端截面 的英文怎麼說

中文拼音 [duānjiémiàn]
端截面 英文
end section
  • 端 : Ⅰ名詞1 （東西的頭） end; extremity 2 （事情的開頭） beginning 3 （門類; 方面） item; point 4 （原...
  • 面 : Ⅰ名詞1 （頭的前部; 臉） face 2 （物體的表面） surface; top 3 （外露的一層或正面） outside; the ri...
  1. I saw a number of amputation stumps from which long ligatures dangled, waiting to ripen in pus to drop off.

    我看見許多截肢端外面露出長的結扎線，等待化膿后再脫落。
  2. From the analysis, some suggestion about joint rigidity design is put forward : 1. joint initial rigidity can be enhanced within the limited range when to increase end - plate thickness ; 2. the rigidity and ultimate moment can be enhanced obviously when to adopt the beam with inclined section or to add axilla at the connections between beam and column ; 3. withm the permissive construction condition, exteriorly extended end - plate inclinedly placed is suggested to be applied firstly ; 4. when the rate of joint rigidity to beam rigidity, that is called, is less than 0. 1, the joints can be regarded as zero - rigidity joints ; on the other hand, if is more than 26, it is rigid connection joints

    採用斜截面梁並在樑柱交接處局部加腋能明顯提高節點剛度和梁的抗彎能力； 3在允許的施工條件下，應優先採用外伸式端板斜放節點，有利於提高節點剛度，進而提高節點的抗彎能力； 4節點剛度與其連接構件的剛度比值0 . 1時，可按鉸接節點設計； 26時，可按剛接節點設計。
  3. Concave reflecting surfaces of spherical cap, paraboloid and hyperboloid of revolution are investigated with regard to the dependence of the levitation force on the section radius rb and curvature radius r ( or depth d ) of the reflector

    針對球面、旋轉拋物面和旋轉雙曲面三種形狀的凹面反射端，系統研究了懸浮力與反射端截面半徑r _ b和曲率半徑r （或深度d ）之間的本徵關系。
  4. 3. a space bond slip relation of reinforcements in either end of a member is proposed, based on one - dimensional bond slip model of reinforcements proposed by teng zhiniirmg from tsinghua university, the first - time loaded ascending stage ? curve of which model is modified as the line which parameters are not changed so as to simply the computation. the bond, slip is regarded as the boundary nonlinearity of a member

    3 、採用清華大學滕智明建議的一維鋼筋粘結滑移恢復力模型，但從簡化計算的角度出發，將首次加載的上升段曲線改為直線，並假定構件端部的諸多縱向鋼筋的滑移服從平截面假定，考慮由節點錨固區粘結滑移引起的構件端截面軸向和兩轉角附加變形。
  5. Wait for section column, the node that base end receives firmly designs, bears larger carrier curved rules, suits the buil - ding that has crane

    等截面柱，底端固接的節點設計，承受更大的支座彎矩，適合有吊車的建築物。
  6. To meet the demands for large space and flexible compartmentation of buildings, laminated vierendeel trusses are adopted in high - position transfer story structures. first the bearing characteristics are analyzed, in which reasonable stiffness ratio of the upper chord, middle chord, and lower chord is derived. then combined with an actual engineering model ( 1 8 similar ratio ), the static loading and pseudo - dynamic tests of two models for laminated vierendeel truss used in transfer story structures are conducted, in which one model adopts reinforced concrete, and the other adopts prestressed concrete and shape steel concrete. seismic behaviors are analyzed, including inter - story displacement, base shear - displacement skeleton curves, and equivalent viscosity - damping curves. a program is programmed to carry out the elasto - plastic dynamic analysis, and displacement time - history curves of the two models are derived. the test and analysis results show that the laminated vierendeel truss with prestressed concrete and shape steel concrete has excellent seismic behaviors. it can solve the disadvantages of laminated vierendeel trusses used in transfer story structures. finally, some design suggestions are put forward, which can be referenced by similar engineering

    為滿足建築物大空間和靈活隔斷要求，在高位轉換層結構中採用迭層空腹桁架結構.首先分析了其受力性能，得出了空腹桁架各構件合理的截面剛度以及布局形式.然後結合一實際工程，進行了兩榀迭層空腹桁架轉換結構模型（ 1 : 8相似比）的豎向荷載下靜力試驗以及擬動力試驗.其中一榀為普通混凝土迭層空腹桁架，另一榀配置了預應力和鋼骨混凝土，對比分析了兩模型的層間位移比、骨架曲線以及等效粘質阻力系數等抗震性能的比較，並進行了彈塑性動力分析.試驗和分析結果表明，配置預應力和型鋼混凝土的迭層空腹桁架轉換結構具有良好的抗震性能，可以成功地解決迭層空腹桁架作為轉換層結構所產生的弊端問題，最後對這類轉換層結構提出了相應的設計建議
  7. Let us consider a slender bar of the medium, with a constant cross - section area. a short axial disturbance is produced at one of the bar, resulting in the propagation of a wave

    此方法的原理在於考慮一個等橫截面的圓形細桿介質，在波傳播到桿的一端時，產生了微小的軸向干擾。
  8. Based on the research to the stability variable cross - section beam, the bending defection differential equation of the variable cross - section beam in critical state of bucking is established. according to the edge condition of the structure, the differential equation is solved and bucking equation of variable cross - section beam is created. we can get the algorithm which can be used to calculate the equivalent inertia moment of the variable cross - section lattice structure when it is regarded as constant cross - section of solid web beam

    對變截面格構式構件的穩定性計算進行了初步的研究，通過建立變截面構件臨界狀態下彎曲變形的微分方程，根據變形邊界條件，得到了兩端鉸支的變截面梁失穩特徵方程，提出了幾種特殊形式的變截面格構式構件等效為等截面實腹式構件時等效慣性矩的計算方法。
  9. For meeting the related nantional standards and avoiding demolishment of the building, the underpinning and strengthening methods are used, with which the loads of center column are underpined by the diagonal steel strut and the cross - sectional areas of side pillar are strengthened, both ends of shear wall are chiseled in turn and then concrete is poured again

    通過採用斜向鋼支撐荷載轉移法實現對中柱的托換，採用剪力墻兩端分批鑿除后再澆搗實現對剪力墻的托換，採用增加截面法對邊柱進行加固，使建築物經托換和加固后能滿足國家有關規范的要求。
  10. By calculating large quantity of examples, this text studies earthquake resistant behavior of tapered portal frame with pined bases and analyzes its natural frequency, natural period of vibration and vibration mode. by comparing interior forces of pillar top, beam end and span midpoint in two conditions that seismic action effect participates combination of forces and not when portal frame is n ' t changed, ensure conditions that combination of seismic action effect has controlling f unction during tapered portal frame design, and tapered portal frame demands anti - earthquake design

    本文通過大量算例分析，研究柱腳鉸接楔形變截面門式剛架的抗震性能，並對其自振頻率、振型進行了分析；通過比較地震作用效應參與荷載組合與不參與荷載組合兩種情況下，樑柱截面尺寸不變時，柱上端、梁端、跨中截面處的內力大小，確定在什麼情況下地震作用效應組合起控製作用，變截面門式剛架需要進行抗震設計。
  11. Comparison including the cracking, yielding and ultimate loads of the beam, load - displacement curve, envelop curve, the ductility and energy - dissipation capacity were made between the response of the specimens before and after strengthening. test results indicated that the yielding loads of the specimens after strengthening were improved from 12. 3 percent to 17. 2 percent and the improvement of specimens rehabilitated by jacketing was higher than that of the bonding steel plates one

    加固后試件破壞同樣發生在梁端，屈服荷載比加固前提高12 . 3 17 . 2 ，與粘鋼加固相比，加大截面法加固的試件承載力提高幅度較大；加固后試件的延性和耗能性能比加固前有很大的改善，其中以粘鋼加固的試件提高最為明顯。
  12. In this part, it is also found that the equivalent prismatic column, which is obtained based on the equal elastic critical load as the non - prismatic member, is not actually equivalent to the tapered column in inelastic stability, and the latter has higher load carrying capacity. finally, the behavior of tapered beam - column acted by combined axial load and transverse load has been investigated. a bending - thrust interaction curve is established which is similar to the ones for the design of prismatic members

    三是研究了楔形變截面懸臂構件在大端固定，小端同時承受橫向及軸向荷載共同作用下的強度和彎矩平面內的穩定，同時參考等截面構件的設計公式，得到了用大端截面來表示的軸力p與彎矩m的之間的相關關系。
  13. Friendly pc converter - preview videos on pc, select parts you want to convert, alter quality

    友好的pc端截面? ?影片預覽，區段轉換，畫質調整。
  14. The femoral head ostectomy is a last resort procedure and generally is not recommended for mild cases of arthritis

    股骨端截面手術是一種不得已的手術，通常不會被用在輕度關節炎上。
  15. It is found that the levitation force can be remarkably enhanced by choosing optimum value of r or d, and the possibility of this enhancement for spherically curved reflectors is the largest

    發現通過選擇最優化的r或d值，可以顯著提高聲懸浮力，並且諧振模式數越小，反射端截面半徑越大，提高的程度就越大。
  16. Based on conjunction theory, the models for gear manufacturing is developed, and the equation of the gear surface is gained by the equation of rack cutter. the contact line in manufacturing and the tooth profile of the gear is also discussed based on the equation of the gear surface

    本文首先基於齒輪嚙合原理，建立了齒輪加工的模型，由刀具曲面方程推導出被加工齒輪的齒面方程，並進一步推導出齒輪端截面的齒廓方程和齒輪刀具接觸線方程。
  17. Firstly, the shear and normal stresses of tapered members under the transverse load or axial load are analysed, and the stresses formulas are obtained which are different from those of the prismatic ones. secondly, research is done on the in - plane inelastic stability of tapered members under axial loads about strong axis and weak axis. a new design method is suggested in which the tapered member is equivalent to the prismatic member with the cross - section at the larger end of the tapered member

    同時由分析可知，目前採用的將變截面壓桿按照彈性極限荷載等效的原則等效成以小端截面為準的等截面壓桿的設計方法，在彈塑性階段低估了壓桿的承載力，即彈性等效的壓桿在彈塑性階段並不等效，實際變截面壓桿的承載力比等效的等截面壓桿的承載力要高。
  18. Tow speciments of prestressed fabricated beam - column subassembly were tested under reversed cyclic loading. experimental studies were carried out to investigate the strain distribution, failure mechanism and load - bearing capacity on the beam - column connections, as well as ductility, hysteresis curves energy dissipation, displacement restoring capacity of full pc speciments

    本文通過兩榀預壓裝配式樑柱組合體在低周反復荷載下的試驗，了解了預壓裝配式框架梁端截面應變分佈、破壞機理和極限承載能力；探討了全預應力配筋截面延性特徵、滯回性能、耗能能力和變形恢復能力。
  19. Results : in the 35 normal subjects with normal resonance, the cross - sectional area over the anterior end of the inferior turbinate was not increased in four subjects after spray application, and another one was assessed as hypernasal by a speech pathologist

    結果： 35名鼻腔共鳴正常的正常輕人在噴? 3 %麻黃素溶液后， 4名受測者之下鼻甲前端截面積並未增加而另1名受測者鼻音被語言治療師檢查認為過重，這5名受測者被排除在本研究之外。
  20. Based on these, the ductility reliability of columns in the lowest layer of the reinforced concrete frames was analyzed, for providing reference to safety hoop reinforced design of cross - section of columns

    在此基礎上，分析了鋼筋混凝土框架結構底層柱在層間位移達到一定限值時，柱底端截面延性的可靠度，為更安全合理的截面配筋設計提供分析參考。
分享友人
分享到 Line

分享到臉書