給隔板 的英文怎麼說

中文拼音 [gěibǎn]
給隔板 英文
longitudinal bulkhead
  • : 給Ⅰ動詞1 (送對方某物; 使對方得到) give; grant 2 (用在動詞后 表示交與 付出) pass; pay 3 (叫; ...
  • : partitionseparate
  • : Ⅰ名詞1 (片狀硬物體) board; plank; plate 2 (專指店鋪的門板) shutter 3 [音樂] (打拍子的樂器) ...
  • 隔板 : [機械工程] bulkhead; division plate; baffle plate; barricade; distance plate; dummy plate; inner ...
  1. Styrofoam boards were prepared for initiates as protective shields against the humid soil beneath their tents

    道場還特別準備了保麗同修們墊在帳篷下潮。
  2. " it was from caderousse that i intended demanding shelter, and, as we never entered by the door that opened onto the road, i resolved not to break through the rule, so climbing over the garden - hedge, i crept amongst the olive and wild fig trees, and fearing that caderousse might have some guest, i entered a kind of shed in which i had often passed the night, and which was only separated from the inn by a partition, in which holes had been made in order to enable us to watch an opportunity of announcing our presence

    「我當時就是想去要求卡德魯斯予庇護的。我們是從來不走前門的,所以我決定不破壞老規矩,而是翻過花園的籬笆,在橄欖樹和野生的無花果樹中間爬了進去。我怕卡德魯斯那兒有別人,就躲進了一間小屋裡,我以前常常在那間小屋裡過夜,它和客棧正屋只著一層墻,墻上有洞,我們可以從洞里向里偷看,等候機會宣布我們的到來。
  3. The effect of carding feed plate and taker - in on card sliver quality

    梳棉機與刺輥距對梳棉質量影響
  4. Do a little plastering

    刷灰泥
  5. In addition, the main stress at the interface of the bottom flange and inclined web, which located at the interface with the diaphragm, is the largest. so, it should be taken more attention to them in design

    另外,橫梁與斜腹及底交界處的底及斜腹區域,其主應力數值最大,設計中應予重視。
  6. Conventionally, this involves coating a silicon wafer with a thin layer of light - sensitive polymer, shining uv light onto it through a template, and then dissolving the affected areas to create a pattern

    和傳統方法一樣,先矽片薄薄地塗上一層對光線十分敏感的聚合物,再著一個模用紫外線照射矽片,然後溶解那些受到影響的區域,這樣就製成了一個圖案。
  7. Influence of gauge of carding feeding plate and linker - in on carding quality

    梳棉機與刺輥距對梳棉質量的影響
  8. According to the results of theory and experimental researches in this paper, the design provisions in the " technical code for concrete - filled square tubular structure " ( draft ) are discussed. the load - carrying capacity formulations for end section of beam to at the column - beam connections are proposed

    根據本文的試驗和理論研究結果,對( (矩形鋼管混凝土結構技術規程》 (送審稿)帶內的梁一柱栓焊連接節點設計內容進行了評析,提出了構造建議,並出了樑柱連接處梁截面的抗彎、剪計算公式。
分享友人