磁能密度 的英文怎麼說

中文拼音 [néng]
磁能密度 英文
magnetic energy density
  • : 名詞1. [物理學] (磁性; 能吸引鐵、鎳等的性質) magnetism 2. (瓷) porcelain; china
  • : 能名詞(姓氏) a surname
  • : Ⅰ名詞1 (秘密) secret 2 [紡織] (密度) density 3 (姓氏) a surname Ⅱ形容詞1 (距離近; 空隙小)...
  • : 度動詞[書面語] (推測; 估計) surmise; estimate
  1. Zmd catena of self inhale magnetic force pumps adopt structure of electrical engine direct link form, by centernog prop up, the structure is tightly, teardown and maintenance is convenient, adopt high - powered magnetism stuff nd fe boron to make inside and outside magnet. isolationsheath assembled make of import nonmetallic material, avoid magnetism backset ullage of the run - of - mill pumps have drastically

    Zmd系列自吸力泵採用電機直聯式結構,由中間支架支撐,結構緊湊,拆卸維護方便,採用高性性材料「釹鐵硼」製造內外體,隔離套採用進口非金屬材料,徹底消除了一般力泵具有的渦流損耗,可輸送高濃大於1 . 84 t m
  2. Radiation spectrums of relativistic charged particles in a dipolar magnetic field were studied numerically in detail by using the current density of moving charged particles in this paper

    摘要從運動的荷電粒子產生的流出發,研究了在地球偶極場中運動的相對論性荷電粒子的輻射量譜,並對其進行數值計算。
  3. The highest density and the low resistivity and the best magnetostriction in a composite rod were obtained when the proportion of binder to powders " weight is 4 : 100

    膠與性粉末的質量比為4 : 100時,粘結體的最高,電阻率最低,致伸縮性最佳。
  4. Value, and the current density and intensity versus the substorm phases. moreover, the characteristics of substorm current wedge are given special attention. it is found that the density and intensity of facs reach their peak during the expansion phase, the onset of the expansion phase is triggered when imf is changed to southward from northward or the southward imf decreases, and the positions of onset are most likely to be at the edge of plasma sheet near the earth

    值分佈以及場向電流強隨亞暴位相的變化,並著重分析了亞暴電流楔的特徵。結果表明,亞暴膨脹相的場向電流強都達到極大值亞暴的膨脹相是由行星際場轉向或南向分量變小觸發的,其起始位置很可位於近地等離子體片內邊緣。
  5. Nowadays with the booming development of microelectronic technique, the functions of the components of machinery, electricity, magnetism, optics, acoustics and thermotics have been improved rapidly. and the micromation of components, the integration of electronic equipments, the worse working environment, the increasing requirement and emi, all of these make the structural design of electronic equipments more and more important

    在微電子學高發展的今天,促使機、電、、光、聲和熱等元器件功飛速提高,隨著元器件微型化,電子設備趨向集成化,再加上一些日趨惡劣的工作環境,各種使用要求的提高,空間電環境的干擾,以及由於裝填高,產生的內在干擾等,使得電子設備的結構設計變得越來越重要。
  6. Hollow ferrites particles are the alternative to conventional solid ferrites particles, which have lower density, larger specific surface area and stability. moreover, it is expected electromagnetic wave can be reflected and absorbed again and again in the cavum of hollow particles which become its black hole. in addition, their electromagnetic parameters can be adjusted in a certain range by changing the thickness of the shell and the diameter of hollow microspheres, and the ability of absorbing microwave can be expected to improve

    空心結構的鐵氧體是對傳統實心鐵氧體的改造,不僅小,還具有特殊的電、,有可使電波在其空腔中反復振蕩吸收,成為電波的「黑洞」 ,從而增加材料的吸波力,同時可通過調節核殼粒子的內外徑來調控電參數。
  7. After studying the relation of distributive function and density matrix, the electron energy is calculated in magnetic field according to the distributive function in the thermodynamic statistical physics and the density matrix average value principle in the quantum mechanics, respectively

    摘要研究正則系綜中的配分函數與矩陣的關系,分別採用熱力學統計物理中的配分函數和量子力學中的矩陣與平均值原理,計算電子在場中的量。
  8. The entropy or number of states of system or subsystem are closely related to interaction of particles and energy level distribution, therefore, to study the temperature dependence of the specific heat may supply some important and useful microscopic information which may play an important role in understanding electronic structure, density of state, phonon spectrum etc. the specific heat measurements at low temperatures also play important roles in the finding of the third law of thermodynamics, the quantum theory of solid and bcs theory for superconducting etc. moreover, specific heat measurements help us to understand the different kinds of phase transitions ( such as : structural phase transition, magnetic phase transition, superconducting phase transition etc. ) and the scaling behavior near the critical point

    系統、子系統的熵或微觀狀態數與微觀粒子間的相互作用及級分佈切相關,因此研究比熱與溫的依賴關系夠提供被測量系統許多極其有用的微觀信息,對理解固體的電子結構、電子態、聲子譜等起著十分重要的作用。低溫比熱的測量和研究對熱力學第三定律、固體量子理論和超導bcs等理論的建立起到了積極的推動作用。比熱研究還有助於認識各類相變如結構相變,性相變,超導相變等及臨界點附近的標規律。
  9. As a new type of functional material which has been developed in recent years, rare earth - iron giant magnetostrictive materials has many advantages, such as large magnetostriction strain, high coupling coefficient, quick response, high energy density and so on, which make it have good application future in fields of precision driving and microdisplacement based on the new type of functional material, this paper uses new principles and approaches to study this kind of microdisplacement actuator and its precision driving system

    稀土鐵系超致伸縮材料就是近年來發展起來的?種新型的功材料,具有致伸縮應變大、機耦合系數高、響應速快、高等優點,已在精驅動及微位移執行器等領域顯示出良好的應用前景。本論文以這種新型的功材料為基礎,以基於該類材料的微位移執行器及其精驅動系統為研究對象,並採用一些新的原理和方法,為新型、高性微位移執行器及其精驅動系統的研究提供一個新的途徑與思路。
  10. Analysis for magnetic field of srm is very complicated since the flux waveforms in different parts of the motor vary with motor phase, stator pole and rotor number, also with the winding connections, etc, which results in the srm losses, especially iron loss calculation difficult. the temperature analysis due to the losses has become a study hot spot

    Sr電機鐵心的通波形不僅與電機的相數有關,還與定、轉子齒極數、定子繞組連接方式等切相關,從而使得sr電機場分析很復雜,復雜的波形導致電機損耗特別是鐵損的計算非常困難。電機的損耗又會引起電機的溫升,因此高性的sr電機的熱分析也成為目前的研究熱點。
  11. This paper systematically discussed the fundamental, characteristics, research status and equipment of microwave sintering, and introduced the preparation and development of sintered ndfeb magnets, on the basis of which the effects of the parameters on the heating rate and sintering temperature were investigated. and by means of optical metallurgical analysis, x - ray diffraction analysis and the measurement of density and magnetic properties, the paper compared the properties and technology of ndfeb magnets sintered in microwave magnetic field with that of magnets sintered in conventional heating process

    本文系統論述了微波燒結基本原理、特點、研究現狀和燒結設備,介紹了燒結ndfeb制備工藝和發展,在此基礎上研究了微波場燒結ndfeb永材料過程中各因素對升溫速率、燒結溫的影響,並通過金相顯微分析、 x射線衍射分析、測試等手段,將微波場燒結的ndfeb體與常規燒結的體進行了工藝與性的對比分析。
  12. Scattered ions from the au foil passing through the q3d magnetic spectrometer, recoiled au ions were deflected, pure ions with single energy and single linear energy transfer were obtained

    經過q3d譜儀的偏轉,去掉反沖au離子和其它雜散粒子,得到具有單一線傳( let )值的離子。
  13. It is found that the fwm field can cause the asymmetry of electromagnetically induce transparency profile. in addition, the effect of different propagating orientations of probe field on the electromagnetically induced transparency is also discussed. in the molecular multi - level system with the perturbed superposition levels, we discuss the electromagnetically induced transparency, spontaneous emission enhancement, double dark resonance and double electromagnetically induced transparency by using the density matrix equation under weisskopf - winger approximation and dressed - state density matrix equation

    針對實際的實驗條件,考慮了一種影響量子干涉的新的因素-四波混頻場,研究了四波混頻場對雙光子探測的-型級體系的eit的影響,發現四波混頻場夠導致雙光子探測的eit線型的不對稱,在此基礎上,討論了不同探測場的傳播方式對eit的影響,針對分子中實際存在的包含有微擾級的不同多級系統,我們分別採用綴飾態繪景下的矩陣方程和weisskopf - wigner近似下的矩陣方程詳細地討論了電感應透明、自發輻射的干涉相消和相長、雙暗態共振和雙電感應透明現象。
  14. According to the requirements of propeller aerocraft model test in wind tunnel, specifications of the driven motor is presented by aerodynamic analysis, and a short - term operated high power density three - phase induction motor is developed with reasonably designing the motor, such as electromagnetism load, heat checkout and high - efficiency heat exchanger

    摘要針對螺旋槳飛機模型帶動力風洞實驗要求,通過氣動性分析提出驅動電機的技術指標,在滿足結構約束的條件下,通過合理設計電機的電負荷、校核發熱、採用高效冷卻裝置等,研製出短時工作制高功率三相異步電機。
  15. Magnetostatic energy density

  16. When designed, the high - speed generator with a permanent magnet ( pm ) rotor is preferred because of its simple structure, without excitation high energy density of the pm material

    轉子式高速發電機由於具有結構簡單、不需勵、效率高和大等優點成為高速發電機設計時的首選。
  17. The hybrid claw - pole alternators have magnetic fields contributed by permanent magnet as well as excitation coil, and the advantages are high efficiency, have good low - speed characteristics, excitation adjustable and high flux densities. for the reason of complex claw - pole construction and 3 - d magnetic field distributions, there is lack of the research on the alternators

    混合勵爪極發電機是由永體和勵線圈共同產生電機場的一種發電機,與傳統的爪極發電機相比有高效、低速性好和集線圈勵的電壓調節性與高的優點,具有很好的研究前景和使用價值。
  18. The emcn model is set up by use of flux - tube method. in this method, the segment in which the flux density is relatively even is considered to be an element, the permeance of each element can be calculated by use of conventional method. finally the permeance network can be set up by connecting each node with permeances, then the parameters and performance can be obtained

    其基本思想是通過通管原理,把電機內部相對均勻的部分看作一個單元,計算出單元的導,最後再把各個節點用等效導連接起來構成一個導的網路圖,再根據電路的基本解法求得各個節點的位,從而求得電機的參數和性
  19. Gmr head technology - increased areal density and improved performance

    大型頭gmr head技術-增加及改善性
  20. Remarkably, the temperature must be limited between softening point and solidification value, at which the bond can get perfect fluidity and stickiness. effects of bond content and pressure on magnet product during heating - pressing process are the same with effects during common - pressing process. fourthly, it is more than 250 hours before magnet is eroded when it is coated with lacquer by way of cathode electrophoresis

    對溫壓效果影響明顯,應當選擇在粘結劑軟化點以上、固化反應前的某一點,保證粘結劑具有適當的粘和良好的流動性;與普通壓制工藝相同,溫壓工藝制備的粘結均隨壓制壓力的增大而提高,體性粉體積分數隨粘結劑含量變化的規律一致。
分享友人