翅片式換熱器 的英文怎麼說

中文拼音 [chìpiānshìhuànrèqì]
翅片式換熱器 英文
finned heat exchanger
  • 翅 : 名詞1. （翅膀） wing 2. （魚翅） shark's fins3. [動物學] （翼; 翅） ala4. [植物學] （翼瓣） ala
  • 片 : 片構詞成分。
  • 式 : 名詞1 （樣式） type; style 2 （格式） pattern; form 3 （儀式; 典禮） ceremony; ritual 4 （自然科...
  • 換 : 動詞1. （給人東西同時從他那裡取得別的東西） exchange; barter; trade 2. （變換; 更換） change 3. （兌換） exchange; cash
  • 器 : 名詞1. （器具） implement; utensil; ware 2. （器官） organ 3. （度量; 才能） capacity; talent 4. （姓氏） a surname
  1. Modal analysis of the fin heat exchanger using fem

    翅片式換熱器模態的有限元分析
  2. The operation efficiency for the improved device shows that the service life is 2 times of unimproved exchanger with a high operating stability

    改造后的運行效果表明，縱向翅片管式換熱器的使用壽命是改造前的2倍，且運行平穩。
  3. Take the technical reform on longitudinal finned tubular oil / heating agent heat exchanger operated in ( superscript # ) 2 platform of chengdao oilfield center as an example, this paper analyzes 3 failure modes of this kind of heater and presents relative improvement measures

    摘要以埕島油田中心二號平臺縱向翅片管式原油熱媒換熱器技術改造為例，分析了縱向翅向管式換熱器常見的3種失效形式，並指出了其相應的改進措施。
  4. Numerical model of plate - fin - evaporator heat transfer performance

    翅片式蒸發器換熱性能的數學模型
  5. Under the guidance of the above method, the type of hampson heat exchanger for mixed - refrigerant j - t coolers is designed. 3

    闡述了混合工質熱交換器的設計方法，對翅片管繞管式換熱器（ hampson型）進行初步設計； 3
  6. A forced convection finned tube exchanger model with constant blast volume was constructed and its reliability was confirmed by the performance test

    摘要建立了恆流條件下的強制對流翅片管式換熱器的結霜模型，並用實驗結果驗證了模型的可靠性。
  7. The plate - tube evaporator, the single back - fin evaporator and the box condenser. after analyzing the physical model and setting up the mathematical model according to the two - phase flow of adiabatic capillary tubes, it also numerically simulates and analyzes the different effects of main parameters on the capillary tube length. based on the heat transfer analysis and counting of thermal insulation layer, the cad system accomplishes the parametric design and drawings of the refrigerator body

    該系統完成了對典型製冷裝置的換熱器部件，如板管式蒸發器、單脊翅片管式蒸發器、箱壁式冷凝器的參數化設計和繪圖；分析了絕熱型毛細管兩相流的物理模型，並建立數學模型，對絕熱型毛細管各主要參數對其長度的影響進行了數值模擬和計算分析；基於對電冰箱箱體絕熱層厚度的傳熱分析和計算，完成了整個箱體的參數化設計和繪圖工作。
  8. The machine designed for expanding tubes inserted into the fin parcel, in order to get a compact coil and thus obtain thermal exchange

    產品說明:該機是管片式熱交換器的散熱片與換熱管的漲接設備，經漲管后，使管、翅片緊密漲接為一體以達到較高的熱交換率。
  9. Numerical simulation of distributor configuration of plate - fin heat exchanger

    板翅式換熱器導流片結構的數值模擬
  10. Numerical study on heat transfer characteristics of offset - strip - fin heat exchanger

    錯列翅片板翅式換熱器傳熱性能數值研究
  11. Application of genetic algorithm to optimal design of a fin tube heat exchanger

    遺傳演算法在管箱式翅片管換熱器優化設計中的應用
  12. Numerical analysis of the fin bypass of multi - stream plate - fin heat exchanger

    多股流板翅式換熱器翅片旁通的數值分析
  13. Flow distribution performance of different distributor ' s c onfiguration in plate - fin heat exchanger

    板翅式換熱器不同結構導流片導流性能的研究
  14. Cfd simulation of fluid flow and heat transfer in channels of plate - fin heat exchangers

    板翅式換熱器翅片通道中流體流動與傳熱的計算流體力學模擬
  15. In order to study the operation characteristics of hpacdhws, distributed parameter simulation models of the fin heat exchanger and the plate heat exchanger are built up. the compressor model is founded in map - based method, and the thermodynamics expansion value model is built up in force balance method. the dynamic system model is the efficient connection of all component models by laws of equalization of mass, momentum and energy

    為了研究hpacdhws的運行特性，本文利用分佈參數法分別建立了翅片管換熱器和板式換熱器的動態數學模型，採用圖形法和力平衡法分別建立了壓縮機和熱力膨脹閥的集總參數計算數學模型，並基於質量、動量和能量守恆定律等約束條件，建立了hpacdhws的動態模擬模型。
分享友人
分享到 Line

分享到臉書