粘合用纖維 的英文怎麼說

中文拼音 [niángěyòngxiānwéi]
粘合用纖維 英文
binder fibre
  • 粘 : 粘動詞（粘附） glue; stick; paste; adhere to; bond
  • 合 : 合量詞（容量單位） ge, a unit of dry measure for grain （=1 decilitre）
  • 用 : Ⅰ動詞1 （使用） use; employ; apply 2 （多用於否定: 需要） need 3 （敬辭: 吃; 喝） eat; drink Ⅱ名...
  • 纖 : 纖形容詞（細小） fine; minute
  • 維 : Ⅰ動詞1 （連接） tie up; hold together; link 2 （保持; 保全） maintain; safeguard; preserve; keep ...
  • 合用 : 1. （共同使用） share 2. （適合使用） serve （the purpose）; fit for use; meet the requirement
  • 纖維 : fibre; staple; filamentary
  1. It is felted by flakes planed from timber crossbedded. thus wooden fibre is interconnected to keep stable performance of product

    採用木材刨切成的薄片，縱橫交錯，多層組合粘結而成，使其木材纖維相互牽扯保持性質穩定。
  2. Taking the brown alumina powder and french chalk as the refractory, the silicasol and dextrin as the composite binder, the western bentonite and sodium carboxymethyl cellulose ( cmc ) as the composite suspension agent, the optimum mixing ratio of the water - based coating was established by the method of orthogonal experiments

    摘要選用棕剛玉粉及滑石粉為耐火填料，以硅溶膠及糊精為復合粘結劑，以鈉基膨潤土和羧甲基纖維素鈉（ cmc ）為復合懸浮劑，通過正交試驗方法確定了最佳配方。
  3. In this paper, the viscosity changes of hydroxy ethyl cellulose sol caused by a kind of mixed salt were studied, which provided valuable basic data and an adapting equation for its practical application

    摘要研究了一種混合鹽的存在使羥乙基纖維素溶膠粘度變化的情況，為其實際應用提供了有價值的基礎數據和擬合公式。
  4. It was widely used in rock oil industry and mucilage glue fibre industry

    有機合成中用脫水劑和磺化劑，還廣泛應用於石油工業和粘膠纖維工業中。
  5. The effect of fiber friction within rovings and yarns can be expressed by means of "minimum twist of cohesion".

    粗紗和細紗中纖維摩擦的效用，可以用「最低粘合捻度」表示。
  6. In the dissertation high - temperature corundum honeycombed ceramic regenerative body was prepared by an extrusion process, a - al2o3 minute powder as main raw material, clay, cmc etc as plasticizers, tung oil etc as lubricator. the plastic performance was tested on a plastic measure apparatus

    以a - al _ 2o _ 3微粉料為主原料，採用粘土、羧甲基纖維素（ cmc ）等有機-無機復合增塑劑，加入桐油等作為潤滑劑，採用擠出成型法制備剛玉質高溫型蜂窩陶瓷蓄熱體。
  7. It is widely used in artificial silk, syntheticfibre, mediate of dyestuff, regeneration of rubber, bleaching of textiles, papermarking, soaping, tanning, refinery of petroleum and grease, alumirium oxide exteacting, pharmacy, plastic industry etc

    主要用於粘液法人造絲、合成纖維、染料中間體、橡膠再生、織物漂染、造紙、制皂、製革、石油和油脂的精製，提取氧化鋁、醫藥、塑料等工業。
  8. Based on plane section assumption, this paper presents the methods of calculating the ultimate strength of the columns strengthened with cfrp, and makes a simplification of the methods. a fortran program on nonlinear method is presented to numerically analyze the characteristics of large eccentrically loaded columns strengthened by longitudinal straps of cfrp, calculating results compare well with experimental data

    本文在平截面假定的基礎上分別推導了碳纖維布縱向粘貼大偏心受壓柱的正截面承載力校核和截面加固基本計算公式，並對公式進行了相應的簡化；運用fortran語言編制相應程序對縱向粘貼碳纖維布大偏壓柱進行了數值分析，本文公式計算結果和程序計算結果均與試驗結果吻合良好。
  9. In this paper ， static load experiments are illustrated and the reliability of cfrp reinforcement technology ， used for reinforcing beam slab structure of large span bridge ， is discussed

    文章結合對大跨度橋梁的梁板結構加固處理前後的靜載試驗，探討了大跨度梁板結構應用粘貼碳纖維加固處理技術的可靠性。
  10. Pressure - sensitive adhesive tapes for electrical purposes - part 3 : specifications for individual materials - sheet 4 : cellulosic paper, creped, with rubber thermosetting adhesive

    電工用壓敏粘帶.第3部分:單項材料規范.第4活頁:用熱固橡膠粘合的纖維素皺紋紙
  11. Pressure - sensitive adhesive tapes for electrical purposes - part 3 : specifications for individual materials - sheet 5 : cellulosic paper, non - creped, with rubber thermosetting adhesive

    電工用壓敏粘帶.第3部分:單項材料規范.第5活頁:用熱固橡膠粘合的纖維素非皺紋紙
  12. Pressure - sensitive adhesive tapes for electrical purposes - part 3 : specifications for individual materials - sheet 11 : combination tapes made of creped cellulosic paper and polyethylene terephthalate film with rubber thermosetting adhesive

    電工用壓敏粘帶.第3部分:單項材料規范.第11活頁:用熱固橡膠粘合的纖維素皺紋紙和聚對苯二甲酸乙酯薄膜製成的混合帶
  13. The grade composite, road performance and its mechanism are systemically studied. 1 ) the aggregate grade of ogfc is studied through the volume method base on the analysis of the aggregate grades. then the grade is verified and the relation between the grade and pore rate is studied statistically, the typical grades of ogfc are developed ; 2 ) the reasonable pore rate of ogfc is studied on the basis of the balance of mechanics and function performance ; 3 ) the mineral fiber is added to the ogfc mixes to increase asphalt content, thus the anti - water performance of ogfc mixes are improved ; 4 ) high viscous asphalt fit for the preparation of ogfc is prepared through composite modification by sbs and rubber powder ; 5 ) the mechanics mechanism of ogfc is studied in the paper, it shows : asphalt paste, as well as the coarse aggregate skeleton, is essential to the mechanics of ogfc

    在分析各國ogfc級配的基礎上，運用礦料體積法進行ogfc級配設計，用正交實驗對礦料級配進行了優化設計，運用數理統計方法分析礦料級配和孔隙率之間的關系，並回歸出礦料關鍵篩孔通過率與ogfc骨架空隙結構關系的數學方程，進而提出了ogfc的合理級配；通過對不同孔隙率典型級配混合料的性能研究，綜合力學和功能性能，得出了ogfc的合理孔隙率范圍：針對高速公路面層對ogfc力學性能方面的要求，本文從瀝青膠結材料、纖維穩定劑兩方面對ogfc的性能進行改善：通過sbs和橡膠粉復合改性的方法開發出了適合ogfc的高粘度改性瀝青，摻加聚合物纖維，提高ogfc的最佳瀝青用量，進而改善了混合料的高溫性能和抗水損害性能，優化設計出能滿足高速公路路用性能，車轍動穩定度達5000次/ mm以上，動融劈裂強度比90 ，透水系數31ml / s ，並具有防滑降噪功能的開級配瀝青磨耗層（ ogfc ）混合料。
  14. Aircraft industry. synthetic cloths for the fabric of airplane structures. determination of shear sstrength by stretching cloths, in the delivery condition, stuck then protected before and after aging

    航空工業.飛機結構用合成纖維布.發貨時測定老化前後粘著保護的拉伸纖維的抗剪切強度
  15. Nylon is one of the best quality snthetic fibers the rubber in dustry use nowadays. the nylon canvas is woven by nylon fibers both in warp and in weft, it is the most widely used fabric in rubb - er industry, and its outstanding merits are its high abrasion resistance. high fensile strength and good fatigue resistance. connvyor belts with nylon canvas inside have the characteristics of thin belt body, high tensile strength, good shock resistance, good troughability, high adhesion between pli - es, splendid flexibility and long working life. nylon conveyor belts are suitable for medium, long - di - stance and heavy - load transportation of materials, widely used in mining, metallurgical industry and architectural industry, ports and etc

    產品說明:尼龍是橡膠工業目前所用合成纖維中性能最好的品種之一，其結構經緯向均為錦綸纖維編織，用途最廣的品種，它最突出的優點是耐磨性好，強度高，耐疲勞性好，尼龍帆布做成輸送帶具有帶體薄，強力高，耐沖擊，成槽性好，層間粘合力大，屈撓性優異及使用壽命長等特點，適用於中長距離，較高載量，高速條件下輸送物料，廣泛用於礦山，冶金、建築、港口等部門。
  16. In this thesis, the pet / montmorillonite ( mmt ) nanocomposites and pure pet with high molecular weight were prepared by solid state polycondensation ( ssp ) so as to meet the needs of industrial fiber. the fiber was spun and drawn in proper conditions. the microstructure of pet / mmt nanocomposites was studied

    本論文以常規分子量的聚對苯二甲酸乙二酯蒙脫土（ pet mmt ）納米復合材料和純pet為原料，通過固相縮聚的方法，來提高樣品的特性粘度，使之達到工業用纖維所需的分子量要求。
  17. It is necessary to study the effect of weak interfacial bonding on the mechanical behaviour of metal matrix composites ( mmcs ), the micromechanical finite element method and the nonlinear spring element for the interface are employed to predict the effective behaviour of mmcs

    論文採用非線性彈簧元模擬界面，用細觀力學有限元法計算分析了不同界面特性下弱界面粘結的纖維增強金屬基復合材料的宏細觀性能。
  18. This thesis aims at the fiber reinforced composites with weak interfacial bonding, which seriously affects the mechanical behaviour

    界面對復合材料的力學性能有重要的影響，開展弱界面粘結對纖維增強金屬基復合材料力學性能的影響研究具有重要的工程應用價值和理論意義。
  19. A fortran program based on conjugate beam is worked out to analyze repaired beams, and the outcome correlates well with experiment data

    本文利用共軛梁法編制了fortran語言的計算機程序對粘貼碳纖維片材加固后的鋼筋混凝土梁進行了數值分析，計算結果與試驗結果吻合良好。
  20. Experimental results indicate that the strength capacity, stiffness of columns have a certain extent increasing as a result of the action of cfrp, repaired columns " cracks show little and distribute uniformly. the ultimate strength and ductility of column improved due to the transverse strengthening with cfrp and display more distinct benefit when strengthened by the combined action of the longitudinal and the transverse straps of cfrp. in addition, many parameters including anchorage length of cfrp, thickness of cfrp are considered on the effects of cfrp on strength, and failure modes of columns

    試驗結果表明，大偏心受壓柱受拉麵縱向粘貼碳纖維布后，偏壓柱承載力和抗彎剛度有一定程度的提高，裂縫寬度減小且分佈均勻；碳纖維布橫向粘貼偏壓柱對偏壓柱的承載力和延性有一定的提高；縱橫向混合粘貼大偏壓柱加固效果更顯著；混凝土強度低於c20級時，不適合採用碳纖維布粘貼加固。
分享友人
分享到 Line

分享到臉書