耦合諧振電路 的英文怎麼說

中文拼音 [ǒugěxiézhèndiànlù]
耦合諧振電路 英文
coupled resonant circuit
  • 耦 : Ⅰ動詞[書面語] （兩人並耕） plough side by sideⅡ名詞1 （古農具名） plough2 [書面語] （兩人一組） a...
  • 合 : 合量詞（容量單位） ge, a unit of dry measure for grain （=1 decilitre）
  • 諧 : Ⅰ形容詞1 （和諧） in harmony; in accord; in tune 2 （詼諧） humorous Ⅱ動詞（商量好; 辦妥） come t...
  • 振 : 動詞1. （搖動; 揮動） shake; flap; wield 2. （奮起） brace up; rise with force and spirit
  • 電 : Ⅰ名詞1 （有電荷存在和電荷變化的現象） electricity 2 （電報） telegram; cable Ⅱ動詞1 （觸電） give...
  • 路 : 1 （道路） road; way; path 2 （路程） journey; distance 3 （途徑; 門路） way; means 4 （條理） se...
  • 耦合 : [物理學] coupling; interconnection; catena; linkage; linking
  • 電路 : [訊] circuit （ckt）; electric circuit; electrocircuit電路板 circuit board; 電路保持 guard of a c...
  1. If the numerical value line resonance frequency plus some shaft connatural frequency of generator is equal to operation frequency, it brings about coupling resonance between generator and system, which maybe results in shaft rupture of synchronous generators

    當線路電氣諧振頻率與同步電機的軸系某一固有振蕩頻率近似互補于電網工頻時，將導致機電系統的耦合振蕩，嚴重的會造成同步發電機大軸的扭斷。
  2. Accurate simulation of switch circuit is needed in pin switch design, while limited by assembling techniques, serial resonance and channel inter - coupling exist in the common joint that bring a lot of difficulties for simulation. 2 - dementions simulation software can not establish accurate circuit mode for pin diode switch which gives simulation error, and it costs much more time with 3 - dementation simulation software, which is not applicable in practice for pin switch design

    Pin開關的設計中需要對開關電路進行準確模擬，然而高頻、寬帶、多擲pin開關受裝配工藝的限制，開關公共結點附近存在著串聯諧振和相互耦合，給pin開關的準確模擬帶來了困難:二維模擬軟體很難對電路進行準確建模，模擬誤差較大;三維模擬軟體耗時過長，難以在實際設計中應用。
  3. The equivalent circuit of the coupling between the dielectric resonator and microstrip is proved then

    接下來詳細推證了介質諧振器與微帶線間耦合的等效電路。
  4. In the second chapter, equivalent circuit of the eddy current sensor is firstly analyzed. based on that, the carrier signal generating circuit that is realized by the lc periodic circuit is introduced, thus, the carrier signal of standard frequency is obtained through the trimming capacity. subsequently, the disc type rotational armature generator and the rotational coupling transformer are separately leaded in to realize the power supplies of the carrier signal generating circuit and output of the measuring signal

    在傳感器設計一章中，首先對渦流傳感器進行等效電路分析，在此基礎上分析了由電感、電容諧振電路構成的載波信號發生電路，並通過微調電容獲得了標準頻率的載波信號；接下來提出了採用盤式旋轉電樞發電機解決載波信號發生電路電源供給問題的方案，同時通過旋轉耦合變壓器的引入，使得測量信號輸出問題很好地解決；本章最後給出的一組實驗曲線充分說明了這一方案的可實現性。
  5. The first, the effect of the sizes of coupling slots in a coupling double gap cavity on the cavity characteristics is studied through simulation computation of three dimensions electromagnetic field and analysis of equivalent lumped element circuit. it is concluded by the research that, in lower frequency band, bigger coupling slots in a coupling double gap cavity are beneficial to raising the characteristic impedance and lowering the frequency of it mode

    第一，採用三維電磁場模擬計算方法和集中元件等效電路法研究了耦合雙間隙腔中耦合槽尺寸對諧振腔性能如何影響等問題，得出了重要結論：在較低頻率波段，耦合雙間隙腔中開大耦合槽有利於提高模的特性阻抗，降低模頻率。
  6. To make the design of the drvco more accurately, the coupling between the dielectric resonator and microstrip was studied and its equivalent circuit was proved. based on it, some different ideas from some reference book were presented. farther, the expression of the coupling ratio was derived

    為了使drvco的設計更加準確，在設計前先對介質諧振器與微帶線之間的耦合的等效電路進行了研究，提出了幾點與文獻資料不同的看法，並得出了耦合比k2的表達式。
  7. A fem software as an important tool, work has been done as follows : the method using fem to design anomalous structure of transducers was adopted ; the vibration modes of the elastic pipe, ultrasonic transducers and system has been analyzed in piezoelectric coupled field. resonant frequencies of the transducers have been matched quite well with resonant frequencies of pipe, which can make it easy and accurate to design a transducer. the values of equivalent dynamic capacitors and dynamic inductances of ahead nine orders have been gotten derived by fem method, and fem equivalent circuit of the transducers has been built

    以ansys有限元軟體為主要分析工具完成了設計工作;在經典換能器設計理論和前人經驗的基礎上，對不規則形狀的換能器採用了有限元的方法設計;在耦合場中分析了換能器、導管及整體裝置的振動情況，使換能器的諧振頻率與導管的諧振頻率達到了較好的匹配，使設計變得更加容易和準確;利用有限元方法建立了振子的等效電路模型，求出了其前6階模態的等效動態電容電感值，為阻抗匹配和驅動電路的設計提供了依據。
  8. The result shows that, the size of the coupling port has strong influence on the external quality factor of the output cavity, while the size of the coupling line and the capacitive metal rods mainly affect the tuning frequency of cutoff waveguide filter

    另外，由於耦合接頭相當于在截止段中引人了一個附加電感，這使濾波器諧振電路的品質因數變大，諧振峰變窄。
  9. Based on the others " research, a sapphire resonator working at 12ghz was improved and fabricated. the coupling of resonant circuit and the match of the outside circuit are analyzed. and the automatic test system is also built

    本文在前人的研究基礎上，改進製作了一個工作在17ghz附近的藍寶石介質諧振腔測試座，分析了諧振迴路的耦合及外電路的匹配問題，並構建了自動測試系統。
分享友人
分享到 Line

分享到臉書