第二種置位 的英文怎麼說

中文拼音 [dìèrzhǒngzhìwèi]
第二種置位 英文
second setting
  • 第 : Ⅰ助詞（用在整數的數詞前 表示次序） auxiliary word for ordinal numbers Ⅱ名詞1 [書面語] （科第） gr...
  • 二 : Ⅰ數詞（一加一后所得） two Ⅱ形容詞（兩樣） different
  • 種 : 種名詞（姓氏） a surname
  • 置 : 動詞1. （擱; 放） place; put; lay 2. （設立; 布置） set up; establish; arrange; fix up 3. （購置） buy; purchase
  • 位 : Ⅰ名詞1 （所在或所佔的地方） place; location 2 （職位; 地位） position; post; status 3 （特指皇帝...
  • 第二 : 1. （序數） second 2. （姓氏） a surname
  1. The position and size of the monochromator, focusing curvature radii and tilting angles of the germanium focusing monochromator under different different take - off angle, size and divergency of the second collimator and intensity loss due to the use of it were determined. the neutron flux at different wavelength, under different reflection and take - off angle of the monochromator and divergency of the first collimator, were given. the simulation on the aperture used for limiting beam size in front of the sample showed that, smaller the size of the aperture and further the distance from the aperture to the sample, greater the loss of the intensity and more serious the spread of the beam along vertical direction at the sample position which makes the practical sampling volume greater than expected

    用蒙特卡羅模擬方法對中子應力衍射譜儀的設計方案進行了優化研究，提出了一系列可供參考的數據：確定了單色器的位置、尺寸、垂直聚焦單色器在不同起飛角下的聚焦曲率半徑和傾角；討論了第二準直器的尺寸和發散，以及使用第二準直器造成的強度損失；給出了在不同單色器反射面、起飛角、中子波長和第一準直器發散度的情況下樣品處的中子注量率，以及多種組合情況下譜儀的解析度曲線；對限束方孔的尺寸、距離樣品遠近對強度損失和測量中的影響做了深入研究。
  2. In the second method, wavelet transform is combined with modal transform, and transient travelling - wave signal is used. after three phase signals are decomposed into their modal components, the wavelet transform coefficient of ground mode can be used to identify approximate position of fault, and the wavelet transform coefficient of aerial mode is used for identifying arrival time of traveling - wave

    第二種方法將小波變換與模式變換理論結合起來，採用的是暫態行波信號，首先將三相信號轉換成模式分量，零模分量的小波變換系數用於判別故障的大致位置，然後利用線模分量的小波變換系數來確定行波到達時間。
  3. The second chapter is mainly a summary of the investigation of the present practice of the system of appointment and contract. through analysis of the statistics, interviewing and discussing, we have found out that the present system of appointment and contract is more like a system of appointment of the position rather than a true system of appointment and contract which is decided by the teachers " law and socially accepted

    第二章主要是對當前教師聘任合同制實踐的調查，通過對統計數據的描述、訪談、座談結果的概括得到，目前的教師聘任合同制實際上更多的是一種崗位聘任制，還不是教師法規定的社會化的真正意義上的聘用合同制，還沒有真正實現優化組合、合理配置人才、提高教學質量和辦學效益的目的。
  4. The first and second longest chromosomes are important in karyotype analysis and most of which are metacentric chromosome and submetacentric chromosome in lilium. hybrids were distinguishable by the existence and position of secondary constriction and arm ratio

    百合的第一對和第二對染色體多為中著絲粒和近中著絲粒染色體，可以根據次縊痕有無與位置及臂比鑒定雜種。
  5. Third, two necessary conditions of constitutive elements of crime. namely, the whole constitutive elements of crime include crime objective respect, crime subjective respect. the second view and third view in common is that object of crime ' s essential and independent status is wiped off in the structure construction of constitutive elements of crime

    第二、三種觀點的相同之處是在犯罪構成整體的結構搭建中抹去了犯罪客體的應有獨立位置，而認為犯罪客體是現行犯罪構成體系中多此一舉的要件，它的存在對定罪量刑也無多大意義。
  6. Chapter two ascertains main technological factor of dong gou lock reconstructing, including forecast the cargo and volume through the lock to reason about representative type of vessel designed for through the lock and its operation organize. chapter three design the renovate engineering through ascertaining the main technological factor scale of the lock, dimension, designed water level and altitude, including design of structure of the lock, lock chamber and lock gate, and select the main technological factor and pattern of headstock gear. chapter four draws a comprehensive compare of the two design scheme of the renovate project with engineering project economy evaluation method, and makes out the recommended scheme, and furthermore, to calculate the economic evaluation index of the recommended scheme and makes the economic sensitivity analysis of the scheme and finally demonstrate economic feasibility of the scheme

    本論文共分四章：第一章主要介紹了原東溝船閘的地理位置和營運現狀，說明了船閘在航道建設和水資源綜合利用中的作用及東溝船閘改造的必要性；第二章東溝船閘改造的主要技術因素確定其中包括東溝船閘過閘貨種和貨運量發展的預測，並確定東溝船閘的設計代表船型及營運組織；第三章東溝船閘改造工程設計本章通過船閘改造工程主要技術參數：船閘規模、尺度、設計水位和高程等的確定，設計了二個船閘改造方案，包括鋼筋混凝土整體塢式閘首結構、閘室和閘門的設計，並選定了啟閉機的主要技術參數和型式；第四章採用了工程項目經濟評估方法對東溝船閘改造工程二個設計方案進行全面綜合比較后，確定了推薦方案。
  7. The wavelengths of reflectance peaks and vales are got by spectral derivative method in section 3. 3. mechanism of them is analyzed. red tide and normal seawater, as well as some different dominant species of red tide, such as chattonella marina and mesodinium rubrum, can be discriminated by using the wavelength information of second reflectance peak

    3 . 3節運用該方法得出了實驗赤潮水體光譜曲線的兩個反射峰和一個吸收峰的波長范圍，並對其產生機理進行了分析;更為重要的是，利用光譜曲線第二反射峰的波長位置實現了赤潮與非赤潮水體的光譜辨別，以及紅色中繞蟲、海洋褐胞藻等不同優勢種類赤潮的識別。
  8. Results : with three different retainer designs, the retainer on the second premolar and the first molar exerted the smallest stress on the abutment and its periodontal tissue, while the retainer on the first premolar and the first molar had the largest stress

    結果：在3種不同的固位體設計方式中，固位體放置在第二前磨牙與第一磨牙之間時，基牙及牙周組織受力最小；固位體放置在第一前磨牙與第一磨牙上，基牙與牙周組織受力最大。
  9. There are also new surveys being carried out or planned in the year, including " survey on new trade types for vacant stalls in kowloon city market ", " survey on the demand on market facilities in siu sai wan and tung chau street area ", " survey on consumer food purchasing habits ", " longitudinal survey on clean hong kong programme phase 1 and phase 2 " and " study on meat consumption in hong kong "

    年內，小組進行及計劃的意見調查包括九城街市空置檔位售賣新種類貨品意見調查小西灣及通州街一帶街市設施需求調查食物購買習慣統計調查清潔香港意見統計調查第一及第二階段，以及香港肉類食用研究及統計調查。
  10. Intense competition forced enterprises to adopt advanced technology to enhance their ability of product development, in this circumstance, concurrent engineering, virtual enterprise is put forward. a method of product configuration based on product model and part family, and utilizing knowledge - base and rule - base is proposed. after building product model and implement of classification of parts, we finish product configuration through two phase search

    針對這種現實在產品配置模塊設計中提出了基於產品模型和零部件族、應用知識d碩士學位論文四示示y川uir 』 slffe 「庫和規則庫的產品配置的方法，其關鍵是在建立產品模型和實現零部件的分族管理的基礎上，通過兩個階段的搜索匹配（第一階段是在產品模型上的搜索和匹配，得到相應的構件，第二階段是針對零部件族的搜索匹配）得到最終的配置零部件。
  11. Firstly, in the thesis, the highway surface track - detecting system being researched by the cooperation of our group with the nanjing university of science and technology has been summed up. sequentially according with the characteristics of the image data captured by the ccd linear array at a high speed, various noise filtering methods are compared in detail, and the effective methods to filter the data in this system is concluded, the filtering program to process the image data is written by turbo c + + 3. 0

    第二部分為6 、 7 、 8章，從分析本實驗室和南理工合作研究的高速公路路面車轍檢測系統著手，結合該系統中用線陣ccd高速採集的激光光斑位置圖象數據的特點，通過對各種不同噪聲濾波方式下處理后圖象的比較，最終得出了在我們的路面車轍檢測系統中行之有效的濾波方法。
  12. There are also new surveys being carried out or planned in the year, including " survey on new trade types for vacant stalls in kowloon city market ", " survey on the demand on market facilities in siu sai wan and tung chau street area ", " survey on consumer food purchasing habits ", " longitudinal survey on clean hong kong programme ( phase 1 and phase 2 ) " and " study on meat consumption in hong kong "

    年內，小組進行及計劃的意見調查包括九龍城街市空置檔位售賣新種類貨品意見調查、小西灣及通州街一帶街市設施需求調查、食物購買習慣統計調查、清潔香港意見統計調查? ?第一及第二階段，以及香港肉類食用研究及統計調查。
  13. Hp : well, go into second position with your children

    好的，和的孩子一起進入第二種位置。
  14. Firstly, by selecting and defining the resource load indexes rationally, lbmr take into consideration the effect on the resource usage of source node and destination node by the migrant. by means of vector operations, lbmr can use multiply resources in harmony. secondly, lbmr adopts the smallest k - subset random algorithin, and the load index information is provided by the information cache

    Lbmr演算法的主要思想有三點：第一，基於合理選擇和定義的資源負載向量，綜合考慮進程遷移對源節點和目標節點資源利用率的影響，通過向量運算協調多種資源的平衡使用；第二，基於最小k子集隨機演算法，採用信息cache提供的負載信息作為負載平衡演算法位置策略的選擇依據；第三，基於進程生命時間的概率分佈，根據遷移進程減速（ slowdown ）數學期望值的改善程度，選擇適合於遷移的進程。
分享友人
分享到 Line

分享到臉書