絕熱反應溫度 的英文怎麼說

中文拼音 [juérèfǎnyīngwēndù]
絕熱反應溫度 英文
adiabatic reacxtion temperature
  • 絕 : Ⅰ動詞（斷絕） cut off; sever Ⅱ形容詞1 （完全沒有了; 窮盡; 凈盡） exhausted; used up; finished 2 ...
  • 反 : Ⅰ名詞1 （方向相背） reverse side 2 （造反） rebellion 3 （指反革命、反動派） counterrevolutionari...
  • 應 : 應動詞1 （回答） answer; respond to; echo 2 （滿足要求） comply with; grant 3 （順應; 適應） suit...
  • 溫 : Ⅰ形容詞（不冷不熱） warm; lukewarm; hot; gentle; mild Ⅱ名詞1 （溫度） temperature 2 （瘟） acute ...
  • 度 : 度動詞[書面語] （推測; 估計） surmise; estimate
  • 溫度 : [物理學] temperature
  1. The temperature rise at the center of a massive concrete wall is calculated by using the adiabatic rise of temperature and heat conduction equations of concrete based on the equivalent time, and considering effects of temperature on the hydration heat reaction ratio and creep characteristics of early - age concrete

    摘要基於等效時間的混凝土絕熱溫升、熱傳導方程，考慮溫度對早期混凝土水化熱化學反應速率和徐變特性的影響，計算了大體積混凝土墻中心的溫升。
  2. Fouriertransformation infro - red microspectroscopy micro - ftir technique was used to investigate the chemical compositions and structures of cutinite, vitrinite and fusinite from jurassic coals in tarim basin at different temperatures. the results show that the chemical structure of cutinite is mainly composed of long aliphatic - side chain with minor amounts of aromatic compounds. vitrinite is mostly composed of aromatic compounds, in addition to large amount of short aliphatic - side chain compounds. whereas fusinite are dominant by aromatic structure. the study indicates that cutinite is one of the best oil source - rocks, with the higher hydrocarbon - generation potential ; vitrinite is one of better gas source - rocks, and has medium hydrocarbon - generating potential ; fusinite has little hydrocarbon - generating potential. in addition, the components of aliphatic structures of cutinite, vitrinite and fusinite decrease, the aromatics are enriched and condensation of aromatic structure increases with increasing the temperature, and along with the rise of temperatures, the intensity of aliphatic structure and heteroatomic compounds decrease obviously, however the aromatic structure changes a little

    應用顯微紅外光譜技術，對塔里木盆地侏羅紀煤中有代表性的3種組分角質體鏡質體絲質體在不同熱模擬溫度下的結構組成變化特徵進行了研究，結果表明：角質體結構組成中含有較豐富的長鏈脂族結構，而芳香結構和含氧官能團的含量則相對較少與此相反，絲質體結構組成中芳香烴占絕對優勢，而脂族結構含量則很少鏡質體結構組成介於角質體和絲質體之間，含有較多的短鏈脂族結構和芳香結構。
  3. The approach is that we first calibrate the filter radiometer with cryogenic radiometer and measurement equipment of relative spectral responsivity and then calculate the absolute spectral responsivity. because the drift in blackbody temperature directly influnces measurement accuracy, so we adopt a feedback system to stabilize blackbody temperature through controlling the current of blackbody that improves measurement accuracy greatly

    該方法首先要用低溫輻射計及相對光譜響應度測量裝置對濾光輻射計進行標定，經計算可得到濾光輻射計的絕對光譜響應度；由於黑體溫度的漂移直接影響到測量精度，我們採用反饋系統通過控制黑體的加熱電流，來穩定黑體溫度。
  4. According to the thermodynamics theories, reaction free energy and adiabatic temperature in zro2 - b _ 2o _ 3 - mg system have been theoretically calculated and analyzed. results of adiabatic temperature calculation showed that the adiabatic temperature of zro2 - b _ 2o _ 3 - mg system without diluent was 3093k, and it reduced with improvement of diluent content. when the diluent mgo content was 0 ~ 45 %, or the diluent zrbb2 content was 0 ~ 62 % the shs process would occer

    絕熱溫度計算表明:稀釋劑含量為零時， zro _ 2 - b _ 2o _ 3 - mg體系的絕熱溫度tad為3093k ，隨著稀釋劑含量的增加絕熱溫度呈現逐漸降低的趨勢，得出了稀釋劑mgo含量在0 45 % ，稀釋劑zrb2含量在0 62 %之間的所有組分的體系均有足夠的熱量來完成燃燒合成反應的結論。
  5. The experimental results show that in situ reaction between several oxides and al balances adiabatic temperature and controls the drastic reaction between cuo and al. at the same time, this kind of in situ reaction also accelerates the other replacement reactions and makes them react till to the end

    實驗結果表明採用多種氧化物原位反應法合理調配了不同反應的絕熱溫度，控制了cuo與al劇烈的鋁熱反應，同時促進了其它單質氧化物與al反應，使其能自我維持進行下去。
  6. The work mainly consists of four parts : the first part is to use oxidation and lpcvd technique to produce sio2 mask film and si3n4 insulation film in order to enhance the heating efficiency of micro chamber, and guarantee the carry out of the reaction. the second part is to use the combination of dry etching and wet etching to produce reaction micro chamber, it is the container which carry out the pcr reaction, and dna sample carry out amplification reaction here. the third part is to use the sputtering, photolithography to produce heaters and temperature sensors which heat the reaction micro chamber and provide the temperature condition for the pcr reaction

    首先，利用氧化工藝和lpcvd技術，生長sio _ 2掩膜層和si _ 3n _ 4絕緣層，以提高反應腔的熱效率，保證擴增反應的順利進行；其次，用濕法腐蝕和干法刻蝕相結合的方法加工微型腔體，使之作為dna樣品進行pcr擴增反應的容器；第三，用濺射、光刻等工藝在微型腔體底部製作微型加熱器和溫度傳感器，實現對反應腔體的加熱及其溫度的精確測量，提供pcr擴增反應所需的溫度條件。
分享友人
分享到 Line

分享到臉書