等摩爾響應 的英文怎麼說
中文拼音 [děngmóěrxiǎngyīng]
等摩爾響應
英文
equimolar response-
The factors influencing on the performance of ash - jd such as the moore ratio of monomers, the reaction temperature and time, concentration, the ph value of reaction solution and the drippy speed of formaldehyde were studied carefully. through experiments, the optimum level of those factors was gained
論文詳細研究了反應單體的摩爾比、反應溫度、時間、濃度、反應溶液的酸堿度及甲醛的滴加速度等對產品ash - jd性能的影響，通過試驗，得到了這些因素的最佳水平。The study conducted research on the following four fields : firstly, the characteristics of the interfacial polymerization system of piperazine aqueous solution / trimesoyl hexane solution were systematically investigated. the results show that at a certain molar ratio between the two monomers, piperazine and trimesoyl, at the two phase interface, a dense functional layer of ultra low pressure, high permeating flux and high salt rejection formed by controlling the time of interfacial polymerization, such as the composite membrane ( i ), the concentration in water phase is 0. 4 %, and 0. 1 % in organic phase, and the polymerization time is 1 minute
本文主要進行了四個方面的研究，首先系統分析和研究了哌嗪水溶液均苯三甲酰氯正己烷溶液界面聚合體系特徵、界面聚合反應中各影響因素對膜性能的影響等，結果發現，當界面處兩相單體（哌嗪和酰氯）分子摩爾比為某一比值時，通過控制界面聚合時間（有機相處理時間） ，可以形成超低壓高通量高脫鹽的緻密功能層，如復合膜（ ） ，水相濃度為0 . 4 ，有機相濃度為0 . 1 ，聚合時間1min 。Abstract : the synthetic method of pentaerythrito naphthenate by n on - acid catalyst sno was studied. the influences of mole ratio of ethanediol and naphthenic acid, a mount of catalyst, reation time, reation temperature etc. on est erification were discussed and the suitable processing conditions were found
文摘:介紹了用氧化亞錫非酸性催化劑催化合成環烷酸季戊四醇脂的方法，通過討論醇酸摩爾比、催化劑用量、反應時間、反應溫度等因素對該脂化反應的影響，從而確定了適宜的工藝條件In this paper, co3o4 nano - particles were prepared by homogeneous precipitation method, technical conditions and kinetics were studied, the main contents and results are as follows : co ( no3 ) 2 6h2o was used as raw materials, and co ( nh2 ) 2 was used as precipitator, co3o4 nano - particles were prepared by homogeneous precipitation. the influences of concentration, molar ratio of reactants, reaction temperature and time, dryness temperature and time, and calcining temperature and time on particle size were investigated
本文採用均勻沉澱法制備納米co _ 3o _ 4粉體材料，研究了制備工藝條件、沉澱反應和前驅體熱分解過程的動力學，主要研究內容及結果如下：以硝酸鈷為原料，尿素為沉澱劑，採用均勻沉澱法制備納米co _ 3o _ 4 ，考察了硝酸鈷濃度、反應物摩爾比、反應溫度和時間、乾燥溫度和時間、煅燒溫度和時間等條件對產物粒徑的影響。The influences of w0 ( molar ratio of water to surfactant ), the concentration of the reactants and the aging time on the morphologies and the sizes of the nanoparticles were studied
研究了微乳液中水與表面活性劑的摩爾比（ _ 0 ） 、反應物濃度及濃度比、陳化時間等條件對產物形貌的影響。The reaction conditions, such as the ratio and adding order of rectants, reaction temperature, reaction time and displacers, were investigated
考察了原料摩爾比、加料順序、反應溫度、反應時間、置換劑等對反應結果的影響。So can amount of displacement measured comes with hall1 s component it has small inertia, respond and wait for the characteristic quickly, except that hall must move with the unit under test in succession component, there are not other activity parts, so can avoid the disadvantages, such as frictional force, mechanical breakdown, etc., adapt to doing the on - the - spot trends to test very much
因此可以用霍爾元件來測量位移量。它具有慣性小，響應快等特點，除了霍爾元件須與被測部件連動外，無其他活動部件，因此可避免摩擦力、機械故障等弊病，很適應做現場動態測試。分享友人