縱軸向 的英文怎麼說

中文拼音 [zōngzhóuxiàng]
縱軸向 英文
y direction
  • 縱 : Ⅰ動詞1 （釋放; 放走） release; set free; let go 2 （放任; 不約束） indulge; give oneself up to; l...
  • 軸 : 軸Ⅰ名詞1. （圓柱形的零件） axle; shaft 2. （對稱部分的直線） axis 3. （圓柱形的纏繞器物） roller; spool Ⅱ量詞（用於纏在軸上的線以及裝裱帶軸子的字畫）
  1. In this system, the oil pipe be locally magnetized through the longitudial and circumferential direction, the oil pipe be circumvolved by the electromotor, the detector will has a linear movement on the surface of the pipe, so it can realize the combined testing of horizontal flaw ( cankerous pits and cankerous holes etc. ) and vertical flaw ( pole flaw and crack etc )

    該系統在油管局部實施軸向和周向磁化，油管由電機主軸帶動旋轉，檢測探頭緊貼油管直線運動，從而實現對腐蝕坑、腐蝕孔等橫向缺陷和桿狀損傷、劈縫等縱向缺陷的綜合檢測。
  2. The plating in ships is generally subjected to combined in - plane and lateral pressure loads. in - plane loads include biaxial compression / tension and in - plane bending and edge shear, which are mainly induced by overall hull girder bending and / or torsion of the vessel. lateral pressure loads are due to water pressure and cargo

    面內載荷分為軸向壓應力或拉應力、邊緣剪切應力以及面內軸向彎曲應力。實際的船舶結構中面內載荷通常由船體梁的總縱彎曲或者船體梁的扭轉引起。側向壓應力則由水壓力和貨物壓力引起。
  3. Sonographic examinations of the pancreas were performed by sagittal scanning at the epigastrium ; the long axis and short axis of the oval cross - sections of both the pancreatic head and body were measured

    檢查測量的方式是在上腹部作縱向掃描，可以分別得到胰臟頭部與體部之圓形縱切面造影，進而分別測量胰臟頭部與體的長軸與短軸，一共為4個胰臟因數。
  4. Bearing sleeves for milling machine arbors, for milling cutters with longitudinal keyway

    第1部分:銑床心軸用和帶縱向鍵槽的銑刀用軸承座套
  5. For magnetic thin films, the magnetic axis is in the longitudinal direction, where kerr effect is obvious

    對于很多磁性薄膜，易磁軸方向為縱向，通常縱向克爾效應較明顯。
  6. The vertical axis represents the cache aggregation direction

    縱軸表示緩存聚合方向。
  7. Further, the axia ! uniform periodical property can be replaced by an anisotropic dielectric with uniform transverse and uniform axial property

    進一步，把軸向周期分佈的均勻介質盤又等效為徑向和縱向均勻的各向異性介質。
  8. 3. a space bond slip relation of reinforcements in either end of a member is proposed, based on one - dimensional bond slip model of reinforcements proposed by teng zhiniirmg from tsinghua university, the first - time loaded ascending stage ? curve of which model is modified as the line which parameters are not changed so as to simply the computation. the bond, slip is regarded as the boundary nonlinearity of a member

    3 、採用清華大學滕智明建議的一維鋼筋粘結滑移恢復力模型，但從簡化計算的角度出發，將首次加載的上升段曲線改為直線，並假定構件端部的諸多縱向鋼筋的滑移服從平截面假定，考慮由節點錨固區粘結滑移引起的構件端截面軸向和兩轉角附加變形。
  9. The influence of such parameters as axial load index, aspect ratio and percentages of lateral reinforcement, on seismic performance of reinforced concrete frame column in hong kong and analyses the distribution relationships of flexural deformation, shear deformation and slippage of longitudinal reinforcement in joint zone

    根據試驗結果，討論了軸壓比、配箍率、剪跨比等參數對其抗震性能的影響，分析了水平荷載作用時塑性鉸區的彎曲變形、剪切變形和縱向鋼筋粘結滑移變形所產生的位移在框架柱總水平側移中所佔的比例及其變化規律。
  10. Pf series air fans are new low - speed high - flow - rate tube - axial fan. wich represents advantages of high flow, light weight, low noise and lower power consumption. they are key equipment of tunnet ventilation in houses of poultry & livestock poultry

    Pf系列排風扇是新型的低速大流量軸流風機，具有流量大、重量輕、噪音低、耗電省等優點，是畜、禽舍縱向通風的關鍵設備。
  11. Mouting and connecting dimensions ; traction motors for two - axle longitudinal drive with two hollow axle shafts

    安裝和連接尺寸.帶雙空心軸的雙軸縱向傳動牽引電機
  12. Then the experiment platform of the hypoid gear system was set up, and the lateral, longitudinal and axial vibration response of the bearing and the vibration acceleration response on the surface of the gearbox were measured

    搭建了準雙曲面齒輪傳動系統的實驗平臺，測量了準雙曲面齒輪箱軸承座的橫向、縱向和軸向振動響應和箱體表面振動加速度響應。
  13. The characteristics of longitudinal and lateral frame columns are different from general frame columns, due to the high depth - to - width ratio of cross - sections and withstanding large vertical loads. the axial compressive ratio is a very important factor in columns design

    縱、橫向框架柱具有與一般框架柱不同的特點，如柱截面高寬比較大，且承受很大的豎向荷載，其軸壓比設計問題是柱設計的一個非常重要的因素。
  14. It was shown that the maximum displacement occurred on the tunnel axis when one tunnel was excavated, while the maximum value happened near the shallow tunnel and between the area of two tunnels when two adjacent tunnels were excavated at the same time

    分析結果表明：單條隧道開挖引起的地表最大沉降值出現在隧道軸線的正上方，而兩左右或上下相鄰隧道開挖的地表及土層內部的最大沉降值則出現在兩隧道的縱軸線之間，且偏向上方埋深較淺的隧道。
  15. Establishing primary haloes ' s axial direction, vertical direction and horizontal direction, concluding the normally regulate of combined characteristic and zonal characteristic in shiyingtan gold deposit. finally vertical direction and horizontal direction, concluding the normally regulate of combined characteristic and zonal characteristic in shiyingtan gold deposit

    而對該礦床隱伏礦體l _ 4不同標高的巖石地球化學采樣分析，確定了石英灘金礦的原生暈軸向分帶、橫向分帶、縱向分帶以及其原生暈組合特徵的一般性規律。
  16. Cq6132w infinitely variable speeds, power - driven feed in longitudinal and cross directions, safety interlock, a overload safety device

    Cq6132w主軸無級變速，縱橫向機動走刀，安全互鎖，超負荷保險。
  17. Cq6132b variable speed can be obtained from spline gears, power - driver feed in longitudinal and cross directions, safe interlock, a overload safety device

    Cq6132b主軸皮帶塔輪變速，縱橫向機動走刀，安全互鎖，超負荷保險。
  18. The longitudinal stresses in the tunnel structure calculated by using the model of tamura & okamoto are obviously greater than the stresses in transverse direction obtained by using two dimensional finite element analysis. it is proposed that the axial and bending stresses should not be ignored for the underground structural design

    計算結果表明，由彈簧質量模型算得的地下結構在地震作用下縱向振動和橫向振動產生的縱向和彎曲正應力及剪應力明顯高於由二維平面有限元算得的橫向平面內產生的正應力和剪應力，由此可見軸向應力和彎曲應力是地下結構抗震設計中不容忽視的因素。
  19. According to different transverse difference in temperature and lengthways difference in temperature, the paper gave the method of computing temperature effect including : 1 ) the stress ot1 caused by nonlinear difference in temperature. 2 ) the constrain stress o t2 in undetermined structures by equivalent difference in temperature. 3 ) the constrain stress ot3 caused in undetermined structures by even difference in temperature tm

    針對具有不同性質的橫向溫差和縱向溫差，本文分別提出了預應力結構的溫度效應的計算方法，包括： 1 ）非線性溫差引起的自約束應力_ （ t1 ） ； 2 ）等效線性溫差引起的超靜定結構的約束太原理工大學碩士學位論文應力民3 ）均勻溫差tw引起超靜定結構中的約束應力4 4 ）均勻溫差tm引起梁的軸向變形受到柱的側向約束，與預應力筋的溫度變形之間的差異引起的預應力的變化。
  20. ( 2 ) axial pre - swirling inflow on high radius holds back the further transmission of heat effectively, to inner part of cavity

    （ 2 ）軸向高位進氣有效地阻止了熱流向盤腔內端縱深傳遞，在進氣加有預旋時效果更好。
分享友人
分享到 Line

分享到臉書