短纖維率 的英文怎麼說
中文拼音 [duǎnxiānwéilǜ]
短纖維率
英文
short fiber content-
Testing method for oil content of synthetic staple fibres
合成短纖維含油率試驗方法Experimental result shows that cavitation can destroy metal cyanogen preparation and chemical property of bearing cyanide wastewater is changed ; it intensify the fiber ' s adsorption progress and reduce the time of adsorption equilibrium, the general cyanide adsorption rate is increased 5 % or so, but it strength the different effect on different metal - cyanide negative ions ; strengthen effect of copper cyanide complex is stronger than zinc and iron cyanide complex, so ultrasonic wave may strength the fiber ' s adsorption processes
實驗結果表明，功率超聲的空化作用能破壞金屬氰配合物鍵，從而改變含氰廢水的化學性質，另外也可縮短吸附平衡時間，強化纖維的吸附過程，使總氰的吸附率可提高5 %左右；功率超聲對不同金屬氰配合物離子的強化效果是不同的，對銅氰絡離子的強化效果要強于鐵氰、鋅氰絡離子，所以功率超聲可以強化纖維的吸附過程。In spinning process, what should be done is to improve the coherence force of the fibers due to the linen fiber being thick, stiff, smooth, super long and containing more short fibers, causing difficulty to spinning ; in weaving it should focus on the settlement of unclear shedding and more ends breaking caused by fuzzy & poor elasticity of the warp yarn ; finishing plays an key role in improving fabric appearance to solve fold mark & frost mark and enhance style of peach skin and linen knot effects
紡部工序主要克服天絲與亞麻纖維抱合力低，特別是亞麻纖維粗、硬、滑、超長纖維和短纖維率高給紡紗工藝帶來的困難；織造工序重點解決成紗毛羽對開口清晰和經紗彈性差對斷頭的影響；后整理涉及影響外觀質量的摺痕與霜印問題，並要突出桃皮絨和獨特的亞麻麻節外觀效應。Distinctive centrifugal impeller to handle clean medium not containing solid particles, featured by little vibration, low noise and high efficiency ; open impeller to handle unclean liquid containing solid particles and short fiber, featured by stable operation and non - clogging
採用獨特的離心式葉輪，供輸送不含固體顆粒等清潔的介質，振動噪音低，效率高；採用開式葉輪，供輸送不清潔帶有固體顆粒及短纖維的液體，運行平穩、不堵塞。First, polytetrafluoroethylene ( ptfe ) composites filled with various contents of glass fibers ( gf ) and graphite were prepared by compression molding. the screening friction and wear tests were carried out in a reciprocating sliding tribotester. it is found that the optimal ptfe composite was a ptfe - 25wt. % gf - 5wt. % graphite amongst the composites
採用石墨與短玻璃纖維（ sgf ）填充ptfe ，制備出一系列ptfe復合材料，在往復式滑動摩擦試驗機進行篩選試驗，結果發現: ptfe - 25 % sgf - 5 %石墨復合材料的摩擦系數與比磨損率都比較低。The regressive equation that described the relationship between resistivity and strain are determined. to prove the applicability of the relationship, we composite the conductive composite material prepared by chopped carbon fiber mat with glass fiber reinforced composites of different strain character and study the relations of strain to resistivity under tensile stress
為證實該關系的適用性，通過將短切碳纖維氈制備的導電復合材料與具有不同應變性能的玻璃鋼復合，對拉伸狀態下應變與體積電阻率之間的變化關系進行了研究，並用多元回歸的方法進行了數值分析，確定了電阻率與應變之間變化的數學模型。Based on the characteristics of silicon whisker, the research on the modification of pa6 by silicon whisker sio2 - jx was made, and the result showed that the tensile strength, impact strength, brinell hardness, and heat resistance increased with the increase of the content of the whisker ; sio2 - jx could replace short glass fiber in the modification of pa6, improving the heat distortion temperature, removing the appearance of glass fiber, reducing shrinkage and the cost
摘要利用晶須矽纖維狀的特性，對其填充于龍玻纖改性進行研究，結果表明，隨晶須用量的增加，材料的拉伸強度、沖擊強度，布氏硬度、耐熱溫度均得到提高；晶須矽可取代短玻纖使用，提高熱變形溫度、消除玻纖外露，降低收縮率及生產成本等。Clk - proliferation cyclone applicable to the collection of non - fiber drying of granular dust is the main characteristics of a conical dongshen, thus reducing the dust since the dongshen gas exports to the centre to short - circuit the possibility and install a conical reflector screen to prevent the two air separation will have to roll up the dust down, brought out by the increased flow, thereby enhancing the efficiency of dust
Clk擴散式旋風除塵器，適用於捕集乾燥的非纖維性的顆粒狀粉塵，主要特點是筒身呈圓錐形，因而減少了含塵氣體自筒身中心短路到出口去的可能性，並裝有圓錐形的反射屏，防止兩次氣流將已經分離下來的粉塵重新捲起，被上升氣流帶出，因而提高了除塵效率。Regarding the lcm filling process as the newton fluid through fibrous reinforcements, the permeability of preform determines the saturating of resin in fiber, and has effects on the curing process and the quality of products. based on the darcy ' s law, the theoretical model of permeability measurement was established. and the influence of different testing methods and major process parameters such as fabric structure, fiber volume fraction, injection pressure, flow rate and resin viscosity on preform permeability were investigated in details
文中首先根據達西定律建立了滲透率測量的理論模型，深入研究了不同的測試方法及主要工藝參數（纖維織物織構、纖維體積含量、充模壓力、流動速度、樹脂粘度）對滲透特性的影響規律，發現多孔介質增強材料的滲透率主要取決于纖維織物的結構形式，預成型體孔隙分佈及其體積分數、壓實性對滲透率有較大的影響，提高充模壓力和流動速度可以縮短充模時間，在一定程度上可以提高滲透率。Standard test method for crimp frequency of man - made staple fibers
人造短纖維捲曲率的標準試驗方法The friction properties for dry spinning polyacrylonitrile fiber are studied, and the surface properties and friction factors include gliding, cohesive, the opu, fiber types and environment condition are analyzed
摘要對聚丙烯腈干法紡絲短纖維表面摩擦性能進行了研究，分析了纖維表面的形態與摩擦性能的關系，對影響纖維摩擦性能的纖維含油率、環境條件及纖維規格等因素進行了探討。Two different reinforcing methodologies are applied : modification of the overlay characteristics by adding chopped glass fibers to the hot mixture asphalt ( hma ) and reinforcing asphalt overlay with glass grids. theory of fracture mechanics ( fm ) is employed to determine crack growth rates for the suggested anti - cracking overlay systems. asphalt mixture designing tests, three point bending tests and fatigue crack propagation tests were carried out. the critical stress intensity factors kic are determined for plain and reinforced asphalt concrete. depending on the fatigue crack propagation, the crack growth rate is determined for each type of anti - cracking system and the cracking process is also analyzed. one of the significant points in this study is the attempt to give better understanding of the crack propagation for multilayer asphaltic overlay or what are suggested herein to be called composite structure anti - cracking overlay system. the results indicate that the reinforcing materials improve anti - cracking characteristics of the asphalt concrete. composite structure anti - cracking overlay gives a good solution for the reflective cracking phenomenon over old cracked pavements
利用2種不同的方法加筋瀝青罩面:在瀝青混合料中加入短切玻璃纖維改善瀝青混凝土的特性，採用玻璃格珊加筋瀝青混凝土.應用斷裂力學方法分析瀝青路面裂縫擴展機理.採用瀝青混合料設計試驗、三點彎曲試驗和疲勞裂縫擴展試驗，確定加筋瀝青混凝土的臨界應力強度因子kic ，測量每一種瀝青罩面抗裂系統的裂縫擴展速率.本研究的主要特點是提出復合型抗裂罩面系統，分析了多層加筋瀝青罩面裂縫擴展過程，推薦了若干瀝青路面抗裂系統.結果證明，加筋材料可以提高瀝青罩面的抗裂特性，復合型抗裂罩面系統能夠有效地阻止反射裂縫的擴展By optimizing and controlling the technology conditions of grey yam linear density, spinning speed, stretching temperature, stretching ratio, tension - setting and shrink - setting, the polyester staple with shrinkage rate over 20 % was successfully developed with normal polyester chip
通過對原絲線密度、紡絲速度、拉伸溫度、拉伸倍率、緊張熱定型及鬆弛熱定型等工藝條件的優化和控制，採用常規聚酯切片成功開發出收縮率在20 %以上的滌綸短纖維。The technology conditions that have effect on polyester shrinkage rate were discussed
摘要探討了影響滌綸短纖維收縮率的工藝條件。分享友人