絮狀反應 的英文怎麼說
中文拼音 [xùzhuàngfǎnyīng]
絮狀反應
英文
flocculation reaction-
It showed that, the formation process of floc consisted of four stages ; bacteria multiplication ; floccule forming ; floccule polymerizing and the phase of the floe coming into being
結果顯示：反應器活性污泥凝絮體的形成過程經歷了4個階段，即細菌增殖階段、絮狀體形成階段、絮狀體聚合階段、凝絮體形成階段。When the dosage was 8 % aa, the effect was best. ( 2 ) the performance of pc was decided with the proportion of pea, aa, mma. the fluidity of copolymer would augment if the dosage of aa increase, but when dosage of aa was 75 %, it was hard to control the compose reaction, and dispersion of pc would depress ; when pea degree of polymerization augment the air - entraining of mma would increase ; it would produce floe and hard to control the compose reaction when the dosage of pea4 more than 15 %, pea23 more than 25 %
（ 2 ） pea 、 aa 、 mma之間的比例關系決定了共聚體的性能：隨著丙烯酸用量的增加，共聚體的流動度增大，達到75時合成控制難度加大，共聚體分散性下降；而mma的引氣增穩作用，其用量隨著pea的聚合度的增加而增加， pea4體系的用量超過15 ， pea23體系超過25則會產生絮狀物，反應控制難度加大，理想的用量分別為不超過10和15 。The output signal of pda is affected by the suspended particle concentration, particle size, and the type and dosage of coagulant as well. by analysing the fi curve, it is found that the characteristic parameters of fi curve closely relate to aggregates size and turbidity removal the aggregates size and turbidity removal achieve the maximum when the amplitude of fluctuation is the maximum. the mean diameter and fractal dimension increase with agitation time, and finally reach a steady - state
通過對混凝過程的在線監測和對pda輸出信號fi曲線的數學解析表明： fi曲線綜合反映了懸濁液中膠體顆粒濃度和顆粒粒徑，混凝劑種類和投量很大程度上影響了fi曲線形狀， fi曲線的特徵值與絮凝體平均粒徑和濁度去除率之間具有良好的相關關系，在振幅最大處，濁度去除率達到最高，絮體平均粒徑最大，該條件下對應的投藥量為最佳投藥量。
分享友人