空氣管系 的英文怎麼說

中文拼音 [kōngqìguǎnxì]
空氣管系 英文
air duct network
  • 空 : 空Ⅰ形容詞（不包含什麼; 裏面沒有東西或沒有內容; 不切實際的） empty; hollow; void Ⅱ名詞1 （天空） s...
  • 氣 : Ⅰ名詞1 （氣體） gas 2 （空氣） air 3 （氣息） breath 4 （自然界冷熱陰晴等現象） weather 5 （氣味...
  • 管 : Ⅰ名詞1 （管子） pipe; tube 2 （吹奏的樂器） wind musical instrument 3 （形狀似管的電器件） valve;...
  • 系 : 系動詞（打結; 扣） tie; fasten; do up; button up
  • 空氣 : 1 （大氣） air; atmosphere 2 （氣氛） atmosphere 3 （氣閘） air brake4 pneum ; pneumo ; pneumat ;...
  • 管系 : piping; solenium; solenia tubulature; solenia; line piping; pipe arrangement; piping line; system...
  1. Air braking systems - air filter for pipes

    空氣制動系統.管道的空氣過濾器
  2. Metric nonmetallic air brake system tubing

    米制非金屬空氣制動系統管路
  3. Abstract : apply computer simulation to the distribution pattern of air - flow without considering the cold condition of the combustion and compare the flow patterns under different designed circumstances. and the effect of the design of the partition in the air way of the burner on the flow and mixture of gas and air is especially studied. the result shows that the design of partition plays a very important role in strengthening the mixture of gas and air, but increases the loss of the resistance in the air way and the total pressure of the air way in same working conditions needs increasing

    文摘:應用計算機模擬的方法，在不考慮燃燒的冷態情況下，研究了熱風爐燃燒室內的氣流分佈規律.在此基礎上，比較了2種不同設計方案的氣流流動特徵，尤其是研究了燃燒器空氣通道內阻流板的設置與否對空氣和煤氣的流動和混合的影響.結果表明，阻流板的設計對加強空氣和煤氣的混合有著極為重要的作用，同時也增加了空氣管道的阻力損失，在同樣的工況條件下需要提高管道系統的總壓力
  4. These manifolds are connected to the vacuum system through air take - off lines in order to remove the non - condensable gases from the condenser

    這些集管通過空氣管線與抽真空系統相連，以便從空冷凝汽器內抽走不可冷凝的氣體。
  5. Second, the starting and stopping behaviors under disturbed condition are analyzed and calculated by using the dynamic concentrative parameter model, which gives some advice to better prescribe refrigeration system and set theoretic foundation for carrying out automatic control of refrigeration system. third, the normal running process is analyzed and calculated by means of rational matching theory, which gives some advice on how to better understand the parameter change under steady state and the affection of inlet - parameter on evaporator. fourth, the simulation software with dynamic characteristic is designed, which can be applied to calculate thernio - parameter of cryogen, air humidity and frost thickness under different initial and boundary conditions, and to carry out dynamic simulation under conditions of dryness, wetness and frostiness, at the same time, to achieve detection and simulation at any stage from starting to stopping

    本文的主要內容如下： 1 ）對翅片管蒸發器結構特點進行分析，選取適當的微元控制體，就干、濕和霜工況下對每個微元分別進行傳熱傳質分析，基於經驗關系式確定霜的有關參數，對于霜工況下的霜生長建立模型，經適當假設，運用質量守恆、能量守恆和動量守恆方程建立適合動態模擬的蒸發器數學模型，為系統模擬奠定基礎； 2 ）對蒸發在大擾動下的開、停機過程，運用動態集中參數模型進行分析和計算，為更好地描述製冷系統運行的全過程奠定基礎，同時也為製冷系統實現自動控制提供一定的理論基礎； 3 ）對蒸發器正常運行過程，運用動態分佈參數和參數間定量耦合的觀點來分析和計算，為更好地了解穩態工況下各點參數的變化情況及各入口參數對蒸發器動態特性的影響即蒸發器性能對各參數變化的敏感性； 4 ）編寫翅片管蒸發器動態特性模擬計算程序，可以計算不同邊界條件和初始條件下的製冷劑熱力參數、空氣溫濕度和霜厚度分佈場，實現對翅片管蒸發器在干、濕和霜工況下的動態模擬。
  6. In a transparent plexiglas column with inner diameter of 600mm, the comparison of downcomer capacities between ctst tray and fl valve tray were studied with the air - water and foaming systems

    在600mm的透明有機玻璃塔中，採用空氣?水和易發泡物系，對兩種塔板的降液管操作能力進行了比較研究。
  7. Wearproof porcelain plate developed by this factory can be used as inside lining plate, coal delivery pipework, bin, bunker, separation port, wind pipe bend, exhauster, inner pipe of mill fan, air preheater, air fule and various dedust equipment for antifriction. besides, it can extend the service life of equipment

    耐磨瓷板系是我廠自行研製的適用於磨煤機內襯板，輸煤管道、料倉、料斗、粗、細粉分離口、一、二次風管彎頭、引風機、排粉機內殼、空氣預熱器、尾部煙道等以及各類除塵系統設備的防磨抗蝕、延長設備的使用壽命。
  8. Its current products include : top oscillation electrical precipitator, side electrical oscillation precipitator, magnetism controlled static electricity precipitator, wet electrical precipitator, honeycomb electric catching tar instrument, high - pressur silicon rectifier equipment and plc low - pressure controlling system, blast furnace gas impulse precipitator, high concentration pulverized coal collector, coke oven and boiler flue gas low pressure impulse precipitator, blower fan inhaler, crossing piping gas cooler, high temperature fume cooler, gyre - orientation impulse hop - pocker and all sorts of molded sections

    目前主要產品有：頂部振打臥式電除塵器、側部振打電除塵器、磁控靜電除塵器、濕式電除塵器、蜂窩電捕焦油器、高壓硅整流裝置及plc低壓控制系統、高爐煤氣脈沖除塵器、高濃度煤粉收集器、焦爐及鍋爐煙氣用低壓脈沖除塵器、風機空氣過濾器、橫管式煤氣冷卻器、高溫煙氣冷卻器、回轉定位脈沖大布袋及加工各種冷彎型鋼。
  9. Our factory mainly manufactures hydraulicfllfers, filter oil vehicles, hydraulic air cleaner, liquidlevel gage and liquid thermometer, liquid level control relay, switch of manometer, combined sealing washer, piezometer soft tebe assembly, andso on. we also carry on all kinds of non - standard, and bring in filters, air cleaner, liquid - level gage and liquid thermometer and complete set of design and manufacture of hydraulic system

    本廠主要生產各類液壓過濾器、濾油車、液壓空氣濾清器、液位液溫計、液位控制繼電器、壓力表開關、組合密封墊圈、測壓軟管總成、塑料管夾等產品，還承接各類非標、引進過濾器、空氣濾清器、液位溫計及成套液壓系統設計與製造。
  10. This article aims at the boiler ' s problems in operation : 1 ) under nominal load, the smoke temperature at the outlet of hearth reaches 1200, far more exceeds 1050 the original designed temperature. this will always result in slag inside boiler and the temperature of overheater ' s pipe superheat, so that boiler cannot take nominal load and all these influence boiler ' s nomal operation heavily, 2 ) this article also studied the reason why the assistant oil becoming necessary when coal changes. during the nomal operation, many factors ( makeup of combustor and its disposal, smirch and encrust of water wall, excessive air coefficient, temperature of primary air, coal type and density of coal dust ) can deviate the designed working conditions, then affect the boiler ' s nomal operation

    本文針對該鍋爐在實際運行中存在的問題：在額定負荷下，爐膛出口超溫、低溫段過熱器前煙溫高達936 ，遠遠超過815的設計值；噴燃器四周水冷壁結焦嚴重，過熱器管壁溫度超標，無法帶上額定負荷；甚至有時因燃煤質量的變化，必須投油助燃的嚴重情況進行了分析研究。在實際生產過程中，燃燒器的結構、布置，水冷壁的粘污、結垢，過剩空氣系數、一次風溫、煤種及其濃度變化等許多因素都會偏離鍋爐的設計工況，從而影響爐內的傳熱和燃燒，造成爐膛出口超溫、水冷壁結渣等問題。
  11. Air distribution piping systems almost invariably use soft copper tubing with soldered fittings.

    壓縮空氣的分配管道系統無例外地都是用焊接管件的銅管。
  12. Analysis of experimental data indicates that there exist several following problems during the whole operation : first, the emission is serious and the density of hc and co smoke is very high at on and off period. second, there is oil dripping from the dripping vitta as a result of the fault of ignition system and combustion structure. the last, there might be accidents of disabled ignition resulted from the improper operation at the beginning

    通過對樣機的試驗分析和研究表明，汽車空氣燃油加熱器在整個工作過程中，其排放存在以下三個問題：一、開機和關機兩個階段的排放問題嚴重，廢氣中hc和co的濃度值及煙度測量值都很高；二、因點火系統和燃燒結構的缺陷而導致開機后一段時間內有油滴從滴油管滴落；三、在點火過程中，會出現因操作不當而點火失效的現象。
  13. A typical dual duct system would have 2 zone supply air paths ? one for the hot air and one for the cold air ? and 1 zone return air path

    而對于典型的雙管系統，則由兩條區域送風路徑（一條用於熱空氣、一條用於冷空氣）和一條區域回風路徑組成。
  14. Air - heating systems circulate air through ducts to and from an air heating collector ( figure 1 )

    空氣加熱系統使空氣循環，通過通往或是通出空氣加熱收集器的管道（見圖一） 。
  15. Pneumatic tube fire alarm system

    空氣管式火警系統
  16. However, air ducts and air - handling equipment require more space than pipes and pumps, ductwork is hard to seal, and leaks are difficult to detect

    然而，空氣管和空氣處理裝置比起管道和泵需要更多空間，管道系統很難密封，泄漏很難發覺。
  17. Superstructure compressed air ( water supply 、 fire fighting 、 smoke detection ) piping to be done air - tightness test

    上層建築壓縮空氣管系（供水管、消防管、煙霧探測管）密性試驗。
  18. Ventilation for buildings - ductwork - requirements for ductwork components to facilitate maintenance of ductwork systems ; german version env 12097 : 1997

    建築物通風.空氣管道.空氣管道系統維護用空管組件要
  19. For large room area, space, or people gathering zone, where temperature and humidity are needed to be regulated, the full air conditioning system should be introduced rather than fan - coil system

    房間面積或空間較大、人員較多或有必要集中進行溫、濕度控制的空氣調節區，其空氣風系統宜採用全空氣空氣調節系統，不宜採用風機盤管系統
  20. Our major products include fluid power systems and services for industrial, mobile and aircraft equipment ; electrical systems and components for power quality, distribution and control ; automotive engine air management systems and power - train controls for fuel economy ; and intelligent drive - train systems for fuel economy and safety in trucks

    伊頓公司主要業務涉及流體動力、電子產品、汽車和卡車零部件，在許多工業領域都是全球領導者，包括電力系統和電源質量、電力輸配和控制組件；工業、行走機械和航空設備方面的流體動力系統與服務；安全節能的智能化卡車傳動系統；以及汽車發動機空氣管理系統、傳動系統解決方案和運行、省油及安全方面的特性控制。
分享友人
分享到 Line

分享到臉書