粗化 的英文怎麼說
中文拼音 [cūhuà]-
For a class of quadratic finite element diseretization systems of an elliptic boundary problem with jump coefficients under the unstructured quadrilateral grids, we are concerned with two kinds of quadratic lagrangian finite element equations, by analyzing the relationship between the linear finite element and quadratic finite element basis functions, a hew amg method is designed
摘要針對一類帶間斷系數的橢圓邊值問題，在非結構四邊形剖分下，討論了兩種二次拉格朗日有限元方程的代數多重網格法，通過利用雙線性元和二次元基函數之間的表示關系，給出了一種新的網格粗化演算法和構造提升運算元的代數途徑。Effects of re on ' directional coarsening in single crystal superalloys during creep
相定向粗化的影響A new grid - coarsening algorithm for parallel algebraic multigrid method
一種新的并行代數多重網格粗化演算法Effect of microalloy element on the grain coarsening behavior of q345 steel
345鋼奧氏體晶粒粗化行為的影響Phase particle coarsening dynamics and pattern change in ti - 6al - 4v alloy
鈦合金相顆粒粗化動力學及形貌變化Effect of ti content on coarsening temperature and austenite grain size of ah
36粗化溫度和奧氏體晶粒大小的影響Lock coarsening may entail a trade - off between performance and responsiveness
鎖粗化可能要在性能和響應性之間進行平衡。Blocks or method calls, the compiler can still perform lock coarsening
塊或方法調用之間有其他語句，編譯器仍然能夠執行鎖粗化。Evolution and coarsening mechanism of surface morphology of zno film at different annealed temperatures
薄膜表面形貌的演變及粗化機制The jvm might still be able to elide the locking, but it could still benefit from lock coarsening
之後， jvm可能仍然能夠省略鎖定） ，但是它仍然可能從鎖粗化受益。If the compiler cannot eliminate the locking using lock elision, it may be able to reduce the overhead by using lock coarsening
如果編譯器可以用鎖省略清除鎖定，那麼它就可能用鎖粗化降低開支。When the specimens are deformed in a long time at the optimal superplastic deformation condition, the microstructure is coarsened sharply. if the deformation time is shortened properly or the deformation temperature is decreased appropriately or strain rate is increased, homogeneous and fine equiaxed crystal microstructure can be obtained
在最佳超塑性條件下長時間變形時，合金顯微組織將發生明顯粗化，適當縮短變形時間、或適當降低超塑變形溫度及提高應變速率，可得到均勻細小的等軸組織。Obviously armoring layer existed in the surface of the river bed
河床表面具有明顯的粗化層。It is firstly found that for alloys in transitional region, with enhancement of atomic interaction energy, pregnant period of " phase is shortened dramatically, and process of clustering accelerated remarkably, stages of growth and coarsening of " phase brought forward, i. e. precipitation mechanism of alloy in transitional region incline to that of alloy in instable region
首次發現，隨著原子間相互作用勢的增加，過渡區合金中有序相的孕育期明顯縮短，原子簇聚過程明顯提前，相的長大和粗化階段也有所提前，即促使過渡區合金的沉澱機制偏向失穩區合金。Then river width increased and the intensity of deep point lowing and bed material coarsening decreased and water level lowed continuously. so the bed form changed toward to u type. the bed regulation is realized through sediment silting in different parts in cross section during silting period and the deformation of bed form changed from broad u type channel to narrow and deep v type channel
研究表明，河道在持續沖刷前期深泓點及水位下降與河床粗化同步發展，河床向v型發展；沖刷後期深泓點下降、河床粗化減弱，河道展寬增大，水位繼續下降，河床向u型發展；在以淤積為主時期的調整，是通過斷面不同部位的淤積來實現的，但都是由u型較大河槽向v型窄深小槽發展。( 1 ) first, metallizing abs plastics surface by chemical coarsing, metal ion absorption, metal ion reducing and chemical copper - plating. then, the copper - coating was thickened by electroplating in order to improve adhesion between following - coating and plastics matrix, and nickel was preplating. finally, ni - sic composite was plated
（ 1 ）通過反復實驗，確定工藝流程：首先通過粗化、敏化、活化和化學鍍銅，使塑料表面金屬化，再電鍍銅加厚銅鍍層，增強后續鍍層與塑料基體的結合力，然後預鍍鎳，最後電鍍ni ? sic復合鍍層。The organic matter, total n, hydrolytic n were increased, then reduced with the increase of abandoned time. the loss of organic c got up to 59. 4 % in abandoned land. in 0 - 20cm, the sand content of 0. 25 - 0. 05mm was increased gradually, the average content of sand in the abandoned land was up to 76. 84 %, the sand contents of silt and sand was gradually reduced, the soil mechanic compose became coarse
隨撂荒年限的增加，土壤有機質、全氮、堿解氮等主要養分均表現出先降低后增加的趨勢；撂荒地有機碳的損失平均達到59 . 4 ；在撂荒地表面0 - 20cm范圍內， 0 . 25 - 0 . 05mm粒徑的砂粒含量逐漸增加，各撂荒地砂粒平均含量達76 . 84 ，粉粒和粘粒含量逐漸降低，土壤機械組成出現粗化現象。Effect of percent reduction and alloying elements on the austenite grain coarsening temperature of 18crmnbhz steel
鋼奧氏體晶粒粗化溫度的影響Influence of ti content on austenite grain size and grain coarsening temperature in medium - carbon boron steel
鈦含量對中碳硼鋼奧氏體晶粒度及晶粒粗化溫度的影響The effect of reheating austenitizing temperature on grain coarsening, the dissolution of vanadium compound and hardness of 50mn2v steel
鋼再加熱奧氏體化溫度對晶粒粗化釩化物溶解及硬度的影響分享友人