耦合諧振器 的英文怎麼說

中文拼音 [ǒugěxiézhènqì]
耦合諧振器 英文
coupled resonators
  • 耦 : Ⅰ動詞[書面語] （兩人並耕） plough side by sideⅡ名詞1 （古農具名） plough2 [書面語] （兩人一組） a...
  • 合 : 合量詞（容量單位） ge, a unit of dry measure for grain （=1 decilitre）
  • 諧 : Ⅰ形容詞1 （和諧） in harmony; in accord; in tune 2 （詼諧） humorous Ⅱ動詞（商量好; 辦妥） come t...
  • 振 : 動詞1. （搖動; 揮動） shake; flap; wield 2. （奮起） brace up; rise with force and spirit
  • 器 : 名詞1. （器具） implement; utensil; ware 2. （器官） organ 3. （度量; 才能） capacity; talent 4. （姓氏） a surname
  • 耦合 : [物理學] coupling; interconnection; catena; linkage; linking
  1. Therefore analysis of resonator was predigested. graphs of the external q and coupling coefficient between resonators were created

    分析並創建了siw諧振器的外部q值、諧振器間的耦合系數隨耦合結構尺寸變化的曲線圖。
  2. The increasing of single channel capacities and evolution of optical networks topology, from simple point - to - point to intelligent optical networks, call for strict demands to optical filters. in this paper, the crucial technologies of optical filters such as interleaver, optical digital filter, fused biconical taper all - wave coupler as well as polarization - pump combiner have been studied experimentally and theoretically, which include : 1. a new process, cascaded fbt ( fused biconical taper ) with precise control as well as strict interference arm length difference, is proposed for the first time to our knowledge

    單通道速率不斷提高以及網路拓撲由單一的點對點傳輸向可上下載的環網和可動態選擇波長路由的智能型格形光網路演進，對光濾波器的常規性能指標、時域特性和動態可調諧特性提出了更加苛刻的要求，鑒於此，本論文全面研究了全光纖熔錐型奇偶交錯濾波技術、數字光濾波技術、基於g - t全通濾波器的奇偶交錯濾波技術以及熔錐型全波耦合器和偏振泵浦合波器。
  3. Characteristics analysis of electrical couplings between cylindrical combline resonators

    圓柱形波導梳狀線諧振器間電耦合特性分析
  4. The equivalent circuit of the coupling between the dielectric resonator and microstrip is proved then

    接下來詳細推證了介質諧振器與微帶線間耦合的等效電路。
  5. In the second chapter, equivalent circuit of the eddy current sensor is firstly analyzed. based on that, the carrier signal generating circuit that is realized by the lc periodic circuit is introduced, thus, the carrier signal of standard frequency is obtained through the trimming capacity. subsequently, the disc type rotational armature generator and the rotational coupling transformer are separately leaded in to realize the power supplies of the carrier signal generating circuit and output of the measuring signal

    在傳感器設計一章中，首先對渦流傳感器進行等效電路分析，在此基礎上分析了由電感、電容諧振電路構成的載波信號發生電路，並通過微調電容獲得了標準頻率的載波信號；接下來提出了採用盤式旋轉電樞發電機解決載波信號發生電路電源供給問題的方案，同時通過旋轉耦合變壓器的引入，使得測量信號輸出問題很好地解決；本章最後給出的一組實驗曲線充分說明了這一方案的可實現性。
  6. First, the capacitor inserted allows a low frequency " extension " due to the resonance between the transformers inductance and the capacitance value

    第一，耦合電容和變壓器初級電感之間的諧振可以容許更好的低頻延展。
  7. The non - linearity of measurement microphone in principle and structure at high pressure level analysed, and deeply introduces the high pressure level calibration system, the systems principle of operation, calibration method, measurement uncertainty and experimental results and deeply introduced

    摘要從原理和結構上分析測試傳聲器在高聲壓級下的非線性特性，著重介紹以高壓諧振耦合腔為核心的高聲壓級校準裝置的原理、校準方法及不確定度分析，並給出一些試驗結果。
  8. Resonant cavity, coupler and splitter are the most important passive microwave devices

    諧振腔、耦合器、功分器都是重要的無源微波器件。
  9. The main research is as follows : analyze and research the boundary constraint and the structure characteristic and segment the frame making use of the shell element, the pipe element etc. on the base of it the practical finite element model has been established ; analyze the mode of the frame by dint of the finite element model. and get the inherent frequency and the vibration mode of the frame. tentatively estimate the dynamic characteristic of the frame and analyze the inherent frequency that may be lead to the resonance

    論文的主要研究工作如下：分析研究車架的邊界條件和結構特性，並用殼、管等單元對該車架進行離散，建立一種切實有效的車架有限元模型；對該車架的有限元模型進行模態分析，求得其的固有頻率和振型，並對車架的動態特性做出初步評估，分析可能引起車架振動的固有頻率；在模態分析基礎上，研究發動機輸出的簡諧力引起的車架位移響應（即諧響應分析） ，以考察摩托車車架各部位的振動情況並與模態分析對比，分析是否與該車架的固有頻率相耦合而導致共振；在深入研究車架的模態分析及諧響應分析、清晰地認識了摩托車車架動態特性的基礎上，分析並提出了採用橡膠減震器對車架進行隔振的減震方法。
  10. To make the design of the drvco more accurately, the coupling between the dielectric resonator and microstrip was studied and its equivalent circuit was proved. based on it, some different ideas from some reference book were presented. farther, the expression of the coupling ratio was derived

    為了使drvco的設計更加準確，在設計前先對介質諧振器與微帶線之間的耦合的等效電路進行了研究，提出了幾點與文獻資料不同的看法，並得出了耦合比k2的表達式。
  11. A fem software as an important tool, work has been done as follows : the method using fem to design anomalous structure of transducers was adopted ; the vibration modes of the elastic pipe, ultrasonic transducers and system has been analyzed in piezoelectric coupled field. resonant frequencies of the transducers have been matched quite well with resonant frequencies of pipe, which can make it easy and accurate to design a transducer. the values of equivalent dynamic capacitors and dynamic inductances of ahead nine orders have been gotten derived by fem method, and fem equivalent circuit of the transducers has been built

    以ansys有限元軟體為主要分析工具完成了設計工作;在經典換能器設計理論和前人經驗的基礎上，對不規則形狀的換能器採用了有限元的方法設計;在耦合場中分析了換能器、導管及整體裝置的振動情況，使換能器的諧振頻率與導管的諧振頻率達到了較好的匹配，使設計變得更加容易和準確;利用有限元方法建立了振子的等效電路模型，求出了其前6階模態的等效動態電容電感值，為阻抗匹配和驅動電路的設計提供了依據。
  12. Due to excellent stop band and slow wave characteristics, they are applied to filters, resonators, directional couplers, diplexers and antennas

    由於其優良的帶阻、慢波等特性，它們被廣泛地應用於濾波器、諧振器、定向耦合器、雙工器和天線中。
  13. The result shows that, the size of the coupling port has strong influence on the external quality factor of the output cavity, while the size of the coupling line and the capacitive metal rods mainly affect the tuning frequency of cutoff waveguide filter

    另外，由於耦合接頭相當于在截止段中引人了一個附加電感，這使濾波器諧振電路的品質因數變大，諧振峰變窄。
  14. Since the concept of superlattice was proposed, vertical transport in superlattice has been investigated widely. the electric field domains and current self - oscillations which result from sequential resonant tunneling between different subbands of the superlattice are very significant phenomena. such kind of oscillation can be uesd to make tunable microwave oscillaors. in this thesis, low temperature transport problem, especially the formation of field domain and the condition of current self - oscillations in doped gaas / alas superlattice with weak coupling are investigated thoroughly and also by combining the macroscopic model with the microscopic one., the voltage - current characteristic and the current oscillation are simulated. the calculated result is nearly consistent with the experimental data

    由超晶格中子能級之間的順序多阱共振隧穿引起的電場疇及電流自維持振蕩現象是其中的一個非常有意義的分支，該現象可用來製作電壓調諧微波振蕩器。本論文對弱耦合摻雜gaaa alas超晶格中的縱向輸運特別是針對低溫下的場疇的形成和固定偏壓下電流自維持振蕩產生的條件進行了深入的探討，並結合宏觀模型和微觀模型對超晶格在時變電壓作用下的電壓-電流特性以及固定偏壓作用下的電流特性進行了模擬計算。
  15. The factors that influenced the output of the laser were analyzed theoretically. the output power of the laser was observed to be related with the length of eof, the coupled - ration of the output coupler and the loss of splicing

    並在摻鉺光纖激光器理論分析基礎上，討論了影響激光器輸出的各種因素：腔長、輸出耦合比、諧振腔損耗。且作了相應的實驗，與理論結果相一致。
  16. The couplers of accelerator structures are important components of electron knear. the efficient delivery of power from rf sources to accelerator structures depends crucially on the coupler cavity. the input coupler cavity is to be well matched, that is to say, it must have proper coupiing. and it must be tuned to the synchronous frequency. in this way, we can obtain the maximum power. in the past, the decision of the coupler cavity dimensions is very difficult

    加速結構的輸入耦合腔是電子直線加速器的重要組成部分。功率從功率源輸送到加速管中，就依賴于輸入耦合腔。輸入耦合腔在整個結構中必須有良好的匹配即有恰當的耦合度，還必須工作在諧振頻率。
  17. Coupled optical resonator

    耦合光諧振器
分享友人
分享到 Line

分享到臉書