瞬時出生率 的英文怎麼說
中文拼音 [shùnshíchūshēnglǜ]
瞬時出生率
英文
instantaneous birth rate-
Principal conclusions were drawn as the following : the non compatibility of pressure or velocity of the gas on both sides of the contact surface is the cause of the formation of shock wave ; the heating effect of reflective shock wave to driving gas during charging or exhausting process is the internal mechanism of peak oscillating effect, and all the factors that influence the formation and the running of the shock wave will influence the peak oscillating frequency, cooling effect
主要結論如下：熱分離機內激波形成的原因是射氣瞬間接觸面兩側壓力和速度不相容；峰值振蕩效應的內在機制為反射激波對充氣階段的驅動氣或低溫排氣的加熱，凡是影響激波形成及運動的因素都將對峰值振蕩頻率、冷效應及熱效應產生影響；當充、排氣時間比為0 . 1763時，最佳射流激勵頻率出現在高階峰值振蕩頻率上。Equations of mesh, shorting contact line, undercutting limit line, meshing limit lines and the existence conditions, angle between the direction of relative speed and the direction of contact line, induced normal curvature about every point on the contact line are established. moreover, the paper also theoretically analyzed the error of the grinded gear surface. on the basis of the theory, the computer program is worked out to automatically produce the contact line and the boundary curves of mesh. analysis of meshing circs under different parameters can be done so that we can gain the best process condition
首先對漸開面二次包絡理論進行了深入的探討，推導出了兩次嚙合的嚙合方程式、瞬時接觸線方程式、根切界限線方程式、嚙合界限線的方程式及其存在條件，相對運動速度方向與接觸線方向的夾角及接觸線上各點的誘導法曲率；此外，還對磨齒后工件的齒面誤差進行了理論分析；並在理論基礎上編制了相應的計算機程序，自動生成接觸線族及嚙合界限線，對不同參數條件下的嚙合情況進行分析，可以使工藝條件達到最佳狀態；最後研究了磨齒裝置，設計了磨齒機的傳動系統。This paper focuses on the control strategies to improve the performance of the three - phase ac - dc pwm voltage - source - converters ( vsr ) under unbalanced power supply. the problems such as negative sequences current, voltage and current harmonics and un - constant ( un - smooth ) power flow from ac to dc side are discussed in this paper. the analytical solutions for negative sequence current and harmonic current elimination are obtained by fully feed - forward of negative sequence voltage and producing a non - harmonic current command of the inner - loop
電網不平衡時，基於電網平衡為約束條件設計的三相vsr將出現不正常運行狀態，比如三相vsr交流電流中出現負序分量，使交流電流嚴重不對稱；直流電壓和交流電流中出現非特徵諧波分量，使直流電壓和交流電流波形發生嚴重畸變；三相vsr從電網吸收不平衡的瞬時功率等一系列問題。The transform uses the scale of the signal to decompose and make self - adapting frequency band partition of the input signals. therefore the amplitude value and the modulating frequency of the flickering signal can be obtained. with the instantaneous frequency in this method, the present study also analyzes the signal in terms of both time and frequency, and thus gets the time at which the flickering signal occurs and terminates
運用該變換從信號本身的尺度特徵出發對信號進行分解的特點，對輸入信號進行自適應的頻帶劃分，從而求出了閃變的調制信號幅值和調制頻率;利用該方法中的瞬時頻率概念，從時頻兩方面同時對信號進行分析，從而獲得了閃變信號的發生時刻和終止時刻，得到了較好的檢測效果。For those biological signals like echo of bat or whale, as well as man - made system signals like radar or sonar signal, the instantaneous frequency of signal component contains important information and could be used for signal model parameters extraction. so that the proper choose of transformed domain and signal characteristic extraction method is of crucial important. the ridge extraction method used for signal characterization was first proposed in the 1990s, it ' s based on the study of the phase of the wavelet ( or other linear ) transform
對于許多實際的信號，如蝙蝠發出的超聲波、鯨魚的叫聲等生物信號，以及雷達、聲吶等人造系統產生的信號而言，信號瞬時頻率的變化規律反映了信號重要的特徵，並且也是信號模型中關鍵的參數，因此選擇合適的變換域提取信號的瞬時頻率信息，並選擇合適的方法對信號進行重建是很重要的問題。The paper proves that in the 2d non - linear case, the coulomb gauge is been meet naturally. in the paper, the second - order isoparametric fem is adopted in the non - linear transient magnetic field simulating excited by current source and the results of transient field and static field solved by the second - order isoparametric and linear fem are compared and analyzed, besides, the effect of the eddy currents in the magnetic materials of the different conductivity is analyzed, it is obtained that the magnetic material of high magnetic conductivity and low loss should be chosen in designing of pma
文中採用二次等參元有限元法推導出在電流源激磁下的非線性瞬態磁場的計算方法和編制了相應的計算程序，並採用二次等參元有限元法和雙線性有限元法分別對瞬態場和靜態場進行了計算，並對計算結果進行了誤差分析，此外，還對不同電導率的導磁材料中渦流產生的影響進行了分析，得到結論設計永磁操動機構時，應選擇導磁性能好，損耗低的導磁材料。The content of this dissertation include : orthogonal transformation of digital signal ; mathematic model of modulation signals and software - defined radio receiver ; nine feature parameters of the modulation algorithm and threshold of feature parameter ; development procedure of modulation recognition by ccs and the modulation digital signals produced through matlab ; discussion on sampling speed and instantaneous frequency and analysis of experiment " s result
本文給出了在ccs集成開發環境下調制識別演算法模擬實現的程序設計和利用matlab模擬產生調制信號的方法；分析了調制識別演算法的模擬實驗結果；對采樣速率的選取、非弱信號段判決、瞬時頻率的計算以及演算法數據關聯性的簡化等方面進行了研究。分享友人