio _ 2 、 al _ 2o _ 3 、 fe _ 2o _ 3含量相對比較穩定，土體中sio _ 2含量較高， cao含量較少， sio _ 2 、 al _ 2o _ 3和fe _ 2o _ 3含量之和約占土壤礦質部分的92 ，礦質元素含量的順序依次為： sio _ 2 al _ 2o _ 3 fe _ 2o _ 3 k _ 2o mgo cao tio _ 2 mno 。
  2. Moreover, the resulted prediction model of foam size of the closed cell aluminum foam was verified by comparison to the experimental results from the foaming process at different foaming conditions, and the predicted bubble diameter is in good agreement with the experimental ones, the relative error distributes between - 5. 04 % and 6. 32 %

    當入射空氣的壓強、氣流量，液面高度，出氣孔直徑增大時，氣泡直徑隨之增大；當出氣孔數量，液體粘度增大時，氣泡直徑減小，表面張力對氣泡直徑的影響可以忽略不計；靜態條件下液體表面氣泡直徑的預測值和實驗測量值符合得較好，相對誤差分佈在- 5 . 04 % ~ 6 . 32 %之間。
  3. The results show that the dynamic elastic modulus, loss modulus and complex viscosity of the nanocomposite are higher than those of pp, while the loss factor is lower, that the complex viscosity of the nanocomposites is more sensitive to temperature, and that the flow activation energy and the crystallization temperature increase respectively by 15 % and 10k as compared with pp, which may contribute to the enhanced interfacial interaction between pp and ommt resulting from the addition of tmpp

    結果表明：與純聚丙烯相比，納米復合材料具有較高的動態彈性模量、損耗模量和復合粘度，力學損耗因子則降低，納米復合材料的復合粘度對溫度的敏感性略高於聚丙烯；界面改性劑的加入增強了有機蒙脫土與聚丙烯的界面作用，與聚丙烯相比，納米復合材料的流動活化能提高約15 % ，結晶峰溫度提高10k左右。
  4. The research results show that aggregate gradation and the nominal maximum aggregate size evidently influence the shear resistance of asphalt mixture ; aggregate flakiness content influences the shear resistance of asphalt mixture, and with the increase of aggregate flakiness content the shear resistance of asphalt mixture decreases ; asphalt binder properties, especially penetration, softening point and viscosity influence the shear resistance of asphalt mixture, and the latter increases with the decrease of penetration and the increase of softening point and viscosity ; asphalt content influences shear resistance of asphalt mixture, and with the increase of binder / aggregate ratio the shear resistance of asphalt mixture decreases ; air void influences shear resistance of asphalt mixture, and usually with the increase of air void the shear resistance of asphalt mixture decreases ; homogeneity does not have a direct and obvious relationship with absolute value of shear resistance of asphalt mixture, but does with variation of shear resistance of asphalt mixture

    研究結果表明：集料級配和公稱最大集料粒徑對瀝青混合料抗剪強度有顯著的影響；瀝青混合料抗剪強度受其集料中針片狀含量的影響較大，集料中針片狀含量增大，瀝青混合料抗剪強度減小；結合料的性質，特別是針入度、軟化點和粘度對瀝青混合料抗剪強度有較大的影響，隨著針入度減小，軟化點和粘度增大，瀝青混合料抗剪強度增大；含油量對瀝青混合料抗剪強度有較大影響，隨著油石比的增大，瀝青混合料抗剪強度減小；瀝青混合料抗剪強度受其空隙率的影響較大，一般隨著空隙率的增大，其抗剪強度減小；瀝青混合料均勻性與瀝青混合料抗剪強度絕對數值間沒有明顯的關聯，而與數值間的變異性有著很好的相關性。
  5. The density, viscosity, refractive index, molecular weight and sulfur amount of the fractions are on the increase with the increasing cumulative yield, while their molecular weight exhibits a narrow distribution from 300 to 400

    研究表明，隨累積萃取收率的增加，大慶和遼河油漿窄餾分的密度、粘度、折光率、硫含量及芳碳率呈增大趨勢，油漿窄餾分的相對分子質量分佈較窄（ 300 ~ 400 ） 。
  6. The obtained results indicate that compared with the clay layer, the liquefied sand layer takes a decreasing effects on the short period component of the surface ground motion and the effects increase with increasing of the thickness 、 depth and width of the liquefied sand layer ; the liquefied sand layer takes a increasing effects on the long period component of the surface ground motion but the effect is not obviously ; to the input earthquake wave, the demarcation point of strengthens and weaken is about 0. 6s

    主要結論為:和同樣的粘土層相比，液化層的存在對地表上地震動的短周期分量主要起減弱作用，且減震效果隨著液化層埋深、厚度的增加而變強;對長周期分量主要起加強作用，但是效果不太明顯;對所輸入的地震波來說加強減弱的分界點所對應周期為0 . 6s左右。
  7. Based on prandtl ' s momentum transportation, this paper calculates in detail the physical quantities such as eddy viscosities, and ratio of eddy viscosity to motion viscosity, total stresses with respect to relative position in three regions of viscous sub - layer, buffer layer, and main turbulent stream for non - newtonian fluid flowing turbulently in ducts, which according to karman ' s three layer models and measurement of fluid parameters in evaluation apparatus, discusses the influence of polymer drag reduction on flowing properties of non - newton fluid, analyzes quantitatively principle of turbulent reduction phenomenon and condition of increasing reduction rate

    摘要以普蘭德動量傳遞理論為基礎，按照卡門的三層模型，通過室內模擬環道用0號柴油及加入減阻劑在圓管內的流動參數的測定，計算了非牛頓型流體管內湍流邊界層的層流內層、過渡層、湍流中心的渦流粘度，渦流粘度與運動粘度比、總應力隨相對位置的變化等定量參數，探討了高分子減阻劑對非牛頓流體流動特性的影響，對湍流減阻現象的機理與增大減阻率的條件進行了定量分析。
  8. The results show that nano - particles affect the solution viscosity and crystalline properties of uhmwpe. owing to the strong interaction between nano - particles and pe molecules, the viscosity and e _ ( ) of uhmwpe solution increase with the increasing of nano - particles content

    實驗表明，納米粒子的加入對溶液粘度和uhmwpe的結晶性能均有影響，由於納米粒子和pe大分子及溶劑間有強烈的相互作用，使溶液粘度及粘流活化能均隨納米粒子的加入量的增加而增加。
  9. The early studies are mostly focused on the method of gluing piezoceramics on structural surfaces, which has some disadvantages such as difficulties to protect the ceramics and the connection wires, bad coupling with only one surface glued on the base materials, low signal - to - noise ratio etc. these problems can be solved using the embedded piezoceramics, and furthermore, the piezoceramics can be placed in the optimal positions, especially in the optimal deepness for the piezo - actuators, according to an optimization algorithm befor e they are embedded, so the actuator effects and sensor signals are thereby enhanced

    早期的研究主要集中在表面粘貼壓電片的結構，表面粘貼壓電片具有一些無法克服的缺點。本文著重進行利用埋入復合材料結構的壓電傳感器和壓電驅動器對其振動進行主動控制的相關理論和實驗研究，並介紹其相應結果。埋入型壓電材料的優點主要是能保護壓電傳感器和作動器及其連線、增強壓電材料和基體材料的耦合、優化埋入壓電陶瓷的深度和厚度可增強壓電傳感器的測量信號並提高信噪比等。
  10. Remarkably, the temperature must be limited between softening point and solidification value, at which the bond can get perfect fluidity and stickiness. effects of bond content and pressure on magnet product during heating - pressing process are the same with effects during common - pressing process. fourthly, it is more than 250 hours before magnet is eroded when it is coated with lacquer by way of cathode electrophoresis

    溫度對溫壓效果影響明顯，應當選擇在粘結劑軟化點以上、固化反應前的某一點，保證粘結劑具有適當的粘度和良好的流動性；與普通壓制工藝相同，溫壓工藝制備的粘結磁體密度和磁性能均隨壓制壓力的增大而提高，磁體性能和磁粉體積分數隨粘結劑含量變化的規律一致。
分享友人
分享到 Line

分享到臉書