結晶偏析 的英文怎麼說

中文拼音 [jiējīngpiānxī]
結晶偏析 英文
coring
  • 結 : 結動詞（長出果實或種子） bear （fruit）; form （seed）
  • 晶 : Ⅰ形容詞（光亮） brilliant; glittering Ⅱ名詞1. （水晶） quartz; （rock） crystal 2. （晶體） any crystalline substance
  • 偏 : Ⅰ形容詞1 （不正; 歪斜） inclined to one side; slanting; leaning 2 （只側重一面） partial; prejudi...
  • 析 : Ⅰ動詞1. （分開; 散開） divide; separate 2. （分析） analyse; dissect; resolve Ⅱ名詞（姓氏） a surname
  • 結晶 : 1 （析出晶體） crystallize2 （晶體） crystal 3 （成果） crystallization; fruit; product; quintess...
  1. The degrees of crystallinity of pure ptfe under the different conditions of water cooling, air cooling and furnace - varying cooling were made comparison by xrd. the thermal stability of pure ptfe and solid lubricant was analyzed by dsc - tg ; the composition and valence state of elements in the surface of carbon fiber, solid lubricant before and after friction test and lubricant transfer film were characterized by xps ; the frictional property of solid lubricant was tested by pin and disk test rig. the frictional wear property of solid lubricant between embedded bearing sleeve and steel axle friction pair ring was tested by special simulate test machine, the hardness of solid lubricant was tested by pm ; the compression strength of solid lubricant was tested by material test machine

    用sem表徵原料微觀結構、摩擦表面及潤滑轉移膜表面形貌：用xrd進行原料物相分析，及比較水冷卻、空氣冷卻、隨爐冷卻三種工藝條件下的純聚四氟乙烯樹脂的結晶度；用dsc - tg分析純聚四氟乙烯樹脂及固體潤滑劑的熱穩定性；用xps表徵碳纖維表面、固體潤滑劑摩擦前後表面、潤滑轉移膜表面的元素組成、價態變化；用銷盤式摩擦磨損試驗機對固體潤滑劑進行摩擦性能測試；採用專用的臺架模擬試驗機對固體潤滑劑鑲嵌軸承套與鋼軸摩擦副間的摩擦磨損性能進行測定；用萊次偏光顯微鏡（ pm ）測試固體潤滑劑的硬度；用材料試驗機測試固體潤滑劑的抗壓強度等。
  2. This has an important meaning to the industrial manufacture. dsc, waxd and polarizing microscope with hot stage experiments were performed to describe what led the ssp rate acceleration of pet / mmt. it was shown that montmorillonite acted as a very good nucleating agent in pet crystallization process, which results in the lower crystallinity, more small microlites, and more surfaces of microlites

    為研究pet mmt固相縮聚效率提高的原因，通過熱臺偏光顯微鏡、 dsc 、 x -射線衍射等手段對樣品的結晶進行觀察與分析研究，結果表明蒙脫土對pet的結晶有明顯的成核作用，使其晶核生成速率迅速提高，晶核數量明顯增多，從而使整個結晶過程的時間變短，同時形成了更多結構不完善的微晶體。
  3. Abstract : the crystal structures obtained by static solidification and vibration solidification were compared. it was showed that, in the case of vibration solidification, the orientation growth of the columnar crystal was not obvious, the equiaxial crystal appeared more early. the grains of both types of crystals were quite fine, hardness in the full section was relatively high, and the hardness distribution was uniform. in the former case, the solute segregation in dendritical austenite more severe, and there were lumps of distortion inclusion

    文摘:對球鐵金屬型靜凝固與振動凝固的結晶組織對比表明：後者柱狀晶方向性生長較弱，等軸晶出現較早，且兩者的晶粒均較細，全斷面硬度較高且分佈均勻；前者枝晶奧氏體內溶質偏析大，有畸變夾雜團塊。
  4. Polaride microscope and scanning electron microscope ( sem ) were used to study the molecule texture and the polymer network structure. the paper had compared the difference between the polymer of the traditional polymer network liquid and the egdmma polymer and analyzed the polymerization mechanism

    採用正交偏光顯微鏡和電子掃描電鏡研究了聚合物網路形貌和結構，比較了傳統的聚合物網路穩定液晶中聚合物的差異，並分析了聚合機理。
  5. To accept the current signal from high negative voltage circuit, the analog ground is raised to a certain positive voltage, which makes it possible for the signal amplitude to be compressed at the same time of its polarity reversion. a pi control program special for laser gyro current control is brought forward according to the conventional pid control method, in which the control signal is figured out corresponding to the difference between the sample and the reference value by turn of proportion - short step integral - long step integral. and at the end of this paper, a comparison of system performance on different conditions is made and the key elements influencing system performance are educed

    利用集成a / d 、 d / a轉換器的新型晶元aduc824 ，實現了電流（電壓）采樣?數據處理?電流控制的閉環控制結構；地電位的抬升解決了a / d轉換器對負高壓迴路電流采樣時的輸入范圍匹配問題；控制信號反相的同時進行幅度壓縮，使得輸出調整電壓的解析度提高；根據常規的比例?積分?微分（ pid ）調節模型，針對陀螺系統的特性，給出了一種可以滿足系統要求、據采樣值偏差大小進行的比例?大步長積分?小步長積分、分層次比例?積分演算法；不同條件下系統穩流性能的對比、分析在論文最後給出，並據此找出了決定該系統穩流精度的關鍵因素，提出了系統的改進意見。
  6. The change regularity for performance and microstructure of low carbon steel is summarized. the main characteristic of the process is pearlite spheroidizing, increasing of grain boundary width, element segregation and carbide in grain boundary. the change of those microstructure causes the variance of the merchant performance

    通過上述的研究工作，總結了火力發電廠用低碳鋼在長期運行期間性能與微觀結構的變化規律，提出以珠光體球化、晶界寬化、元素晶界偏聚及碳化物晶界析出為主要特徵的低碳鋼微結構變化規律，以及由此而引起的材料機械性能的變化。
分享友人
分享到 Line

分享到臉書