組合轉接器 的英文怎麼說

中文拼音 [zǔgězhuǎnjiēqì]
組合轉接器 英文
integrated adapter
  • 組 : Ⅰ名詞1 （由不多的人員組成的單位） group 2 （姓氏） a surname Ⅱ動詞（組織） organize; form Ⅲ量詞（...
  • 合 : 合量詞（容量單位） ge, a unit of dry measure for grain （=1 decilitre）
  • 轉 : 轉構詞成分。
  • 接 : Ⅰ動詞1 （靠近;接觸） come into contact with; come close to 2 （連接; 使連接） connect; join; put ...
  • 器 : 名詞1. （器具） implement; utensil; ware 2. （器官） organ 3. （度量; 才能） capacity; talent 4. （姓氏） a surname
  • 組合 : 1 （組織成為整體） make up; compose; constitute 2 （組織起來的整體） association; combination3 [...
  • 轉接器 : adapter
  • 轉接 : change-over; throw-over; switch; transfer; transit; reset; adapter coupling; built-up connection
  1. Driveequipment use active magnet connected - implement to firsthand fix at the axletree of electrical engine, pumproom close completely, via magnetic force coincidence to drive impeller on rotor - assembled to circumgyrate indirectly

    驅動裝置採用主動磁鐵聯軸器直接裝在電機軸上，泵室完全封閉，通過磁力偶合間接驅動轉子組合上的葉輪旋轉。
  2. This paper presents our research in actuating in - vivo micro - robot based on the capsule endoscope platform by the external power. while seeking secure driving method we take several factors into account, such as driving environment, power transmitting and consuming, motion requirement and controllability, and locating technique. we mainly deal with driving the capsule with spatial gradient magnetic field, so we employ combined electro - magnetic coils, including gradient coils and homogenous coils, which have rotational dof around a translatable patient bed, to compose a controllable uniform gradient which act on the permanent - magnet embedded robot, thereby get an appropriate spatial force and torque to fulfill the anticipant locomotion such as move, stop, pitch and yaw

    基於驅動環境、能量供給和消耗、驅動動作要求及驅動安全性與可控性，定位方案等多方面考慮，尋求安全可靠的腸胃檢查微機器人的外部驅動控制方法，並著重研究直接利用外磁場磁力驅動微機器人:在微機器人內部嵌入永磁性體，利用體外的組合電磁線圈產生加載電流控制的驅動磁場，其中外部的電磁線圈由多組梯度線圈和勻場線圈組合構成，通過繞病床的旋轉以及病床的平移共同控制微機器人所在位置的磁場強度及梯度，作用於微機器人內嵌磁體以獲得空間意義上的必要驅動力和調整轉矩，從而有效地完成驅動動作要求。
  3. Zhong tian electronic & electrical factory, and experienced and professional manufacturer of high - quality combined outlet and joint commutator, is the menber of the electrical accessory branch of china electrical industrial associantion

    中山市小欖鎮中天電子電器廠是有多年專業生產高素質組合扦座、連接轉換器的生產廠家，中國電器工業協會電器附件分會會員。
  4. Through analysising the characteristics of the power system with floating neutral point deeply, the paper puts forward a new plan of single - phase to ground fault line selection on the base of s ' s signal injecton method and gives the hardware and software design. in this design, the high speed sampling and data processing is carried out through using dsp processor ; the large electrice current is drived through the application of a high - performance audio power amplifier and transformer ; the communication between host computer and detectors is realized through rs485 bus technology ; the difference multilevel frequency - selected amplifier is designed and the feeble signal of space is sampled on the base of the theory of magnetic induction ; the interface between dsp and exterior chip and rs485 interface logical is designed through using fpga ; the using of lcd module and keyboard interfacing chip makes the interface between human and machine ; the programme of host computer and detectors is designed through using blocking design method

    在本設計中，採用高速的dsp處理器，實現了對故障特徵信息的高速採集與處理;採用大功率的功放晶元與變壓器配合的方法，實現了大電流信號的驅動輸出;採用485總線技術，組建了裝置主機與多探測器之間的主從式通訊網路，實現了多干擾條件下裝置主機與多探測器的可靠通訊;設計了差分式多級選頻放大電路，採用磁感應的方法實現了對空間微弱信號的接收;利用fpga技術，實現了控制器與多外設的介面及數字信號的串並轉換;採用了先進的lcd液晶顯示模塊及鍵盤介面晶元，設計了人機信息交互的介面;採用了模塊化的軟體設計方法，開發了裝置主機及探測器的軟體程序。
  5. The thesis analyse the error and the feasibility of the system. because the precision of position and direction is related with the precision of the heading and the distance, the thesis discuss the method of obtaining the distance using milemeter, water milemeten engine ' s rotate speed and accelerometer, and the method of obtaining the heading using the combination of the gyrocompass and the digital compass. then the thesis introduce the details of the system realization, include the hardware and the software

    由於航位推算的精度與航程和航向的精度直接相關，因此，論文討論了用里程計、水速表、引擎轉速或加速度計等獲取里程的方法，用航向保持器和數字磁羅盤組合的方法獲取航向角的方法（初始尋北由數字磁羅盤來完成） ，這為採用數據融合方法提高航程和航向精度打下了基礎。
  6. This control system adopts creditable plc for real control ; it sends many simulating signals collected by old sand temperature of inlet, suction opening temperature of double disk, inner sand temperature of double disk, current of mainframe and current of fan ; meanwhile, the operation signal and switching value signal outputted by material movement transducer is inputted to switching value module of plc ; it gets evidence of water feeding after cpu account ; the operation result of cpu is outputted by switching value of plc to control unlock combination of coarse, middle and thin water feeding electromagnetically operated valve and then gets different water feeding quantity

    該控制系統採用高可靠性的plc可編程序控制器進行實時控制，傳感器所採集的入口舊砂溫度雙盤抽風口溫度雙盤內砂溫主電機電流及鼓風機電流等模擬量信號直接輸入plc的模擬量採集模塊，同時加砂設備運轉信號及加砂設備物料移動檢測傳感器發出的開關量信號輸入plc的開關量模塊，由cpu獲取經運算而得到加水計算依據， cpu運算結果直接由plc的開關量輸出控制粗中細加水電磁閥的開啟組合，而得到不同的加水量。
  7. In the second chapter, equivalent circuit of the eddy current sensor is firstly analyzed. based on that, the carrier signal generating circuit that is realized by the lc periodic circuit is introduced, thus, the carrier signal of standard frequency is obtained through the trimming capacity. subsequently, the disc type rotational armature generator and the rotational coupling transformer are separately leaded in to realize the power supplies of the carrier signal generating circuit and output of the measuring signal

    在傳感器設計一章中，首先對渦流傳感器進行等效電路分析，在此基礎上分析了由電感、電容諧振電路構成的載波信號發生電路，並通過微調電容獲得了標準頻率的載波信號；接下來提出了採用盤式旋轉電樞發電機解決載波信號發生電路電源供給問題的方案，同時通過旋轉耦合變壓器的引入，使得測量信號輸出問題很好地解決；本章最後給出的一組實驗曲線充分說明了這一方案的可實現性。
  8. Air filtration portfolio, air filters, valve, oil mist machine, filter valve, oil mist separator, micro - mist separator, stability activated solenoid valve, pressure gauge, micro - valve and vacuum valves, links the release of the closure - pressure valves, and pipe connection, a one - way valve, t - shelves, shelves, brackets, diaphragm - type flow switches, blades type flow switches, further growth actuator, the valve lock, precision valve, pressure switches, mechanical pressure switches, pneumatic control ratio positioning devices, and electric - gas ratio positioning devices, and telecommunications - pressure converters, electro - pneumatic proportional valve, filter valve, shuttle valve, gas - electric relay and gas indicator, delay pneumatic valve and cylinder fcl, plumbing fcl, mufflers and exhaust cleaner, the excess flow valve with silencer, a one - way valve, rapid valve, rapid joints, rapid valve with fcl, rapid joint sub - cluster gas, micro joints, gas pipes, pipe from the devices, and helical coils, pipes, channels, scissors, multiple fastener, high - speed rotary joint, 10000 threaded joints, and insert the tube joints, rotary joints began, 68. 25 rapid joints and hoses, hose fittings and rapid non - electrostatic

    空氣過濾組合空氣過濾器減壓閥油霧器過濾減壓閥油霧分離器微霧分離器穩定啟動電磁閥壓力表微型減壓閥減壓氣閥三通釋放式截流閥壓力開關管接頭單向閥t型隔板隔板托架膜片型流量開關漿葉型流量開關增速繼動器鎖定閥精密減壓閥壓力開關機械式壓力開關氣控比例定位器電-氣比例定位器電訊號-氣壓轉換器電-氣比例閥過濾減壓閥梭動閥氣-電繼電器氣源指示器氣動延時閥氣缸限流器管道限流器消聲器排氣潔凈器限流閥帶消聲器單向止回閥快速排氣閥快速接頭快速排氣閥帶限流器快速接頭集束分氣微型接頭氣喉管喉管脫離器螺旋管排管管道剪刀多管扣件高速旋轉接頭萬用螺紋接頭插入式管接頭旋式緊鎖接頭難燃性快速接頭和軟管不帶靜電快速接頭和軟管
  9. We propose the joint filterbank precoders and decision feedback equalizers structure at first, by which the dispersive channel is equivallent into parallel independent flat fading subchannels such that the diversity gain of the receiver is increased. then we adopt the discrete - time ( dt ) canonical model to convert the problem of blind signal processing of tv dispersive channels into processing the time - invariant multi - channels model blindly, and discuss the problem of blind equalization and identification of tv dispersive channels based on this new model

    第一種是採用濾波器組聯合均衡方法將色散通道等價為一組獨立的平坦衰落子通道，以提高接收機的分集增益；另外一種是提出採用離散正則模型將時變色散通道的盲信號處理轉化為時不變多通道模型的盲信號處理，並針對該模型對時變色散通道的盲均衡與盲辨識方法進行了詳細討論。
  10. Some hybrid frequency synthesis methods for dds + pll which used usually are presented in the following section, and its analysis for phase noise, spur, and frequency jump speed was also introduced

    接著對dds + pll頻率合成器常用組合方案進行了介紹，並對dds + pll系統的相位噪聲、雜散、頻率轉換速度進行了分析。
  11. In order to improve the performance of the ac adjustable speed system and reduce the pollution to power network, a compound control strategy that combines matrix converter ( mc ) with direct torque control ( dtc ) is proposed

    摘要為提高交流調速系統的性能，並且減小對電網的污染，提出了一種將矩陣式變換器與直接轉矩控制相結合的組合控制策略。
  12. Matrix converters have received considerable attention in recent years, but the study focus is on matrix converter per se. a combined control strategy for matrix converter fed induction motor drive system is proposed, which implements both space vector modulation of matrix converter and direct field oriented control of induction motor

    摘要提出了一種適用於矩陣變換器供電的異步電動機調速系統的組合控制策略，同時實現了矩陣式變換器的空間矢量調制和異步電動機的定子磁場定向直接轉矩控制。
分享友人
分享到 Line

分享到臉書