系統負荷 的英文怎麼說

中文拼音 [xìtǒngfùhé]
系統負荷 英文
system loading
  • 系 : 系動詞（打結; 扣） tie; fasten; do up; button up
  • 統 : Ⅰ名詞1 （事物間連續的關系） interconnected system 2 （衣服等的筒狀部分） any tube shaped part of ...
  • 負 : Ⅰ名詞1 （負擔） burden; load 2 （虧損） loss 3 （失敗） defeat Ⅱ動詞1 [書面語] （背） carry on th...
  • 荷 : 荷名詞（蓮） lotus
  • 系統 : 1. （按一定關系組成的同類事物） system 2. （有條理的;有系統的） systematic
  • 負荷 : [電學] load; charge; weight
  1. Alb air braking systems ; labels for load sensing devices

    氣制動系統.負荷敏感元件標志牌
  2. Load predictions for district heating systems based on a wnn model

    基於小波網模型的區域供熱系統負荷預測
  3. The remote diagnosis center is based upon the implementation of remote signal analysis system. general methods of signal processing are discussed. they are accomplished by java, jsp programming language in j2ee environment, which can keep the balance of system and utilize resources sufficiently expert - diagnosis system is an important part in the remote diagnosis center

    對于遠程診斷中心，主要研究了遠程信號分析系統的設計與實現，討論了信號分析處理常用的一些方法，並將這些方法用java 、 jsp編程語言在j2ee環境下實現，使得系統負荷平衡，更靈活、充分地利用資源。
  4. This paper deduced the harmonic parameter models of electrical transformers, generators, transmission lines and electrical loads in detail

    本文較為詳細的推導了電力變壓器、發電機、輸電線路、電力系統負荷等的諧波參數模型。
  5. Validate system load flow and fault models using instantaneous voltage angles. use system - state measurements to increase stable system loading through reduced margin requirements

    批準電力潮流和故障類型使用瞬時電壓角度.通過縮減利潤需求，使用系統狀態測量以增加穩定的系統負荷
  6. All of the above will be a basis for the studies of flow load control, power supply recovery and damage loss mitigation of power system after earthquake

    該工作可為震后電力系統負荷快速調整、震區供電系統較快恢復電力供應，減少供電工程系統的損失提供理論分析依據。
  7. The assignment of the load of the steam turbine can be solved by the reverse follow, the assignment of the load of the boiler can be solved by dsfd

    根據兩種規劃問題的特點，汽輪機系統負荷分配問題採用分枝限界反向跟蹤的優化演算法來求解，鍋爐系統負荷分配問題採用轉動坐標軸直接搜索可行方向法（ dsfd法）來求解。
  8. The model of fujian power grid and models of generators, excitation systems, governor systems and loads are established, the tested excitation system models of large hydro and thermal units, the model of wind turbine are established as well in this paper with pss / e, a new software imported from pti of u. s. a. recently. some key points are proposed on data convertion from psasp and bpa to pss / e. the transient and dynamic characteristics between separate excitation system and transformer - fed excitation ( self excitation ) system are compared with pss / e

    本文完成了pss e的福建省電力系統的基本框架以及發電機、勵磁系統、調速系統、負荷的數學模型和參數，實現了大型水、火電廠發電機組勵磁系統實測模型和風電機組的pss e建模，提出了pss e與bpa 、 psasp數據互轉的部分要點，比較了福建電力系統現有大型水、火電廠發電機組它勵與自並勵勵磁方式的動態和暫態性能的差別。
  9. In sum, the main contents of the thesis include : 1. analyses of the impact of different load characteristics on static voltage stability with the v - p - and - v - q curves of power system loads

    歸納起來，本文的主要內容包括: 1 .應用電力系統負荷的電壓-功率特性曲線，分析了不同負荷的負荷特性對靜態電壓穩定性的影響。
  10. The essay combines the power system prediction, mathematical build modular technology and computer technology together and thoroughly and systematically makes an analysis, thus the software functions designed can meet the needs of power system load prediction

    論文將電力系統負荷預測分析、數學建模技術、計算機技術有機結合，進行了深入、系統地分析。所設計的軟體功能較好地滿足了電力系統負荷預測的需求。
  11. This system adopts " 3 - tiers " framework, and remedies the limitation of traditional distributed system. the system consists of server, middle components and clients, these parts balance the load and advance the capability of whole system

    系統的三層體系分別由服務器、中間層和客戶端三部分組成，這三部分合理的平衡了系統負荷，充分利用了網路計算資源，提高了系統的整體性能，增加了系統應用廣泛性。
  12. It belongs to heuristic optimization methods. since loads are varying all the time, we should adjust the topology to reduce the power losses

    由於系統負荷是不斷變化的，針對不同的負荷情況應該調整網路拓撲結構以達到網損最小的目的。
  13. The result is a rapidly growing proliferation of pointless emails that can increase to such an extent that they overload systems

    結果，該等無意義的電子郵件迅速擴散，其增長程度足以令系統負荷過重。
  14. The history and current development of power system load modeling are briefly summaried, including the concepts, models, identifiability and identification methods. this paper focus on load model in the following three aspects with applications : 1. influences of local power plant on load modeling

    本文概述了電力系統負荷建模的發展、現狀，介紹了負荷建模的概念、方法、常見模型及其參數可辨識性問題和辨識方法，著重研究了負荷建模工程應用中的幾個重要問題： 1 、研究了地方發電廠對于區域負荷建模的影響。
  15. As the res ult, probabilistic dynamic security and integrated assessment indices based on system, load point and element levels are introduced

    在此基礎上，建立了系統、負荷節點和元件三個層次的電力系統概率動態安全和概率綜合安全指標體系。
  16. Load forecast is the foundation of power system operating dependably and economically

    電力系統負荷預報是電力系統安全、經濟運行的基礎。
  17. With the quick development of the industry and agriculture, the category of electric power system gradually increases

    近幾年來，隨著工農業生產的迅速發展，電力系統負荷種類也日趨增多。
  18. This present thesis analyzes the characteristics of the load in - depth. and studies the factors which effect the precision of the load forecasting, such as the type of day, special holidays, all kind of weather factors and so on

    通過對電力系統負荷特性的認真深入分析，總結了影響短期負荷預測的各種因素如日類型、特殊節假日、各種天氣因素等。
  19. , : after review fair queuing algorithms, the chapter 5 places emphasis on wfq ( weighted fair queuing ) performance analysis and concludes that wfq has certain capability of resisting h

    第五章首先介紹了幾種公平排隊演算法，重點分析了wfq的性能，得出了wfq具有一定的抗高等級突發的能力，該能力和業務的突發程度、系統負荷和各等級的權值分配有關。
  20. System operators can grasp the all units " states in global and by the simulation results they can make out correct the dispatching method, improve the performance of whole power system and decide rightly the quantity of units which can satisfy the load requirement of current power system

    而且利用這種模擬演算法和機組調度演算法結合的模擬軟體可以模擬機組的調節過程，由這一模擬過程可以制定相應的調度策略，改善負荷調節與系統需求趨勢相反的機組的運行狀態，更好的確定適應系統負荷需求量的機組。
分享友人
分享到 Line

分享到臉書