粉密度 的英文怎麼說

中文拼音 [fěn]
粉密度 英文
powder density
  • : Ⅰ名詞1 (粉末) powder 2 (用澱粉製成的粉條或粉絲) noodles or vermicelli made from bean potato o...
  • : Ⅰ名詞1 (秘密) secret 2 [紡織] (密度) density 3 (姓氏) a surname Ⅱ形容詞1 (距離近; 空隙小)...
  • : 度動詞[書面語] (推測; 估計) surmise; estimate
  1. Powder materials can be made into even granules customer needs without adding any bonding anent when they run througnh the machine. as density of granules are larger, no any afterward process is needed so as to reduce technological process, reduce granulation cost and powder pollution and improve labor environment as well

    體物料經本設備,無需添加任何粘結劑即可直接製成用戶所需的均勻顆粒產品,顆粒大,城無需再進行后續加工處理,減少了工藝流程,不僅降低了造粒成本,並且減少了塵污染,改善工人的勞動環境。
  2. We also attainted mosi2 / sic composite by using melting mosi2 infiltrated sic body which shaped by sic powder. the result show that the diameters of sic particle and shaping methods have effect on the composite ' s microstructure and properties

    另外,嘗試了用mosi _ 2在2050下浸滲直接由sic體成型的坯體制備mosi _ 2 / sic復合材料。採用sic顆粒的級配有利於提高坯體,但是降低燒結體的緻
  3. The material was sintered at 1050 for three hours to get the porous artificial bone, that its apparent porosity was54 %, its volume density was 1. 28 g / cm3, and its bending strength was 13. 25mpa. the results showed that the sintering temperature was reduced by adding bioglass

    本研究採用含生物玻璃前驅體末原料,添加檸檬酸造孔劑,模壓成型,在1050燒結保溫3小時,獲得了顯氣孔率為54 、體積為1 . 28s cm ~ 3 、抗彎強為13 . 25mpa的多孔hap人工骨材料。
  4. The powder was pressed through molding and cold isostatic pressure, which increased the density and decreased the uneven distribution of stress inside the briquet to make the ceramic briquet equally compact

    料採取模壓和冷等靜壓相結合的方法壓制,增大了坯體內部的並減少了應力的分佈不均,得到均勻緻的陶瓷坯體。
  5. Test methods for bulk density of fine ceramic powder

    細陶瓷末的體測試方法
  6. Standard test method for apparent density of non - free - flowing metal powders using the carney funnel

    非高流動性金屬末的表觀的標準試驗方法
  7. Mas precursor powders were uniaxially pressed at 100 mpa employing a lubricated steel cylindrical mold. after sintering at 1450 for 2 hours, single - phase cordierite ceramic is prepared, and its relative density is 95. 1 %

    Mas先驅體末在100mpa的軸向壓力下成型后,經1450無壓燒結2小時,得到單相堇青石陶瓷,其緻達95 . 1 。
  8. In other four species, gentiana przewalskii, aconium tanguticum, pedicularis kansuensis and delphinium monanthum, the whole starch grains were light in

    在其餘4種高山植物中,澱粒的電子均較低。
  9. The results from the pollen densitometers indicate the number of pollen grains sucked into a device per square millimeter of the aperture.

    顯像計的計算結果,可以表明每一平方毫米孔徑上吸入的花粒數。
  10. Dried milk and dried milk products. determination of bulk density

    及奶製品.體的測定
  11. This machine is mostly used for rubber has been comminuted with glue water whipping and middling, and pass foaming shapes up template, through oil press system having it beenpressed homologized demand density reprocessed foam rubber

    本機主要用於將已經碎的泡綿與膠水攪拌混合,再經過發泡成型模,經油壓系統壓成相應要求的再生泡綿。
  12. Chemical products for industrial use. determination of density of solids other than powders and cellular products. hydrostatic balance method

    工業用化學製品.除了劑和泡沫製品之外的固體的測定.水靜態平衡法
  13. A study on bonding mechanism of water - based modified starch adhesive used in the packaging of middle density fiberboard of kenaf stalk

    水性改性澱膠在包裝用麻稈中纖維板中膠合機理的研究
  14. The highest density and the low resistivity and the best magnetostriction in a composite rod were obtained when the proportion of binder to powders " weight is 4 : 100

    膠與磁性末的質量比為4 : 100時,粘結體的最高,電阻率最低,磁致伸縮性能最佳。
  15. The results showed that the effect of c. megacephala pollination was not significantly different from that of hand pollination and bee pollination, but significantly different from that pollinated by musca domestica l. and flies mixed by both c. megacephala and houseflies under the same density

    結果表明:油菜在不同授方式下,大頭金蠅授與人工授、蜜蜂授效果之間差異不顯著,與家蠅授差異比較明顯,與相同條件下兩種蠅類混合釋放有明顯的差異,且有交互作用。
  16. The analysis indicates that micropacking silica fume works to the density and relative density of rpc, and its pozzolanic effect helps the strength of rpc

    硅灰的微填充效應有利於提高活性末混凝土的和相對,而火山灰效應有利於提高其強
  17. W - cu composites prepared from the precipitation w - cu powder have higher sintered density, better mechanical and physical property, more homogeneous and finer microstructure than those prepared from w - cu powder by the balling - reduction method. in chapter 5, a combination of homogeneous precipitation and ball - milling process, namely the mechano - thermochemical process was employed to prepare ultra - fine w - cu powder

    其中,球磨w一cu復合( hp一m )壓坯在1150下燒結30min后,可獲得相對大於99 %的幾乎全緻的超細晶粒w一cu復合材料, w的顆粒小於0 . 5林m 。
  18. Scott metallic powders - determination of apparent density - scott volumeter method

    金屬末.表觀的測定.第2部分:斯科特
  19. Apparent powder density

    表觀粉密度
  20. Density as pressed

    粉密度
分享友人