穩態響應 的英文怎麼說

中文拼音 [wěntàixiǎngyīng]
穩態響應 英文
stationary response
  • 穩 : 形容詞1 （穩定; 穩當） steady; stable; firm 2 （穩重） steady; staid; sedate 3 （穩妥） sure; rel...
  • 態 : 名詞1. （形狀; 狀態） form; condition; appearance 2. [物理學] （物質結構的狀態或階段） state 3. [語言學] （一種語法范疇） voice
  • 應 : 應動詞1 （回答） answer; respond to; echo 2 （滿足要求） comply with; grant 3 （順應; 適應） suit...
  1. Integrating the power flow program with the tools matlab simulates the transient response of the distribution networks with the direct combination wind generator under disturbances, it provides the credible rationale to the research on stability and maximal penetrable power

    本文結合配電網潮流程序，利用matlab作為模擬工具，模擬包含直接並網風能轉換系統的配電網路在受到擾動情況下的暫態響應，對含有風電場的電力系統穩定性研究及風電場極限穿透功率的研究，提供了可靠的理論根據，有重要的現實意義。
  2. An acceptable system must at minimum satisfy the three basic criteria of stability, accuracy, and a satisfactory transient response

    一個可接受的系統必須至少滿足：穩定性、精度和滿意的瞬態響應這三個指標。
  3. Igbt power modules, 25khz inverterfrequency, fast response time, high arc stability, almost spatter - free welding

    採用igbt模塊，逆變頻率達25khz ，動態響應速度快，穩弧性能好，焊接飛濺極小。
  4. Igbt power modules, 18khz inverter frequency, fast response time, high arc stability, almost spatter - free welding

    採用igbt模塊，逆變頻率達18khz ，動態響應速度快、穩定性能好、焊接飛濺極小。
  5. The efficiency of the pump are calculated and simulated ; the stability, quickening and sensibility relating to dynamic response are analysized ; the effects of some parameters on system performance are discussed and the way to improve performance is pointed out at the same time

    計算和模擬了不同條件下對泵效率的影響；分析了動態響應的穩定性、快速性和靈敏性；探討了系統參數對其性能的影響，並提出了改善系統性能的途徑。
  6. 3. according to the principle of the finite element method, the research establishes finite element models of the vibration transportation mechanisms, some model parameters such as the frequency and vibration type are confirmed and validated by the modal analysis, then which analyzes dynamic - state response of the model and confirms the swing distributing of the models, thereby make the design of models precise. 4

    根據有限元法的理論，建立振動機構的有限元力學模型，對該力學模型進行模態分析，通過模態分析確定拋秧機振動形態和所需的頻率等參數；然後此基礎上再進行力學模型的穩態響應分析，研究該模態下機構的振幅分佈，以確定模型設計的準確性。
  7. The highly precise direct integration scheme is used for solving modal dynamic differential equation of the structure and a dynamic load identification method by the modal respondence is proposed

    採用無條件穩定的精細逐步積分法求解結構的模態動力學微分方程，構造了通過結構的模態響應直接反求荷載列陣的迭代演算法。
  8. The steady - state response of a counter - rotating dual - rotor structure with one inter - shaft bearing was analyzed, of which the low pressure rotor is coupled with the inter - shaft bearing ' s outer ring, and the high pressure rotor coupled with the inter - shaft bearing ' s inner ring

    分析了一種具有中介軸承的反向旋轉雙轉子結構的穩態響應，其中介軸承外圈與低壓轉子聯接，內圈與高壓轉子聯接。
  9. The frequence and modal of main stream piping were analysed under the condition of different velocity of stream and the valve taken as the centralizing mass. this paper also gives the responses of steady state under the condition that the frequency of forced vibration is 4hz 、 8hz 、 12hz respectively

    將閥門作為集中質量處理，分析計算不同蒸汽流速下，某汽輪機主蒸汽管道系統的振動頻率和振型，並給出了激振力頻率分別為4hz 、 8hz 、 12hz時該管道系統的穩態響應。
  10. The developments of high - speed circuits and mmic pose the problem of analyzing the circuits characterized both in time and frequency domains. a variety of mixed time - frequency methods have been developed during the last quarter century in the research of the vlsi interconnect and package analysis and nonlinear steady - state analysis. this paper examines these methods from a unified point of view. various mixed problems are formulated as circuit equations in the mixed time - frequency domain. fundamental approaches to slove the equations are given, from which all of the published mixed methods can be naturally deduced. this facilitates the comprehension of these methods and is helpful for their applications. some new ideas are proposed based on the cross reference among these different kinds of methods

    隨著高速集成電路及mmic （微波單片集成電路）的發展，提出了對時-頻混合表示電路進行分析的任務.本文用統一的觀點考察了通常屬于高速電路互連與封裝分析、非線性電路穩態響應分析兩個不同方面的混合分析問題，指出這類問題的實質是要求解一個時-頻混合的電路方程，給出了求解這一方程的基本思路，闡明了現有的各種方法是如何從這一基本思路導出的.這可為認識這些方法的本質與聯系，促進它們的應用與發展提供參考.此文還探討了某些方法之間的相互借鑒，提出了若干新的想法
  11. In chapter 3, the non - linear equation was linearized with the jacobi matrix, and then the linearized equation was transformed into fixed frame to analyze the stability problem with eigenvalue method ( on - ground or hovering ) or floquet theory ( forward flight ). meanwhile, the equation was perturbed by sweep frequency excitation from steady state to get transit decay of lag response which was then transformed into fixed frame with a numerical fourier coordination transformation ( fct ). the fixed frame response along with the body response was analyzed via an fft to determine modal frequencies

    然後，在穩態響應的基礎上利用雅各比矩陣對非線性方程進行了線化，線化后的方程利用多槳葉坐標變換轉換到固定系下后，利用直接特徵值分析（地面、懸停）或floquet理論（前飛）對系統進行了穩定性分析;同時，對系統進行了瞬態響應分析;在系統達到穩態的基礎上進行掃頻激勵，用fft變換求得系統頻率，進而用移動矩形窗方法分析得到系統的阻尼。
  12. Using the displacement functions and the technique of double fourier transform, the governing differential equations for transversely isotropic saturated poroelastic media are easily solved and, the fourier transformed stress and displacement solutions coorespondingly are obtained. then, under the boundary conditions, the analytical solutions for half - space are presented

    藉助位移函數及雙重fourier變換，研究了直角坐標系下橫觀各向同性飽和土的動力響應問題，得到了飽和半空間體在任意分佈的表面諧振荷載作用下穩態響應的一般解。
  13. Steady state response of the coupled lateral - torsional vibrations of geared rotor system under a holonomic constraint

    完整約束下齒輪嚙合轉子系統的彎扭耦合振動穩態響應
  14. Bode plots of the system transfer function are used to determine the effects of various inputs ( including a step ) upon the steady - stat response of the system

    系統傳遞函數的伯德圖可以用於確定各種輸入（包括階躍輸入）下系統的穩態響應。
  15. Since the frequency response is a steady - state response, the system must be stable and its stability must be determined before the system bode plots can be used

    因為頻率響應為穩態響應，所以系統必須是穩定且其穩定性必須在繪制伯德圖之前確定。
  16. The two kind of harmonic balance methods, analytical hbm and dft numerical hba, are used for the analysis of the parametrically excited flexible cam - follower system with consideration of the clearance between cam and follower. through the two methods, the system equation is reduced to a series of nonlinear algebraic equations

    這種非線性代數方程組需要依靠數值計算的迭代法才能求解，而由於問題的復雜性，普通的newton法很難求解，本文採用一種廣泛應用的擬newton法一一broyden方法來求解，得出了出含間隙凸輪系統模型的穩態響應。
  17. In this system, the soft hardware complex - compensate technique is adopted to enhance the precision of temperature control, the analog pi controller, whose parameters are adjusted by analog fuzzy controller, is designed to enhance the stationary response

    該溫度控制系統利用軟硬體復合補償的方法提高溫度控制的精度，利用模糊參數可調的模擬pi控制器提高系統的穩態響應。
  18. In this paper, the study method is adopted for employing matlab to simulate the transition feature of track circuit, the steady - state response of track circuit is simulated when the alternative sine wave signal is inputted, and the corresponding results are interpreted

    城市軌道交通的迅速發展要求對軌道電路的特性有深入的了解。本文採用matlab軟體模擬軌道電路的傳輸特性，對軌道電路在正弦交流輸入下的穩態響應進行了模擬，得到了相應的的模擬結果和曲線圖。
  19. Using this method, the simulation can be performed with large step ( low order wavelet ) for transient state response, and small step ( high order wavelet ) for steady state response so that the excessive computing time for transient state simulation can be saved

    該方法可以對電路瞬態響應過程用大步長（低階小波）模擬，而對穩態響應過程用小步長（高階小波）模擬，從而避免了為得到電路穩態響應而在瞬態響應時期花費大量的模擬時間。
  20. The sensor is calibrated, then the relative curve of heat flux vs thermal voltage is determined. moreover, the test of responses of steady state and transient state has been done and the results are compared with predecessors ? results, and proved to be advanced in response speed

    在此基礎上對薄膜熱流計進行了穩態響應測試和瞬態響應測試，並與國外的結果進行了比較，結果表明，該熱流計在響應速度方面較快，在靈敏度方面稍低。
分享友人
分享到 Line

分享到臉書