空腔振蕩 的英文怎麼說

中文拼音 [kōngqiāngzhèndàng]
空腔振蕩 英文
cavity oscillation
  • 空 : 空Ⅰ形容詞（不包含什麼; 裏面沒有東西或沒有內容; 不切實際的） empty; hollow; void Ⅱ名詞1 （天空） s...
  • 腔 : 名詞1. （動物體內空的部分） cavity; chamber 2. （話） speech 3. （樂曲的調子） tune; pitch 4. （說話的腔調） accent; tone
  • 振 : 動詞1. （搖動; 揮動） shake; flap; wield 2. （奮起） brace up; rise with force and spirit
  • 蕩 : Ⅰ動詞1 （搖動; 擺動） swing; sway; wave 2 （無事走來走去; 閑逛） loaf; wander; roam; loiter; go a...
  1. Hollow ferrites particles are the alternative to conventional solid ferrites particles, which have lower density, larger specific surface area and stability. moreover, it is expected electromagnetic wave can be reflected and absorbed again and again in the cavum of hollow particles which become its black hole. in addition, their electromagnetic parameters can be adjusted in a certain range by changing the thickness of the shell and the diameter of hollow microspheres, and the ability of absorbing microwave can be expected to improve

    空心結構的鐵氧體是對傳統實心鐵氧體的改造，不僅密度小，還具有特殊的電、磁功能，有可能使電磁波在其空腔中反復振蕩吸收，成為電磁波的「黑洞」 ，從而增加材料的吸波能力，同時可通過調節核殼粒子的內外徑來調控電磁參數。
  2. According to the guidline, two nd : yag lasers have been designed and set up, one is end - pumped by lower output power ld using a selfoc micro lens, and the other is end - pumped by high output power ld using a pair of lenses are designed, and the characteristics such as output power and power stabilization of both solid - state lasers are investigated. thirdly, when an empty liquid crystal cell is inserted in the cavity of the nd : yag laser pumped by high power ld, the laser can operates in single axial mode. finally, according to the relationship between the laser output power and the longnitudinal a ld - end - pumped nd : yag laser sensor for displacement measurement has been investigated theoretically and demonstrated experimently, the results indicate that when the mean radius of pumping inside the laser cavity is far less than that of the oscilating laser mode, the exponential of the output power is a gauss function of the longitudinal positon of focused spot of ld pumping beam, both the measurement range and the sensitivity are dependent on the incident pumping power, as the incident pumping power is increased, the measurement range is enlarged and the sensitivity is improve d

    本文首先介紹了ld泵浦nd ： yag激光器的發展狀況、主要特性及其應用，從四能級速率方程出發，推導了ld泵浦nd ： yag激光器的閾值、輸出功率和斜效率的表達式，並簡述了激光器的工作原理、結構型式和倍頻方法；其次，以空間相關的速率方程為基礎，提出了ld端面泵浦nd ： yag激光器的設計方法，給出了一定泵浦耦合方式下，振蕩光模尺寸、最佳輸出耦合率、泵浦光模尺寸、泵浦光焦斑位置等參數的選取依據，以此為依據，設計了自聚焦透鏡耦合小功率ld泵浦nd ： yag激光器和透鏡組耦合高功率ld泵浦nd ： yag激光器，對激光器的輸出功率和功率穩定性等特性進行了實驗研究；再次，在帶尾纖輸出的高功率ld泵浦nd ： yag激光腔內插入一隻空液晶盒，觀察到了激光器以單縱模運轉；最後，根據泵浦光焦斑端面位置對激光輸出功率的影響規律，提出了ld端面泵浦nd ： yag激光位移傳感新方法，並進行了理論和實驗研究，研究結果表明：當激光晶體內泵浦光平均光斑半徑遠小於振西安理工大學碩士學位論文蕩光束腰半徑時，激光輸出功率的自然指數與泵浦光焦斑的縱向位置成高斯變化規律，測量范圍和靈敏度依賴于泵浦功率，隨著泵浦功率的增加，測量范圍擴大，靈敏度提高，當端面泵浦功率為7 . 24w （最大輸出功率為1 . 926w ）時，激光位移傳感器的測量范圍和靈敏度分別是13 . 045mm和0 . 148mw / pm 。
  3. Development of noise prediction method on fluid induced pressure oscillations in cavities

    流動誘導空腔振蕩預測方法的改進
  4. Firstly, the oscillator theory was researched as the base of the design of oscillator - type aia in this paper. the derivation of oscillation condition and stability condition were given ; at the same time, the cavity modeling theory of microstrip antenna was studied, which gave the relation between the size of microstrip antenna and the resonate frequency and that between the size and impedance of microstrip antenna

    首先，針對本文所討論的振蕩型有源集成天線，作為理論基礎，進行了振蕩器理論的研究，推導出有源集成天線的振蕩條件和穩定條件；同時利用空腔模理論，給出了天線尺寸與諧振頻率和輸入阻抗的關系。
  5. Based on the rate - equation theory of four - level system, the expressions of threshold pump power, output power and slope efficiency are given. the influence of space distribution of pump light ( the position of focusing point, dimension of pumping light and divergence angle ) to the output characteristics are also discussed. then, by investigating the effects of thermal effect of laser crystal on the size of laser cavity mode, we obtain the mode - matching principle of high power laser diode end - pumped solid - state lasers

    其中，在泵浦光的空間分佈變量中我們分別考慮了泵浦光聚焦后的腰斑大小、聚焦腰斑在增益介質中的位置以及泵浦光在介質中發散角的影響；然後我們研究了在高泵浦功率下激光晶體因吸收泵浦光而產生的熱效應所導致的熱透鏡效應以及熱致衍射損耗，通過分析它們對振蕩激光腔模尺寸的影響，得到了高功率半導體激光二極體端面泵浦固體激光器模式匹配的要求，為高功率連續單頻nd ： yvo _ 4激光器的優化設計提供了理論依據。
分享友人
分享到 Line

分享到臉書