結構半不變量 的英文怎麼說

中文拼音 [jiēgòubànbiànliáng]
結構半不變量 英文
structure semi invariant
  • : 結動詞(長出果實或種子) bear (fruit); form (seed)
  • : Ⅰ動詞1 (構造; 組合) construct; form; compose 2 (結成) fabricate; make up 3 (建造; 架屋) bui...
  • : Ⅰ數詞1 (二分之一) half 2 (在 中間的) in the middle; halfway 3 (比喻很少) very little; the l...
  • : 名詞[書面語] (剁物所用的木墩) a block of wood
  • : 量動1. (度量) measure 2. (估量) estimate; size up
  • 結構 : 1 (各組成部分的搭配形式) structure; composition; construction; formation; constitution; fabric;...
  1. The study in the paper starts with beam distortions, and it treats the plastic deformation area as pure bending sect, rest of the beam as rigid bodies. according to different shapes of the external tendons, it divides into three structural forms familiar in projects, that is the beams with no deviator, with a deviator and with two deviators, and studies the relation between the deformation of the external prestressing tendons and that of the beams, and derives the formulas of the ultimate stress increment of external tendons. in the formulas, the ultimate angle corresponding to half of the plastic deformation area is considered as a variable parameter

    本文首先從梁極限狀態下的形入手,將塑性鉸區看作純彎段,將塑性鉸以外的區域看作剛體,按照體外預應力筋的形狀同,分工程中最常見的三種體外形式,即無轉向塊的直線型體外筋混凝土梁、具有一個轉向塊的單折線型梁和具有兩個轉向塊的雙折線型梁,研究體外預應力筋形和梁體的形間的關系,推導出以極限狀態下塑性鉸區之對應的轉角為參數的計算體外預應力混凝土簡支梁以及連續梁的體外筋應力增計算公式,並進一步求得梁的極限承載力。
  2. It is an effect method to model complex system with qualitative - quantitative information to correctly build the semi - quantitative restrict between variables of system according to quantitative information of part variables in incomplete knowledge complex system

    摘要根據知識完備的復雜系統中部分的定信息,合理地造系統相關間的約束,是建立復雜系統定性定合模型的有效方法。
  3. The mode competition is much improved. it may operated with a large electron beam radius, that means decreasing the space charge effects compared with a smaller radius beam with the same current, hence the rbwo may operated with a low axial guide magnetic field. besides, the rbwo with a sinusoidal corrugated coaxial structure is very easy to manufacture

    波紋內導體rbwo具有一些突出優點:同軸中內導體的存在使系統的截止頻率顯著升高,使得系統尺寸可比普通波紋波導慢波系統大;具有很大的抑制模式競爭的能力和很高的功率容;可以採用大徑電子注,在工作電流的情況下空間電荷效應大幅度降低,因而可以工作在低磁場狀態;此種慢波內導體上的波紋易於加工。
  4. A calculation comparison on the pipeline network system consisting of pipe sections of short length is made herein with three calculation methods respectively, i. e. neglecting the local energy loss at junctions ; adopting constant local energy loss coefficients and the semi - empirical relationships based on experimental data related to the flow conditions, from which the calculated results for the flow rates of the pipe sections are largely deviated

    文中分別應用三種計算方法,即忽略點處局部能損失、採用恆定點局部能損失系數,以及根據試驗成果所得的與水流條件有關的經驗公式,針對短管段成的管網系統進行了計算比較,管段流的計算果相差很大。
  5. In the design of real - time control system, the paper takes three - phase full - bridge mosfet inverter as the real - time control main circuit, and adopts a control scheme with 120 ? switching mode combined with half - bridge pulse width modulation ( pwm ), which would avoid straightthrough short of a certain bridge. phase current is detected by single current sensor ; three - phase position signals generated by position sensors could not only supply commutation information for inverter, but also be used for speed detecting based on signals " period measurement, which makes the speed sensor unnecessary. the whole control system adopts speed and current dual closed - loop control strategy in order to construct a high performance rare - earth permanent magnetic brushless dc motor ( repm bldcm ) full - digital real - time control system

    在實時控制系統的設計中,本文以三相全橋mosfet逆電路作為實時控制主電路,採用120導通方式橋pwm調制的控制方案,從而有效地避免了橋臂的直通短路;本文用單電流傳感器實現對相電流的檢測,來自位置傳感器的三相位置信號僅為逆電路提供換相信息,而且也用於基於信號周期測的轉速檢測,這樣就省去了速度傳感器;系統採用的是速度、電流雙閉環控制策略,力求建高性能的稀土永磁無刷直流電動機全數字實時控制系統。
分享友人