砂填充物 的英文怎麼說

中文拼音 [shātiánchōng]
砂填充物 英文
sand fillings
  • : 名詞(沙子) sand; grit
  • : 動詞1. (墊平或塞滿) fill; stuff 2. (補足; 充滿) replenish; supplement; complement 3. (填寫) fill in; write
  • : Ⅰ形容詞(滿; 充足) sufficient; full; ample Ⅱ動詞1 (裝滿; 塞住) fill; charge; stuff 2 (擔任; ...
  • : 名詞1 (東西) thing; matter; object 2 (指自己以外的人或與己相對的環境) other people; the outsi...
  1. The channel is filled with noncompactible sand, or with sand and gravel.

    水道內由不可壓實的
  2. The variations in trace element contents and ratios may hold up a mirror to the lake - level fluctuations and climatic changes, which, in turn, have exerted a direct and important effect on the sequence stratigraphic development. collectively, the reservoir rocks from the yanchang formation consist dominantly of the delta front subfacies subaqueous distributary channel and channel - mouth bar microfacies and delta plain subfacies subaerial distributary channel microfacies fine - grained feldspar sandstones and siltstones. the reservoir rocks have been subjected to three stages of diagenetic and porosity evolution : ( 1 ) the porosity reduction by the mechanical compaction and chemical pressure solution during the early diagenetic stage ; ( 2 ) the porosity increase by the dissolution during the a substage of the late diagenetic stage, and ( 3 ) the porosity reduction by the cementation and filling during the b substage of the late diagenetic stage

    系統的儲層特徵研究表明,該區延長組儲層成因類型主要為三角洲前緣水下分流河道、河口壩及三角洲平原水上分流河道微相細粒長石巖、粉巖;儲層巖石經歷了壓實,膠結,溶蝕等成巖作用,歷經早成巖機械壓實和化學壓溶孔隙縮小期、晚成巖a亞期溶蝕作用孔隙擴大期及晚成巖a亞期( b亞期)膠結孔隙縮小期三個成巖-孔隙演化階段;儲層性總體上具有較低孔滲、低孔滲的特點,孔隙類型主要為粒間溶孔、殘余粒間孔隙、粒內溶孔、晶間孔及晶間溶孔,裂縫不發育,儲集巖排驅壓力和中值壓力較高,孔隙結構類型以細小孔-微孔隙,微細喉-微喉型為主。
  3. The sediments of the incised valleys show an upward - fining succession, and can be grouped into four sedimentary fades : gravel lag - deposit of in - channel to partly over bank sediments of a meandering river, flood plain - estuary, estuary - shallow marine, and estuary sand bar, based on lithology, paleontology, and sedimentary textures and structures

    根據巖石學、沉積結構和沉積構造特徵,本區下切河谷沉積具有向上變細的沉積層序,可以劃分為4個沉積相類型:河床滯留沉積到部分曲流河沉積體系的邊灘沉積、河漫灘河口灣沉積、河口灣淺海沉積和河口灣壩沉積。
  4. This article introduced the method of geological investigation of nanling tunnel karst disease, elaborated the tunnel engineering geology conditions, especially the karst water, the karst water power channel and the harm of karst water, and analyzed the cause that produced the karst disease

    摘要南嶺隧道巖溶地下水活動造成地表坍陷、洞內泥淤塞等病害,其原因在於隧道施工遺留的導洞長期疏排巖溶水,採用地質測繪、探、鉆探、水文地質試驗等綜合勘察方法,查明地下水通道位置、地下水流速、流向,針對病害原因,提出攔截、封團、疏排、等綜合整治方案。
  5. Dreparing gold tailings stabilized fill witu cold binding material of tailings agglomeration

    用冷粘結尾礦團聚配製全尾膠結
  6. The further study shows that the sandstones at the bottom of the lower ganchaigou formation, which is a tr lithostratigraphic unit, were deposited in different stages of base level cycle, and they are not chronostratigraphic unit. so, to identify different sequences, especially high order sequences in analysis of terrestrial stratigraphic sequences, the sequence distribution feature must be fully consided. this view has practical significance for recognizing forming, evolution and filling history of qaidam baisn correctly, and has both theorical and practical meaning for directing further oil exploration

    研究還表明,傳統巖石地層單位中下乾柴溝組底部的巖代表了基準面變化旋迴不同階段沉積的產,它們屬于不同的成因單位,也非等時地層單位,因此,在進行陸相層序地層分析時,各級層序尤其是高級層序的識別要分考慮面上的層序展布特點,這一觀點對正確認識柴達木盆地的形成演化和沉積歷史,指導今後的勘探具有一定的理論和實際意義。
  7. A full - scale review of the nonmetal mineral filler to improve the strength and toughness of the resin matrix materials in the domestic and overseas is presented. based on the theory and experiment, the mechanism of the fsmf filler to build up the strength and toughness in the resin matrix composite materials is studied ; the relation of the mechanical property of the resin cast and the content of the fsmf is obtained ; the elasticity modulus of the fsmf powder is estimated by analysis method and cmm method ; in the end, fsmf used in rpmp is discussed

    本文對非金屬礦樹脂復合材料增強增韌的國內外研究現狀進行了較全面的評述;在理論和實驗的基礎上,研究了fsmf樹脂復合材料增強增韌機理;進行了fsmf樹脂澆鑄體的有關力學性能測試,獲得了fsmf樹脂澆鑄體的有關力學性能與fsmf含量的關系;利用解析法和cmm法,估算了fsmf粉體的彈性模量;最後探討了fsmf在玻璃鋼夾管道中的應用。
分享友人