結晶學指數 的英文怎麼說

中文拼音 [jiējīngxuézhǐshǔ]
結晶學指數 英文
crystal indices
  • 結 : 結動詞（長出果實或種子） bear （fruit）; form （seed）
  • 晶 : Ⅰ形容詞（光亮） brilliant; glittering Ⅱ名詞1. （水晶） quartz; （rock） crystal 2. （晶體） any crystalline substance
  • 學 : Ⅰ動詞1 （學習） study; learn 2 （模仿） imitate; mimic Ⅱ名詞1 （學問） learning; knowledge 2 （學...
  • 指 : 指構詞成分。
  • 數 : 數副詞（屢次） frequently; repeatedly
  • 結晶 : 1 （析出晶體） crystallize2 （晶體） crystal 3 （成果） crystallization; fruit; product; quintess...
  • 指數 : 1. [經] （比數） index number; index 2. [數學] exponent
  1. According to the guidline, two nd : yag lasers have been designed and set up, one is end - pumped by lower output power ld using a selfoc micro lens, and the other is end - pumped by high output power ld using a pair of lenses are designed, and the characteristics such as output power and power stabilization of both solid - state lasers are investigated. thirdly, when an empty liquid crystal cell is inserted in the cavity of the nd : yag laser pumped by high power ld, the laser can operates in single axial mode. finally, according to the relationship between the laser output power and the longnitudinal a ld - end - pumped nd : yag laser sensor for displacement measurement has been investigated theoretically and demonstrated experimently, the results indicate that when the mean radius of pumping inside the laser cavity is far less than that of the oscilating laser mode, the exponential of the output power is a gauss function of the longitudinal positon of focused spot of ld pumping beam, both the measurement range and the sensitivity are dependent on the incident pumping power, as the incident pumping power is increased, the measurement range is enlarged and the sensitivity is improve d

    本文首先介紹了ld泵浦nd ： yag激光器的發展狀況、主要特性及其應用，從四能級速率方程出發，推導了ld泵浦nd ： yag激光器的閾值、輸出功率和斜效率的表達式，並簡述了激光器的工作原理、結構型式和倍頻方法；其次，以空間相關的速率方程為基礎，提出了ld端面泵浦nd ： yag激光器的設計方法，給出了一定泵浦耦合方式下，振蕩光模尺寸、最佳輸出耦合率、泵浦光模尺寸、泵浦光焦斑位置等參數的選取依據，以此為依據，設計了自聚焦透鏡耦合小功率ld泵浦nd ： yag激光器和透鏡組耦合高功率ld泵浦nd ： yag激光器，對激光器的輸出功率和功率穩定性等特性進行了實驗研究；再次，在帶尾纖輸出的高功率ld泵浦nd ： yag激光腔內插入一隻空液晶盒，觀察到了激光器以單縱模運轉；最後，根據泵浦光焦斑端面位置對激光輸出功率的影響規律，提出了ld端面泵浦nd ： yag激光位移傳感新方法，並進行了理論和實驗研究，研究結果表明：當激光晶體內泵浦光平均光斑半徑遠小於振西安理工大學碩士學位論文蕩光束腰半徑時，激光輸出功率的自然指數與泵浦光焦斑的縱向位置成高斯變化規律，測量范圍和靈敏度依賴于泵浦功率，隨著泵浦功率的增加，測量范圍擴大，靈敏度提高，當端面泵浦功率為7 . 24w （最大輸出功率為1 . 926w ）時，激光位移傳感器的測量范圍和靈敏度分別是13 . 045mm和0 . 148mw / pm 。
  2. The calculation of surface energy of metals al, cu and ni by using the molecular dynamics combining the eam potential, we calculated the surface energy of some high miller index surfaces belong to the ( 001 ) to ( 111 ) and ( 001 ) to ( 110 ) in al, cu and ni

    金屬表面的表面能的計算基於半經驗嵌入原子勢（ eam ）的分子動力學方法，對al 、 cu 、 ni三種金屬位於[ 001 ]晶帶和[ - 110 ]晶帶的高密勒指數表面的表面能進行了分子動力學模擬計算，計算結果同已有的實驗結果相符合。
  3. Clothing industry has always been one of the most important industries in china ， among china ’ s whole exports ， the clothing export has been holding the important status from this point of view, and on the basis of analyzing the history and current situation of china ’ s clothing industry, this paper points out the advantages of china ’ s clothing export with using the concerned theories of international trade in general ， china ’ s clothing trade is growing steadily ， but along with the intensify of the world clothing industry ’ s competition ， the superiority of china ’ s clothing export is becoming less and less by analyzing the main counterparts of china ’ s clothing trade ， that is the import features and trend of usa 、 eu 、 japan and hong kong ， this paper gives the main problems that china ’ s clothing industry exists at present with designing the system structure for elements of affecting the clothing requirements ， this paper uses ahp, grey 7heory and fuzzy theory to analyze the elements of affecting the clothing export and put them to order according to the degree of importance ， which scientifically proves that the main elements that affect the clothing export are the green trade barriers 、 brands and styles ， etc to counter these elements this paper supplies detailed suggestions on china ' s clothing trade management strategies these suggestions are practidal and operational ， which must have a constructive role on china ’ s clothing industry entering into the world

    本文通過分析中國服裝貿易的主要夥伴，即美國、歐盟、日本和香港的進口特點和趨勢，指出中國服裝行業目前存在的主要問題。通過設計影響服裝需求因素的體系結構，運用層次分析法、灰色模糊理論、模糊數學對影響服裝行業出口的因素進行定量化方法分析排序，科學合理地分析出影響服裝出口的主要因素為綠色貿易壁壘、晶牌和服裝款式等，並針對這些因素詳盡地提出了中國服裝貿易經營戰略的建議。這些戰略性的建議具有可行性和可操作性，必將對中國的服裝行業走向世界起到建設性的作用。
  4. By means of the calorimetric experimental results and the temperature dependence of heat capacity differences, four kinds of temperature dependences of configurational entropy, dielectric relaxation index and cooperatively rearranging region are studied, on the basis of configurational entropy theory on cooperatively rearranging region in disordered amorphous materials by the methods of the relationship between configurational entropy and heat capacity difference, and the equation of relaxation time with activated energy barriers

    摘要基於無序非晶材料「關聯重排區域」的構型熵理論，運用構型熵與熱容量差的關系式、弛豫時間與活化勢壘的基本公式，及聚合物量熱學的實驗結果和熱容量差與溫度的基本關系，研究了4種情況下構型熵、介電弛豫指數和關聯重排區域大小的溫度變化關系。
  5. According to the raman selection rule and the pl measurement, it is reasonable to evaluate the quality of galnp / algalnp mqw by analyzing the relative intensity ratio of a1p - lo / to. ( 4 ) a new modified random element isodisplacement ( mrei ) model is set up to calculate the dependence between the long - wavelength optical phonon frequencies and the composition of iii - v - type ab1 - xcx mixed crystals. the second neighbor force constants are still assumed to be a linear variation with the composition, but the two first neighbor force constants can be evaluated to be a negative exponent variation with the composition, using the overlapped repulsive potential of the ion crystal combination

    通過實驗我們找到了在這些結構參數上生產gainp algainpmqw的較理想的結果； （ 3 ）首次用喇曼（ raman ）散射方法研究了常溫下的gainp algainp多量子阱結構，除了指認出喇曼光譜中各光學聲子模外，還結合樣品光致發光譜的測量結果，分析發現喇曼光譜中alp - lo to的相對強度比可以在一定程度上評定晶體gainp algainpmqw的生長質量； （ 4 ）在修正的隨機元素等位移? mrei模型的基礎上建立了一個新模型，計算了ab _ （ 1 - x ） c _ x型?族半導體混晶的長波長光學聲子模頻率的組分變化關系。
  6. Both the qualitative pictures and the quamitative data, such as grain growth kinetics exponent ( aboul 1. 8 in the early stage and 5. 5 in the late stage of grain growth ) and the values of fractal dimension ( about 2. 6 in the early stage and 2. 2 in the late stage of grain growth ), show that the simulation work is in good agreement with experimental results reported

    不論是從定性的模擬圖形分析還是從定量的晶粒生長動力學指數k （生長初期約為1 . 8 ，生長後期約為5 . 5 ）或是晶界的分維值d （生長初期約為2 . 6 ，生長後期約為2 . 2 ） ，都說明我們的模擬工作與其它報導的實驗結果互相一致。
  7. The thesis is composed of 9 parts : the background, significance, main topics and innovations in the thesis are introduced in chapter 1 ; in chapter 2, the main function and performance of interface circuits are described from the view of system by using the example of gigabit ethernet ' s transceiver ; the transmission media ' s frequency characteristics and model are analyzed for the high - speed data transmission system in chapter 3 ; the line driver is presented in chapter 4 ; the equalization principles for high - speed data transmission system are introduced in chapter 5 ; a novel adaptive equalizer for 1000base - cx transceiver is presented in chapter 6 ; in chapter 7, a fixed equalizer for 2. 5gbps transceiver is described ; in chapter 8, layout design and measured results are discussed ; at last, the conclusions are drawn in chapter 9. during period of finishing the thesis, i read lots of literatures about the interface circuits in high - speed data transmission system, studied their principles and design techniques, and designed : 1 、 the line driver for 2. 5gbps baseband copper cable transceiver ; 2 、 the fixed equalizer for 2. 5gbps baseband copper cable transceiver ; 3 、 the fixed equalizer for 1. 5gbps sata ( serial at attachment ) transceiver ; 4 、 an adaptive equalizer for 1000base - cx transceiver

    論文由9部分組成：在第一章引言中介紹了論文的背景、意義、國內外研究現狀，以及論文的主要內容和創新；第二章以千兆位以太網為例，從系統的角度介紹了高速數據傳輸系統介面電路的主要功能和性能指標；第三章分析了高速數據傳輸系統的傳輸介質的頻率特性和模型；第四章描述了線驅動器的設計原理及其電路實現；第五章描述了高速數據傳輸系統的均衡原理；第六章描述了適用於1 . 25gbps基帶銅纜收發器系統的自適應均衡器的設計原理和電路實現；第七章描述了適用於2 . 5gbps基帶銅纜收發器系統和1 . 5gbps串列硬盤介面（ sata ）收發器系統的固定均衡器的設計原理及其電路實現；在第八章中分析了電路的版圖設計及晶元測試結果；最後，第九章總結了全文。在完成論文期間，查閱了大量的有關高速數據傳輸系統介面電路方面的文獻，較系統地學習了線驅動器、傳輸線和均衡器等方面的理論知識和電路設計原理，設計了用於： （ 1 ） 2 . 5gbps基帶銅纜收發器系統的線驅動器； （ 2 ） 2 . 5gbps基帶銅纜收發器系統的固定均衡器； （ 3 ） 1 . 5gbpssata系統的固定均衡器； （ 4 ） 1 . 25gbps基帶銅纜收發器系統的自適應均衡器。
  8. The studies of crystallization kinetics of the composites indicated that isothermal and non - isothermal crystallization behaviors could be described by avrami equation, and the avrami exponents were between 2 and 3. so it could be concluded that the mode of crystallization growth was mainly three dimensions spherulity and two dimensions dish

    通過對復合材料結晶動力學研究表明：復合材料等溫及非等溫結晶行為均可用avrami方程來描述， avrami指數n約在2 3之間，從而推測體系中晶體生長方式以球晶三維和盤狀二維生長為主。
分享友人
分享到 Line

分享到臉書